RESUMO
PLA biocomposites were prepared using three corn cob fractions and a wood fiber as reference. The composites were characterized by tensile testing, scanning electron microscopy (SEM) and polarization optical microscopy (POM). Micromechanical deformation processes were followed by acoustic emission measurements. The different strength of the components was proved by direct measurements. Two consecutive micromechanical deformation processes were detected in composites containing the heavy fraction of corncob, which were assigned to the fracture of soft and hard particles, respectively. The fracture of soft particles does not result in the failure of the composites that is initiated either by the fracture of hard particles or by matrix cracking. Very large particles debond easily from the matrix resulting in catastrophic failure at very low stresses. At sufficiently large shear stresses large particles break easily during compounding, thus reinforcement depending on interfacial adhesion was practically the same in all composites irrespectively of initial fiber characteristics.
Assuntos
Ácido Láctico/química , Lignina/química , Polímeros/química , Poliésteres , Estresse Mecânico , Relação Estrutura-Atividade , Resistência à Tração , Madeira/químicaRESUMO
In this work ternary composites based on an epoxy thermoset modified with a thermoplastic polymer and reinforced with glass fibers were prepared. The aim of this study is to analyze the influence of the molecular weight of the thermoplastic polymer on the final morphologies. To obtain tailor made interphases four poly(methylmethacrylate), PMMA, which differ in their molecular weight (34,000, 65,000, 76,000 and 360,000 g/mol) were chosen to modify the epoxy resin. The amount of PMMA in the composites was fixed to 5 wt.%. Neat polymer matrices (epoxy-PMMA without fibers) were also prepared for comparison. To study all systems dynamic mechanical analysis (DMA), atomic force microscopy (AFM) and scanning electron microscopy (SEM) were used. Although all the systems showed the typical phase separation in the epoxy/PMMA blend, DMA experiments revealed a new phase with more restricted mobility when the glass fibers are present. The amount of this phase increases as molecular weight of PMMA does. The morphologies as well as the fracture surface in the immediate surroundings of the fibers were found to be different from those observed further away from the surface of the fiber, suggesting therefore that, in this case, different fracture mechanism operates. These observations allow us to conclude that an interphase with specific properties is formed. This interphase is based on a polymer or a polymer blend (epoxy-PMMA) enriched in the component with lower mobility.