Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Mais filtros










Base de dados
Intervalo de ano de publicação
1.
Life (Basel) ; 12(9)2022 Aug 26.
Artigo em Inglês | MEDLINE | ID: mdl-36143352

RESUMO

Continuous wave (CW) and microsecond pulse (MP) laser irradiations were compared regarding cell damage and laser-induced temperature rise at retinal pigment epithelium (RPE). The RPE of porcine RPE-choroid-sclera explants was irradiated with a 577 nm laser in CW or MP mode (5% or 15% duty cycle (DC)) for 20 ms or 200 ms at an average laser power of 20−90 mW. Cell viability was investigated with calcein-AM staining. Optoacoustic (OA) technique was employed for temperature measurement during irradiation. For 200 ms irradiation, the dead cell area (DCA) increased linearly (≈1600 µm2/mW) up to the average power of 40 mW for all modes without significant difference. From 50 mW, the increase of DCA of MP-5% significantly dropped to 610 µm2/mW (p < 0.05), likely due to the detected microbubble formation. OA temperature measurement showed a monotonic temperature increase in CW mode and a stepwise increase in MP mode, but no significant difference in the average temperature increase at the same average power, consistent with the temperature modeling. In conclusion, there is no difference in the average temperature rise between CW and MP modes at the same average power regardless of DC. At lower DC, however, more caution is required regarding mechanical damage due to microbubble formation.

2.
J Biomed Opt ; 22(11): 1-11, 2017 Nov.
Artigo em Inglês | MEDLINE | ID: mdl-29164836

RESUMO

Laser photocoagulation has been a treatment method for retinal diseases for decades. Recently, studies have demonstrated therapeutic benefits for subvisible effects. A treatment mode based on an automatic feedback algorithm to reliably generate subvisible and visible irradiations within a constant irradiation time is introduced. The method uses a site-individual adaptation of the laser power by monitoring the retinal temperature rise during the treatment using optoacoustics. This provides feedback to adjust the therapy laser power during the irradiation. The technique was demonstrated on rabbits in vivo using a 532-nm continuous wave Nd:YAG laser. The temperature measurement was performed with 523-nm Q-switched Nd:YLF laser pulses with 75-ns pulse duration at 1-kHz repetition rate. The beam diameter on the fundus was 200 µm for both lasers, respectively. The aim temperatures ranged from 50°C to 75°C in 11 eyes of 7 rabbits. The results showed ophthalmoscopically invisible effects below 55°C with therapy laser powers over a wide range. The standard deviation for the measured temperatures ranged from 2.1°C for an aim temperature of 50°C to 4.7°C for 75°C. The ED50 temperature value for ophthalmoscopically visible lesions in rabbits was determined as 65.3°C. The introduced method can be used for retinal irradiations with adjustable temperature elevations.


Assuntos
Terapia a Laser , Doenças Retinianas/terapia , Temperatura , Animais , Coelhos
3.
J Biomed Opt ; 22(10): 1-14, 2017 Oct.
Artigo em Inglês | MEDLINE | ID: mdl-29030943

RESUMO

A holographic method for high-speed, noncontact photoacoustic tomography is introduced and evaluated. Relative changes of the object's topography, induced by the impact of thermoelastic pressure waves, were determined at nanometer sensitivity without physical contact. The object's surface was illuminated with nanosecond laser pulses and imaged with a high-speed CMOS camera. From two interferograms measured before and after excitation of the acoustic wave, surface displacement was calculated and then used as the basis for a tomographic reconstruction of the initial pressure caused by optical absorption. The holographic detection scheme enables variable sampling rates of the photoacoustic signal of up to 50 MHz. The total acquisition times for complete volumes with 230 MVoxel is far below 1 s. Measurements of silicone and porcine skin tissue phantoms with embedded artificial absorbers, which served as a model for human subcutaneous vascular networks, were possible. Three-dimensional reconstructions of the absorbing structures show details with a diameter of 310 µm up to a depth of 2.5 mm. Theoretical limitations and the experimental sensitivity, as well as the potential for in vivo imaging depending on the detection repetition rate, are analyzed and discussed.


Assuntos
Imagens de Fantasmas , Técnicas Fotoacústicas/métodos , Pele/diagnóstico por imagem , Tomografia/métodos , Acústica , Algoritmos , Animais , Artefatos , Desenho de Equipamento , Holografia , Humanos , Aumento da Imagem , Processamento de Imagem Assistida por Computador , Imageamento Tridimensional , Interferometria , Movimento (Física) , Óptica e Fotônica , Pressão , Silicones/química , Suínos
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA
...