Combining surface-sensitive microscopies for analysis of biological tissues after neural device implantation.

In order to address the complexity of chemical analysis of biological systems, time-of-flight secondary ion mass spectrometry (ToF-SIMS), x-ray photoelectron spectroscopy (XPS), and x-ray photoemission electron microscopy (XPEEM) were used for combined surface imaging of a biological tissue formed around a surface neural device after implantation on a nonhuman primate brain. Results show patterns on biological tissue based on extracellular matrix (ECM) and phospholipid membrane (PM) molecular fragments, which were contrasted through principal component analysis of ToF-SIMS negative spectrum. This chemical differentiation may indicate severe inflammation on tissue with an early case of necrosis. Quantification of the elemental composition and the chemical bonding states on both ECM-rich and PM-rich features was possible through XPS analysis from survey and high-resolution spectra, respectively. Variable amounts of carbon (68%-80.5%), nitrogen (10%-2.4%), and oxygen (20.8%-16.5%) were detected on the surface of the biological tissue. Chlorine, phosphorous sodium, and sulfur were also identified in lower extends. Besides that, analysis of the C 1s high-resolution spectra for the same two regions (ECM and PM ones) showed that a compromise between C-C (41.8 at. %) and C-N/C-O (35.6 at. %) amounts may indicate a strong presence of amino acids and proteoglycans on the ECM fragment-rich region, while the great amount of C-C (70.1 at. %) on the PM fragment-rich region is attributed to the large chains of fatty acids connected to phospholipid molecules. The micrometer-scale imaging of these chemical states on tissue was accomplished through XPEEM analysis. The C-C presence was found uniformly distributed across the entire analyzed area, while C-N/C-O and C=O were in two distinct regions. The combination of ToF-SIMS, XPS, and XPEEM is shown here as a powerful, noninvasive approach to map out elemental and chemical properties of biological tissues, i.e., identification of chemically distinct regions, followed by quantification of the surface chemical composition in each distinct region.

Electronic Properties of Transferable Atomically Thin MoSe2/h-BN Heterostructures Grown on Rh(111).

Vertically stacked two-dimensional (2D) heterostructures composed of 2D semiconductors have attracted great attention. Most of these include hexagonal boron nitride (h-BN) as either a substrate, an encapsulant, or a tunnel barrier. However, reliable synthesis of large-area and epitaxial 2D heterostructures incorporating BN remains challenging. Here, we demonstrate the epitaxial growth of nominal monolayer (ML) MoSe2 on h-BN/Rh(111) by molecular beam epitaxy, where the MoSe2/h-BN layer system can be transferred from the growth substrate onto SiO2. The valence band structure of ML MoSe2/h-BN/Rh(111) revealed by photoemission electron momentum microscopy ( kPEEM) shows that the valence band maximum located at the K point is 1.33 eV below the Fermi level ( EF), whereas the energy difference between K and Γ points is determined to be 0.23 eV, demonstrating that the electronic properties, such as the direct band gap and the effective mass of ML MoSe2, are well preserved in MoSe2/h-BN heterostructures.

Beyond van der Waals Interaction: The Case of MoSe2 Epitaxially Grown on Few-Layer Graphene.

Van der Waals heterojunctions composed of graphene and transition metal dichalcogenides have gain much attention because of the possibility to control and tailor band structure, promising applications in two-dimensional optoelectronics and electronics. In this report, we characterized the van der Waals heterojunction MoSe2/few-layer graphene with a high-quality interface using cutting-edge surface techniques scaling from atomic to microscopic range. These surface analyses gave us a complete picture of the atomic structure and electronic properties of the heterojunction. In particular, we found two important results: the commensurability between the MoSe2 and few-layer graphene lattices and a band-gap opening in the few-layer graphene. The band gap is as large as 250 meV, and we ascribed it to an interface charge transfer that results in an electronic depletion in the few-layer graphene. This conclusion is well supported by electron spectroscopy data and density functional theory calculations. The commensurability between the MoSe2 and graphene lattices as well as the band-gap opening clearly show that the interlayer interaction goes beyond the simple van der Waals interaction. Hence, stacking two-dimensional materials in van der Waals heterojunctions enables us to tailor the atomic and electronic properties of individual layers. It also permits the introduction of a band gap in few-layer graphene by interface charge transfer.

Adsorbate Screening of Surface Charge of Microscopic Ferroelectric Domains in Sol-Gel PbZr0.2Ti0.8O3 Thin Films.

We present a study of adsorbate screening of surface charge in microscopic ferroelectric domains in a sol-gel grown PbZr0.2Ti0.8O3 thin film. Low-energy and photoemission electron microscopies were employed to characterize the temperature dependence of surface charge and polarization of ferroelectric domains written by atomic force microscopy. We study the role of charged adsorbates in screening of polarization-bound charges. We demonstrate that full-field electron microscopy is suitable for the determination of ferroelectric system properties such as the Curie temperature.

Laboratory based X-ray photoemission core-level spectromicroscopy of resistive oxide memories.

HfO2-based resistive oxide memories are studied by core-level spectromicroscopy using a laboratory-based X-ray photoelectron emission microscope (XPEEM). After forming, the top electrode is thinned to about 1 nm for the XPEEM analysis, making the buried electrode/HfO2 interface accessible whilst preserving it from contamination. The results are obtained in the true photoemission channel mode from individual memory cells (5 × 5 µm) excited by low-flux laboratory X-rays, in contrast to most studies employing the X-ray absorption channel using potentially harmful bright synchrotron X-rays. Analysis of the local Hf 4f, O 1s and Ti 2p core level spectra yields valuable information on the chemistry of the forming process in a single device, and in particular the central role of oxygen vacancies thanks to the spectromicroscopic approach.

