Interest of a new large diffusive gradients in thin films (L-DGT) for organic compounds monitoring: On-field comparison with conventional passive samplers.

In this work, the performances of a Large Diffusive Gradients in Thin films (L-DGT, i.e., a DGT based on a Chemcatcher® holder with a 5-fold larger sampling area) were compared on-field with the conventional DGT and the Polar Organic Chemical Integrative Sampler (POCIS) for the monitoring of a wide range of organic contaminants (i.e., 65 pesticides and metabolites, 53 pharmaceuticals and 12 hormones). These three passive samplers were simultaneously deployed in four rivers during 14 days. Their performances were then evaluated according to their detection and quantification capacities and their physical robustness. The results obtained confirm the advantages of the L-DGT over the conventional DGT regarding its sensitivity but also its robustness during field deployment. The POCIS provides the higher sensitivity, allowing the detection of more organic compounds compared to the DGT and, to a lesser extent, the L-DGT. However, both L-DGT and DGT reduces the uncertainty on the determination of the time-weighted average concentrations (CW), mainly due to the narrow range of variation of their calibration parameters. Indeed, for a given compound, CW can vary up to only a 3-fold factor with DGT and L-DGT compared to a 2 to 10-fold factor (up to 50) with POCIS. Thus, the L-DGT appears to be more suitable than DGT in low-contaminated contexts, which require higher sensitivity, or than POCIS when a CW determination is needed. For a qualitative evaluation however, the POCIS remains the most suitable passive sampler.

Diffusive gradients in thin films (DGT): A suitable tool for metals/metalloids monitoring in continental waterbodies at the large network scale.

The contribution of Diffusive Gradients in Thin films (DGT) passive sampling to continental water quality monitoring was assessed in a real measurement network (6 sampling campaigns, 17 stations). Ten metals/metalloids (Al, Zn, Ni, Cd, Cu, Pb, Cr, As, Se and Sb) were studied using the control laboratory's working conditions with grab and DGT passive sampling. The DGT field deployments were robust, with a 3% sampler loss rate and a <65% average relative deviation between duplicates. Compared to grab sampling, DGT showed a similar quantification frequency for half of the targeted elements but showed a higher frequency for the other half (e.g., Cd quantification at 20% with grab sampling vs. 97% with DGT). Similar concentration trends were established using DGT and grab sampling at most sites throughout the year. Notably, for some elements, trends were only provided by DGT sampling. A study of several DGT blanks showed that the device contamination was occasional and originated primarily from cross-contamination during the disassembly step. Considering this contamination, the operational sensitivity by DGT was at least between 1 and 5 times greater in comparison to that by grab sampling. Estimations of the economic cost revealed that measurement networks cost 2 to 3 times more when monitored by DGT compared to standard grab monitoring. However, the information obtained based on each type of sampling method is different. Grab sampling is easy to implement and can highlight high contamination peaks. The DGT concentrations are averaged over time and are relevant to chronic exposure evaluations. Considering the good performance of the DGT sampling highlighted in this study and its complementarity with grab sampling in terms of water quality assessments, a combination of these two types of sampling, which can be affordable, should improve the water quality evaluation within monitoring networks.