A multimodal location and routing model for hazardous materials transportation.

The recent US Commodity Flow Survey data suggest that transporting hazardous materials (HAZMAT) often involves multiple modes, especially for long-distance transportation. However, not much research has been conducted on HAZMAT location and routing on a multimodal transportation network. Most existing HAZMAT location and routing studies focus exclusively on single mode (either highways or railways). Motivated by the lack of research on multimodal HAZMAT location and routing and the fact that there is an increasing demand for it, this research proposes a multimodal HAZMAT model that simultaneously optimizes the locations of transfer yards and transportation routes. The developed model is applied to two case studies of different network sizes to demonstrate its applicability. The results are analyzed and suggestions for future research are provided.

Optimal deployment of emissions reduction technologies for construction equipment.

The objective of this research was to develop a multiobjective optimization model to deploy emissions reduction technologies for nonroad construction equipment to reduce emissions in a cost-effective and optimal manner. Given a fleet of construction equipment emitting different pollutants in the nonattainment (NA) and near -nonattainment (NNA) counties of a state and a set of emissions reduction technologies available for installation on equipment to control pollution/emissions, the model assists in determining the mix of technologies to be deployed so that maximum emissions reduction and fuel savings are achieved within a given budget. Three technologies considered for emissions reduction were designated as X, Y, and Z to keep the model formulation general so that it can be applied for any other set of technologies. Two alternative methods of deploying these technologies on a fleet of equipment were investigated with the methods differing in the technology deployment preference in the NA and NNA counties. The model having a weighted objective function containing emissions reduction benefits and fuel-saving benefits was programmed with C++ and ILOG-CPLEX. For demonstration purposes, the model was applied for a selected construction equipment fleet owned by the Texas Department of Transportation, located in NA and NNA counties of Texas, assuming the three emissions reduction technologies X, Y, and Z to represent, respectively, hydrogen enrichment, selective catalytic reduction, and fuel additive technologies. Model solutions were obtained for varying budget amounts to test the sensitivity of emissions reductions and fuel-savings benefits with increasing the budget. Different mixes of technologies producing maximum oxides of nitrogen (NO(x)) reductions and total combined benefits (emissions reductions plus fuel savings) were indicated at different budget ranges. The initial steep portion of the plots for NO(x) reductions and total combined benefits against budgets for different combinations of emissions reduction technologies indicated a high benefit-cost ratio at lower budget amounts. The rate of NO(x) reductions and the increase of combined benefits decreased with increasing the budget, and with the budget exceeding certain limits neither further NO(x) reductions nor increased combined benefits were observed. Finally, the Pareto front obtained would enable the decision-maker to achieve a noninferior optimal combination of total NO(x) reductions and fuel-savings benefits for a given budget.