Atmospheric oxidation and carbon contamination of silver and its effect on surface-enhanced Raman spectroscopy (SERS).

Surface-enhanced Raman spectroscopy (SERS) is considered a highly promising technology for different analytical purposes. The applications of SERS are still quite limited due its relatively poor quantitative repeatability and the fact that SERS is very sensitive to oxidation, which is a challenge especially with silver based SERS substrates. Here, the link between these phenomena is investigated by exposing silver SERS substrates to ambient laboratory air. We show that SERS intensity decreases exponentially after the exposure, which consequently leads to an increasing standard deviation (σ) in intensity. Within a five-hour measurement window, the SERS intensity already drops by 60%, while σ triples from 7% to 21%. The SERS results are supplemented by elemental analysis, which shows that oxidation and atmospheric carbon contamination coincide with the rapid SERS intensity decrease. The results emphasize how sensitive SERS is towards atmospheric contamination and how it can also reduce the measurement repeatability - even if the substrates are exposed to air just for a very short period of time.

Disposable photonic integrated circuits for evanescent wave sensors by ultra-high volume roll-to-roll method.

Flexible photonic integrated circuit technology is an emerging field expanding the usage possibilities of photonics, particularly in sensor applications, by enabling the realization of conformable devices and introduction of new alternative production methods. Here, we demonstrate that disposable polymeric photonic integrated circuit devices can be produced in lengths of hundreds of meters by ultra-high volume roll-to-roll methods on a flexible carrier. Attenuation properties of hundreds of individual devices were measured confirming that waveguides with good and repeatable performance were fabricated. We also demonstrate the applicability of the devices for the evanescent wave sensing of ambient refractive index. The production of integrated photonic devices using ultra-high volume fabrication, in a similar manner as paper is produced, may inherently expand methods of manufacturing low-cost disposable photonic integrated circuits for a wide range of sensor applications.

Fabrication of optical waveguides by imprinting: usage of positive tone resist as a mould for UV-curable polymer.

Optical ridge type waveguides based on UV-curable polymer were fabricated by imprinting method. Positive tone resist patterned on a silicon wafer was used as a mould. The characterization of waveguides was carried out by coupling TE-polarized light from a tapered fiber into a waveguide with 30 mm length and mapping the intensity distribution with another tapered fiber at the output facet of a waveguide. Proper single- or multimode operation was observed depending on the waveguide width being either 2 microm or 6 microm. Experimental observations on the mode profiles were also supported by the simulation results. Average power transmissions of 32% at 1530 nm wavelength and 45% at 1310 nm wavelength were characterized. The results suggest that the simple mould fabrication process might be a useful technique for device prototyping and that the performance of replicated waveguides can meet the requirements for certain applications.