Ozone membrane contactor for tertiary treatment of urban wastewater: Chemical, microbial and toxicological assessment.

A membrane ozone contactor, operated under continuous mode, was applied to promote the tertiary treatment of urban wastewater (UWW), targeting the removal of contaminants of emerging concern (CECs), bacterial disinfection, and toxicity reduction. This system relies on the homogeneous radial distribution of ozone (O3) in the reaction zone by "titration" through a microfiltration borosilicate tubular membrane, while the UWW swirls around the membrane and drags the O3 microbubbles generated in the membrane shell-side. The membrane is coated with titanium dioxide (TiO2-P25) and radiation can be externally supplied via four UV lamps. The ozonation tests were carried out with secondary-treated UWW collected in different seasons (winter and summer) and spiked with a mix of 19 CECs (10 µg L-1 each). For an O3 dose of 18 g m-3, the best performance was obtained by increasing the O3 concentration (maximum [O3]G,inlet of 200 g Nm-3) and decreasing the gas flow rate (minimum QG of 0.15 Ndm3 min-1), providing the highest ozone transfer yield (88 %) and, thus higher specific ozone dose (g O3 per g dissolved organic carbon). Under these conditions, removals >80 % or concentrations below the limit of quantification were obtained for up to 13 of the 19 CECs and reductions up to 5 log units for total heterotrophs and below the limit of detection for enterobacteria and enterococci. Tests including a UVC dose of 0.10 kJ L-1 enhanced disinfection ability but had no impact on CECs oxidation. After ozonation, the abundance of antibiotic resistant bacteria was reduced but not eliminated, and microbial regrowth after 3-day storage was observed. No toxic effect was detected on zebrafish embryos using a dilution factor of 4 for the ozonized UWW and when granular activated carbon adsorption was subsequently applied the dilution factor decreased to 2.

Ultrafiltration ceramic membrane as oxidant-catalyst/water contactor to promote sulfate radical AOPs: a case study on 17ß-estradiol and 17α-ethinylestradiol removal.

This work highlights the performance of an ultrafiltration ceramic membrane as photocatalyst support and oxidant-catalyst/water contactor to promote sulfate radical advanced oxidation processes (SR-AOPs). Peroxydisulfate (PDS) activation mechanisms include photolysis (UVC irradiation) and chemical electron transfer (TiO2-P25 photocatalysis). The photoreactor is composed of an outer quartz tube (the "window"-radiation entrance to the reactor) and an inner tubular ceramic ultrafiltration membrane, where the catalyst particles (TiO2-P25) are immobilized on the membrane shell-side. PDS stock solution is fed by the lumen side of the membrane, delivering the oxidant to the catalyst particles and to the annular reaction zone (ARZ), being the catalyst and PDS activated by UV light. The design facilitates controlled radial slip of PDS into the catalyst surface and to concurrent water to be treated, flowing with a helix trajectory in the ARZ. Under continuous mode operation, with an UV fluence of 45 mJ cm-2 (residence time of 4.6 s), the UVC/PDS/TiO2 system showed the best removal efficiency for two specific endocrine disrupting chemicals, 17ß-estradiol (E2) and 17α-ethinylestradiol (EE2), spiked (100 µg L-1 each) in demineralized water and urban wastewater after secondary treatment.