Warm Season Turfgrass Equine Sports Surfaces: An Experimental Comparison of the Independence of Simple Measurements Used for Surface Characterization.

Turfgrass in equine sports has clear advantages over other types of reinforcement but adds complexity to the management. This study investigates factors that influence the turfgrass' surface performance and how the use of a drainage package and a geotextile reinforcement affect quantitative measurements of turfgrass. The measurements are made using affordable, lightweight testing tools that are readily available or easily constructed. Eight boxes with turfgrass over a mix of the arena with peat at a consistent depth were tested for volumetric moisture content (VMC %) with time-domain reflectometry (TDR), the rotational peak shear device (RPS), the impact test device (ITD), soil cone penetrometer (SCP), and the Going Stick (GS). Results obtained using TDR, RPS, ITD, SCP, and GS indicate that the presence of the geotextile and drainage package was mainly detected by VMC (%), SCP detected geotextile addition, and GS detected the interaction of geotextile × drainage package. Linear regression showed SCP and GS are related to geotextile and was positively correlated between them and negatively with VMC (%). The testing showed some limitations of these devices, mainly related to moisture content and sod composition, but the potential exists to utilize these devices for quality control as well as for the monitoring of maintenance of the surfaces when controlling the range of both VMC (%) and sod constitution.

A Comparison of Devices for Race Day Characterization of North American Turfgrass Thoroughbred Racing Surfaces.

Both pre-race meet and daily turf surface condition measurements are required by regulations adopted as part of the Horseracing Integrity and Safety Act (HISA). The Orono Biomechanical Surface Tester (OBST) is the primary device used for characterizing a racing surface and is used for the pre-meet inspections. Tools that are better suited for the daily testing of turf surfaces are also needed to meet the new federal regulations. The purpose of this study was to compare five simple tools commonly used in turf applications to the OBST. Data were collected with each of the six devices at plots chosen to approximate the current and potential compositions of North American turf racetracks. Correlations and linear regression models were then established between the simple tool measurements and the parameters measured by the OBST. The moisture probe was found to be the primary device for race day characterization due to its strong correlation to OBST measurements. The Longchamp Penetrometer is also prioritized for daily measurements due to its established correlation to horse performance and injuries. The Clegg Impact Hammer provides further improvement of the linear regression model. The Turf Shear Tester and GoingStick® were not found to correlate well to the biomechanically based device.

An Experimental Comparison of Simple Measurements Used for the Characterization of Sand Equestrian Surfaces.

Quantitative measurements of performance parameters have the potential to increase consistency and enhance performance of the surfaces as well as to contribute to the safety of horses and riders. This study investigates how factors known to influence the performance of the surface, incorporation of a drainage package, control of the moisture control, and introduction of a geotextile reinforcement, affect quantitative measurements of arena materials. The measurements are made by using affordable lightweight testing tools which are readily available or easily constructed. Sixteen boxes with arena materials at a consistent depth were tested with the Going Stick (GS), both penetration resistance and shear, the impact test device (ITD), and the rotational peak shear device (RPS). Volumetric moisture content (VMC %) was also tested with time-domain reflectometry (TDR). Results obtained using GS, RPS, ITD, and TDR indicate that the presence of the drainage package, moisture content, and geotextile addition were detected. Alterations due to combinations of treatments could also be detected by GS, ITD, and TDR. While the testing showed some limitations of these devices, the potential exists to utilize them for quality control of new installations as well as for the monitoring of maintenance of the surfaces.