One explanation for the variability of the bacterial suspension test.

Disinfection kinetic studies of sodium dodecyl sulphate, benzalkonium chloride and sodium hypochlorite against Staphylococcus aureus revealed that when a higher inoculum level of Staph. aureus than normal was used (approximately 1 log higher), the efficacy of disinfection was severely attenuated. Kinetic analysis using the Hom model for experiments carried out on tests using 3 x 108 organisms ml-1 were unable to account for the large increase in disinfection power observed when smaller inoculum levels were used. Since the inoculum was the same in every way except for the numbers used, the large variations in the log reduction/time curves could not be explained by a variation in the resistance of the population to the biocide, as identical log reduction-time curves should have resulted. The level of disinfection achieved for a given concentration of biocide was found to be approximately linearly related to the cell number ml-1 of test solution and not to the log number. The variation observed is believed to occur due to intrinsic self-quenching of the biocide by the microbes during the course of the disinfection test. As the level of free biocide decreases, the rate of reaction decreases, giving the tails of the log reduction/time curves. Such intrinsic self-quenching could explain the large variations known to occur in the legally required disinfection suspension tests.

A kinetic study of the effect of hydrogen peroxide and peracetic acid against Staphylococcus aureus and Pseudomonas aeruginosa using the bioscreen disinfection method.

Hydrogen peroxide and peracetic acid at pH 4 were examined against Staphylococcus aureus and Pseudomonas aeruginosa using the published 'Bioscreen' technique of biocide analysis. The data were examined using either classical Chick-Watson (CW) log-linear disinfection kinetics or the empirical, non-linear time Hom model. In some cases, modelling the data with the classical CW method gave good linear correlations, in others, however, deviations from this model were observed. In such cases the Hom model proved an adequate descriptor of the data. The Bioscreen technique therefore gives data which can be analysed using the normal mechanistic and empirical models currently available.

Disinfectant testing: use of the Bioscreen Microbiological Growth Analyser for laboratory biocide screening.

A new method is described for screening potential biocides based on the traditional suspension test using the Bioscreen optical plate reader. This new method is rapid, reproducible, quantitative and cost effective. Data obtained by this new method are not directly equivalent to the log reduction normally quoted, but give a measurement of the total effect of the biocide on the microbe population, measuring the effect of injury as well as death (non-viability). The method allows for the routine examination of disinfection kinetics, the study of which leads to greater scientific insight into disinfection than that achieved by the standard 5 min, one-point, disinfection tests currently employed.