Production and certification of NIST Standard Reference Material 2372 Human DNA Quantitation Standard.

Modern highly multiplexed short tandem repeat (STR) assays used by the forensic human-identity community require tight control of the initial amount of sample DNA amplified in the polymerase chain reaction (PCR) process. This, in turn, requires the ability to reproducibly measure the concentration of human DNA, [DNA], in a sample extract. Quantitative PCR (qPCR) techniques can determine the number of intact stretches of DNA of specified nucleotide sequence in an extremely small sample; however, these assays must be calibrated with DNA extracts of well-characterized and stable composition. By 2004, studies coordinated by or reported to the National Institute of Standards and Technology (NIST) indicated that a well-characterized, stable human DNA quantitation certified reference material (CRM) could help the forensic community reduce within- and among-laboratory quantitation variability. To ensure that the stability of such a quantitation standard can be monitored and that, if and when required, equivalent replacement materials can be prepared, a measurement of some stable quantity directly related to [DNA] is required. Using a long-established conventional relationship linking optical density (properly designated as decadic attenuance) at 260 nm with [DNA] in aqueous solution, NIST Standard Reference Material (SRM) 2372 Human DNA Quantitation Standard was issued in October 2007. This SRM consists of three quite different DNA extracts: a single-source male, a multiple-source female, and a mixture of male and female sources. All three SRM components have very similar optical densities, and thus very similar conventional [DNA]. The materials perform very similarly in several widely used gender-neutral assays, demonstrating that the combination of appropriate preparation methods and metrologically sound spectrophotometric measurements enables the preparation and certification of quantitation [DNA] standards that are both maintainable and of practical utility.

Analysis of mutations in father-son pairs with 17 Y-STR loci.

We have examined 389 father/son sample pairs from U.S. Caucasians, African Americans, Hispanics and Asians using the 17 Y-STR loci in the Yfilertrade mark kit and observed a total of 24 differences between father and son. Thirteen mutations resulted in the gain of a repeat in the son and 11 resulted in a loss of a repeat. All samples resulted in single repeat mutations except one sample which contained a two repeat loss at Y-GATA-H4. Furthermore, two different sample pairs were found to have two mutations. An African American sample pair had a mutation at DYS458 and a second at DYS635 and an Asian sample pair had mutations at DYS439 and Y-GATA-H4.

Results from the NIST 2004 DNA Quantitation Study.

For optimal DNA short tandem repeat (STR) typing results, the DNA concentration ([DNA]) of the sample must be accurately determined prior to the polymerase chain reaction (PCR) amplification step in the typing process. In early 2004, the National Institute of Standards and Technology (NIST) conducted an interlaboratory study to help assess the accuracy of DNA quantitation in forensic DNA laboratories. This study was designed with four primary purposes: (1) to examine concentration effects and to probe performance at the lower DNA concentration levels that are frequently seen in forensic casework; (2) to examine consistency with various methodologies across multiple laboratories; (3) to examine single versus multiple source samples; and (4) to study DNA stability over time and through shipping in two types of storage tubes. Eight DNA samples of [DNA] from 0.05 ng/microL to 1.5 ng/microL were distributed. A total of 287 independent data sets were returned from 80 participants. Results were reported for 19 different DNA quantitation methodologies. Approximately 65% of the data were obtained using traditional slot blot hybridization methods; 21% were obtained using newly available quantitative real-time PCR (Q-PCR) techniques. Information from this interlaboratory study is guiding development of a future NIST Standard Reference Material for Human DNA Quantitation, SRM 2372.

Mitochondrial DNA typing screens with control region and coding region SNPs.

Mitochondrial DNA (mtDNA) analysis has found an important niche in forensic DNA typing. It is used with highly degraded samples or low-copy number materials such as might be found from shed hair or bones exposed to severe environmental conditions. The primary advantage of mtDNA is that it is present in high copy number within cells and therefore more likely to be recovered from highly degraded specimens. A major disadvantage to traditional forensic mtDNA analysis is that it is time-consuming and labor-intensive to generate and review the 610 nucleotides of sequence information commonly targeted in hypervariable regions I and II (HVI and HVII) of the control region. In addition, common haplotypes exist in HVI/HVII mtDNA sequences that can reduce the ability to differentiate two unrelated samples. In this report we describe the utility of two newly available screening assays for rapid exclusion of non-matching samples. The LINEAR ARRAY mtDNA HVI/HVII Region-Sequencing Typing Kit (Roche Applied Science, Indianapolis, IN) was used to type 666 individuals from U.S. Caucasian, African American, and Hispanic groups. Processing of the LINEAR ARRAY probe panels "mito strips" was automated on a ProfiBlot workstation. Observable variation in 666 individuals is reported and frequencies of the mitotypes within and between populations are presented. Samples exhibiting the most common Caucasian mitotype were subdivided with a multiplexed amplification and detection assay using eleven single nucleotide polymorphisms in the mitochondrial genome. These types of screening assays should enable more rapid evaluation of forensic casework samples such that only samples not excluded would be subjected to further characterization through full HVI/HVII mtDNA sequence analysis.