A novel 2-step ALD route to ultra-thin MoS2 films on SiO2 through a surface organometallic intermediate.

The lack of scalable-methods for the growth of 2D MoS2 crystals, an identified emerging material with applications ranging from electronics to energy storage, is a current bottleneck against its large-scale deployment. We report here a two-step ALD route with new organometallic precursors, Mo(NMe2)4 and 1,2-ethanedithiol (HS(CH2)2SH) which consists in the layer-by-layer deposition of an amorphous surface Mo(iv) thiolate at 50 °C, followed by a subsequent annealing at higher temperature leading to ultra-thin MoS2 nanocrystals (∼20 nm-large) in the 1-2 monolayer range. In contrast to the usual high-temperature growth of 2D dichalcogenides, where nucleation is the key parameter to control both thickness and uniformity, our novel two-step ALD approach enables chemical control over these two parameters, the growth of 2D MoS2 crystals upon annealing being ensured by spatial confinement and facilitated by the formation of a buffer oxysulfide interlayer.

Covalent Design for Dye-Sensitized H2-Evolving Photocathodes Based on a Cobalt Diimine-Dioxime Catalyst.

Dye-sensitized photoelectrochemical cells (DS-PECs) for water splitting hold promise for the large-scale storage of solar energy in the form of (solar) fuels, owing to the low cost and ease to process of their constitutive photoelectrode materials. The efficiency of such systems ultimately depends on our capacity to promote unidirectional light-driven electron transfer from the electrode substrate to a catalytic moiety. We report here on the first noble-metal free and covalent dye-catalyst assembly able to achieve photoelectrochemical visible light-driven H2 evolution in mildly acidic aqueous conditions when grafted onto p-type NiO electrode substrate.

Measuring Compositions in Organic Depth Profiling: Results from a VAMAS Interlaboratory Study.

We report the results of a VAMAS (Versailles Project on Advanced Materials and Standards) interlaboratory study on the measurement of composition in organic depth profiling. Layered samples with known binary compositions of Irganox 1010 and either Irganox 1098 or Fmoc-pentafluoro-l-phenylalanine in each layer were manufactured in a single batch and distributed to more than 20 participating laboratories. The samples were analyzed using argon cluster ion sputtering and either X-ray photoelectron spectroscopy (XPS) or time-of-flight secondary ion mass spectrometry (ToF-SIMS) to generate depth profiles. Participants were asked to estimate the volume fractions in two of the layers and were provided with the compositions of all other layers. Participants using XPS provided volume fractions within 0.03 of the nominal values. Participants using ToF-SIMS either made no attempt, or used various methods that gave results ranging in error from 0.02 to over 0.10 in volume fraction, the latter representing a 50% relative error for a nominal volume fraction of 0.2. Error was predominantly caused by inadequacy in the ability to compensate for primary ion intensity variations and the matrix effect in SIMS. Matrix effects in these materials appear to be more pronounced as the number of atoms in both the primary analytical ion and the secondary ion increase. Using the participants' data we show that organic SIMS matrix effects can be measured and are remarkably consistent between instruments. We provide recommendations for identifying and compensating for matrix effects. Finally, we demonstrate, using a simple normalization method, that virtually all ToF-SIMS participants could have obtained estimates of volume fraction that were at least as accurate and consistent as XPS.

Doping characteristics of iodine on as-grown chemical vapor deposited graphene on Pt.

Using laboratory X-ray photoelectron emission microscopy (XPEEM), we investigated the doping efficiency and thermal stability of iodine on as-grown graphene on Pt. After iodine adsorption of graphene in saturated vapor of I2, monolayer and bilayer graphene exhibited work function of 4.93 eV and 4.87 eV, respectively. Annealing of the doped monolayer graphene at 100 °C led to desorption of hydrocarbons, which increased the work function of monolayer graphene by ~0.2 eV. The composition of the polyiodide complexes evolved upon a step-by-step annealing at temperatures from 100 °C to 300 °C while the work-function non-monotonically changed with decreasing iodine content. The iodine dopant was stable at relatively high temperature as a significant amount of iodine remained up to the annealing temperature of 350 °C.

Internal structure of InP/ZnS nanocrystals unraveled by high-resolution soft X-ray photoelectron spectroscopy.

High-energy resolution photoelectron spectroscopy (DeltaE < 200 meV) is used to investigate the internal structure of semiconductor quantum dots containing low Z-contrast elements. In InP/ZnS core/shell nanocrystals synthesized using a single-step procedure (core and shell precursors added at the same time), a homogeneously alloyed InPZnS core structure is evidenced by quantitative analysis of their In3d(5/2) spectra recorded at variable excitation energy. When using a two-step method (core InP nanocrystal synthesis followed by subsequent ZnS shell growth), XPS analysis reveals a graded core/shell interface. We demonstrate the existence of In-S and S(x)-In-P(1-x) bonding states in both types of InP/ZnS nanocrystals, which allows a refined view on the underlying reaction mechanisms.

Synthesis and biological evaluation of cyclopenta[c]thiophene related compounds as new antitumor agents.

A series of 22 cyclopenta[c]thiophene related compounds was obtained by the pharmacomodulation of 6-amino-5,6-dihydro-4H-cyclopenta[c]thiophen-4-ones 1a-g. All compounds were evaluated for potential anticancer activity in the NCI's in vitro human disease-oriented tumor cell line screening panel that consisted of 60 human tumor cell lines arranged in nine subpanels, representing diverse histologies. Among these tested compounds, seven were found to be cytotoxic, especially against leukemia cell lines, allowing us to point out some structure-activity relationships. These derivatives were further evaluated for potential in vivo anticancer activity in the hollow fiber assay developed at the NCI, which selected two compounds, 1f and 3a for standard xenograft testing.