RESUMO
Bimetallic surface plasmon resonance (SPR) sensors have the potential to overcome the drawbacks of individual metals, but the effect of the configuration of the two metallic layers on the performance of the sensors has not been explored. This study examines the influence of different positions of a thin layer of silver in relation to a copper layer on the sensitivity of such a bimetallic SPR sensor. The design of this configuration aims to improve the SPR reflectance curve and strengthen the evanescent electric field to improve the sensor efficiency. Our findings indicate that, by optimizing the architectures of SPR sensors and using a silver-copper bimetallic structure, we can achieve superior performance compared to devices that utilize only silver or copper. The optimized Ag (5 nm)/Cu (55 nm) sensor design, with the best sensitivity of 299.09° RIU-1, can detect a change of 0.43°/(g dl-1) for hemoglobin in blood, 0.35°/(g dl-1) for glucose in urine, and 0.1°/(%) for methanol in ethanol. We also demonstrate the importance of signal quality by introducing two new parameters that offer a better quantitative indication of the efficiency of a sensor than is obtained by using only sensitivity.
RESUMO
Efforts to realize thin-film solar cells on unconventional substrates face several obstacles in achieving good energy-conversion efficiency and integrating light-management into the solar cell design. In this report a technique to circumvent these obstacles is presented: transferability and an efficient light-harvesting scheme are combined for thin-film silicon solar cells by the incorporation of a NaCl layer. Amorphous silicon solar cells in p-i-n configuration are fabricated on reusable glass substrates coated with an interlayer of NaCl. Subsequently, the solar cells are detached from the substrate by dissolution of the sacrificial NaCl layer in water and then transferred onto a plastic sheet, with a resultant post-transfer efficiency of 9%. The light-trapping effect of the surface nanotextures originating from the NaCl layer on the overlying solar cell is studied theoretically and experimentally. The enhanced light absorption in the solar cells on NaCl-coated substrates leads to significant improvement in the photocurrent and energy-conversion efficiency in solar cells with both 350 and 100 nm thick absorber layers, compared to flat-substrate solar cells. Efficient transferable thin-film solar cells hold a vast potential for widespread deployment of off-grid photovoltaics and cost reduction.
RESUMO
A new back-reflector architecture for light-management in thin-film solar cells is proposed that includes a morphologically smooth top surface with light-scattering microstructures buried within. The microstructures are pyramid shaped, fabricated on a planar reflector using TiO2 nanoparticles and subsequently covered with a layer of Si nanoparticles to obtain a flattened top surface, thus enabling growth of good quality thin-film solar cells. The optical properties of this back-reflector show high broadband haze parameter and wide angular distribution of diffuse light-scattering. The n-i-p amorphous silicon thin-film solar cells grown on such a back-reflector show enhanced light absorption resulting in improved external quantum efficiency. The benefit of the light trapping in those solar cells is evidenced by the gains in short-circuit current density and efficiency up to 15.6% and 19.3% respectively, compared to the reference flat solar cells. This improvement in the current generation in the solar cells grown on the flat-topped (buried pyramid) back-reflector is observed even when the irradiation takes place at large oblique angles of incidence. Finite-difference-time-domain simulation results of optical absorption and ideal short-circuit current density values agree well with the experimental findings. The proposed approach uses a low cost and simple fabrication technique and allows effective light manipulation by utilizing the optical properties of micro-scale structures and nanoscale constituent particles.