NIST mixed stain study 3: signal intensity balance in commercial short tandem repeat multiplexes.

Short-tandem repeat (STR) allelic intensities were collected from more than 60 forensic laboratories for a suite of seven samples as part of the National Institute of Standards and Technology-coordinated 2001 Mixed Stain Study 3 (MSS3). These interlaboratory challenge data illuminate the relative importance of intrinsic and user-determined factors affecting the locus-to-locus balance of signal intensities for currently used STR multiplexes. To varying degrees, seven of the eight commercially produced multiplexes used by MSS3 participants displayed very similar patterns of intensity differences among the different loci probed by the multiplexes for all samples, in the hands of multiple analysts, with a variety of supplies and instruments. These systematic differences reflect intrinsic properties of the individual multiplexes, not user-controllable measurement practices. To the extent that quality systems specify minimum and maximum absolute intensities for data acceptability and data interpretation schema require among-locus balance, these intrinsic intensity differences may decrease the utility of multiplex results and surely increase the cost of analysis.

High-throughput Y-STR typing of U.S. populations with 27 regions of the Y chromosome using two multiplex PCR assays.

Two Y-chromosome short tandem repeat (STR) multiplex polymerase chain reaction (PCR) assays were used to generate haplotypes for 19 single copy and 3 multi-copy Y-STRs. A total of 27 PCR products were examined in each sample using the following loci: DYS19, DYS385 a/b, DYS388, DYS389I/II, DYS390, DYS391, DYS392, DYS393, DYS426, DYS437, DYS438, DYS439, DYS447, DYS448, DYS450, DYS456, DYS458, DYS460, DYS464 a/b/c/d, H4, and YCAII a/b. The first multiplex is the Y-STR 20plex previously described by Butler et al. [Forensic Sci. Int. 129 (2002) 10]. The second multiplex is a novel Y-STR 11plex and includes DYS385 a/b, DYS447, DYS448 and the new markers DYS450, DYS456, DYS458, and DYS464 a/b/c/d. These two multiplexes were tested on 647 males from three United States population sample sets: 260 African Americans, 244 Caucasians, and 143 Hispanics. Haplotype comparisons between common loci included in the 20plex and 11plex assays as well as commercially available kits found excellent agreement across a sampling of the population samples. The multi-copy loci DYS464, DYS385, and YCAII were the most polymorphic followed by the following single copy Y-STRs: DYS458, DYS390, DYS447, DYS389II, DYS448, and DYS456. Samples containing the most common type in the European database could be well resolved with additional markers beyond the minimal haplotype loci.

NIST Mixed Stain Study 3: DNA quantitation accuracy and its influence on short tandem repeat multiplex signal intensity.

The Mixed Stain Study 3 (MSS3) interlaboratory challenge exercise evaluated the 2001 performance of STR multiplex DNA typing systems using a set of seven DNA extracts of designed concentration and composition. This initial report focuses on the linkages connecting the measurement of the concentration of DNA ([DNA]) to the observed STR multiplex signal intensities. There is a causal relationship between [DNA] measurement accuracy and the efficiency of STR multiplex analysis. There are no intrinsic measurement performance differences among the [DNA] measurement technologies reported. However, there are large differences in the efficiencies of amplification, separation, and detection among participants using the same nominal measurement systems.

Polymerase chain reaction amplification of DNA from aged blood stains: quantitative evaluation of the "suitability for purpose" of four filter papers as archival media.

In collaboration with the Armed Forces Institute of Pathology's Department of Defense DNA Registry, the National Institute of Standards and Technology recently evaluated the performance of a short tandem repeat multiplex with dried whole blood stains on four different commercially available identification card matrixes. DNA from 70 stains that had been stored for 19 months at ambient temperature was extracted or directly amplified and then processed using routine methods. All four storage media provided fully typeable (qualitatively identical) samples. After standardization, the average among-locus fluorescence intensity (electropherographic peak height or area) provided a suitable metric for quantitative analysis of the relative amounts of amplifiable DNA in an archived sample. The amounts of DNA in Chelex extracts from stains on two untreated high-purity cotton linter pulp papers and a paper treated with a DNA-binding coating were essentially identical. Average intensities for the aqueous extracts from a paper treated with a DNA-releasing coating were somewhat lower but also somewhat less variable than for the Chelex extracts. Average intensities of directly amplified punches of the DNA-binding paper were much larger but somewhat more variable than the Chelex extracts. Approximately 25% of the observed variation among the intensity measurements is shared among the four media and thus can be attributed to intrinsic variation in white blood count among the donors. All of the evaluated media adequately "bank" forensically useful DNA in well-dried whole blood stains for at least 19 months at ambient temperature.