Stability Study of Graphene Oxide-Bovine Serum Albumin Dispersions.

In this work, a stability study of dispersions of graphene oxide and graphene oxide functionalized with polyethylene glycol (PEG) in the presence of bovine serum albumin is carried out. First, a structural characterization of these nanomaterials is performed by scanning electron microscopy, atomic force microscopy, and ultraviolet visible spectroscopy, comparing the starting nanomaterials with the nanomaterials in contact with the biological material, i.e., bovine fetal serum. The different experiments were performed at different concentrations of nanomaterial (0.125-0.5 mg/mL) and BSA (0.01-0.04 mg/mL), at different incubation times (5-360 min), with and without PEG, and at different temperatures (25-40 °C). The SEM results show that BSA is adsorbed on the surface of the graphene oxide nanomaterial. Using UV-Vis spectrophotometry, the characteristic absorption peaks of BSA are observed at 210 and 280 nm, corroborating that the protein has been adsorbed. When the time increases, the BSA protein can be detached from the nanomaterial due to a desorption process. The stability of the dispersions is reached at a pH between 7 and 9. The dispersions behave like a Newtonian fluid with viscosity values between 1.1 and 1.5 mPa·s at a temperature range of 25 to 40 °C. The viscosity values decrease as the temperature increases.

Rheological Properties of Different Graphene Nanomaterials in Biological Media.

Carbon nanomaterials have received increased attention in the last few years due to their potential applications in several areas. In medicine, for example, these nanomaterials could be used as contrast agents, drug transporters, and tissue regenerators or in gene therapy. This makes it necessary to know the behavior of carbon nanomaterials in biological media to assure good fluidity and the absence of deleterious effects on human health. In this work, the rheological characterization of different graphene nanomaterials in fetal bovine serum and other fluids, such as bovine serum albumin and water, is studied using rotational and microfluidic chip rheometry. Graphene oxide, graphene nanoplatelets, and expanded graphene oxide at concentrations between 1 and 3 mg/mL and temperatures in the 25-40 °C range were used. The suspensions were also characterized by transmission and scanning electron microscopy and atomic force microscopy, and the results show a high tendency to aggregation and reveals that there is a protein-nanomaterial interaction. Although rotational rheometry is customarily used, it cannot provide reliable measurements in low viscosity samples, showing an apparent shear thickening, whereas capillary viscometers need transparent samples; therefore, microfluidic technology appears to be a suitable method to measure low viscosity, non-transparent Newtonian fluids, as it is able to determine small variations in viscosity. No significant changes in viscosity are found within the solid concentration range studied but it decreases between 1.1 and 0.6 mPa·s when the temperature raises from 25 to 40 °C.

Amino-Functionalized Multiwall Carbon Nanotubes as Efficient Basic Catalysts for the Formation of γ-Lactams: Synthesis of N-1-Heptenyl-2-pyrrolidinone.

In this work, we prepared a series of N-functionalized carbon nanotubes by means of a process of acylation-amidation of commercial multiwall carbon nanotubes that were previously pre-oxidized with nitric acid. Three different amines, butylamine, N,N-dimethyl ethylenediamine, and ethylenediamine, were used in the process. The characterization of samples by several techniques probed the incorporation of nitrogen atoms to the carbon nanotubes, especially in the case of ethylenediamine. The solids were tested as catalysts in the synthesis of N-1-heptenyl-2-pyrrolidinone, included in the group of a γ-lactams, compounds that show important biological properties. The most active catalyst was that prepared with butylamine, which exhibited the highest SBET and Vpore values and contained an amount of nitrogen that was intermediate between that of the other two catalysts. A yield of 60% to N-1-heptenyl-2-pyrrolidinone was achieved after 3 h at 120 °C under free-solvent conditions. This catalyst could be used in four consecutive cycles without significant activity loss.

Fe-Cu Doped Multiwalled Carbon Nanotubes for Fenton-like Degradation of Paracetamol Under Mild Conditions.

A series of carbon nanotubes doped with Fe and/or Cu, Fe100‒xCux/CNT (x = 0, 25, 50, 75 and 100) has been prepared by an easy method of wetness impregnation of commercial multiwalled carbon nanotubes previously oxidized with nitric acid. The wide characterization of the solids by different techniques demonstrates that the incorporation of Fe and Cu to the CNTs has been successfully produced. Fe100-xCux/CNT samples were tested as catalysts in the removal of paracetamol from aqueous solution by a combined process of adsorption and Fenton-like oxidation. Under mild conditions, 25 °C and natural pH of solution, i.e., nearly neutral, values of oxidation of paracetamol between 90.2% and 98.3% were achieved after 5 h of reaction in most of cases. Furthermore, with the samples containing higher amounts of copper, i.e., Cu100/CNT and Fe25Cu75/CNT, only 2 h were necessary to produce depletion values of 73.2% and 87.8%, respectively. The influence of pH and dosage of H2O2 on the performance has also been studied. A synergic effect between both Cu+/Cu2+ and Fe2+/Fe3+ in Fenton-like reaction was observed. These results demonstrate that Fe100-xCux/CNT are powerful Fenton-like catalyst for degradation of paracetamol from aqueous solution and they could be extended to the removal of other organic pollutants.

A study of hydrogenated carbon fibers by scanning electron microscopy and confocal laser scanning microscopy.

The hydrogen absorption process is studied in carbonaceous fibers produced from a mixture of methane and hydrogen. The absorption of the hydrogen was examined in two types of fibers, in "as-grown" state and after a process of desorption during an annealing to 1.473 K under vacuum. Later to its production process, the fibers withstand an oxidation in air to 973 K. The fibers were examined by means of scanning electron microscopy (SEM) and confocal microscopy by reflection. Differences in the behavior during the oxidation were observed between the fibers in as-grown state and those subjected to a further annealing. It could be verified that the fibers were really constituted by two different phases. In one of the phases, the storage of the hydrogen absorbed took place, whereas in the other phase there was no alteration. The process of annealing prior to the absorption of the hydrogen has an appreciable effect on the desorption rate of the hydrogen.