Knee instability caused by altered graft mechanical properties after anterior cruciate ligament reconstruction: the early onset of osteoarthritis?

Anterior cruciate ligament (ACL) rupture is a very common knee joint injury. Torn ACLs are currently reconstructed using tendon autografts. However, half of the patients develop osteoarthritis (OA) within 10 to 14 years postoperatively. Proposedly, this is caused by altered knee kine(ma)tics originating from changes in graft mechanical properties during the in vivo remodeling response. Therefore, the main aim was to use subject-specific finite element knee models and investigate the influence of decreasing graft stiffness and/or increasing graft laxity on knee kine(ma)tics and cartilage loading. In this research, 4 subject-specific knee geometries were used, and the material properties of the ACL were altered to either match currently used grafts or mimic in vivo graft remodeling, i.e., decreasing graft stiffness and/or increasing graft laxity. The results confirm that the in vivo graft remodeling process increases the knee range of motion, up to >300 percent, and relocates the cartilage contact pressures, up to 4.3 mm. The effect of remodeling-induced graft mechanical properties on knee stability exceeded that of graft mechanical properties at the time of surgery. This indicates that altered mechanical properties of ACL grafts, caused by in vivo remodeling, can initiate the early onset of osteoarthritis, as observed in many patients clinically.

A decellularized and sterilized human meniscus allograft for off-the-shelf meniscus replacement.

PURPOSE: Meniscus tears are one of the most frequent orthopedic knee injuries, which are currently often treated performing meniscectomy. Clinical concerns comprise progressive degeneration of the meniscus tissue, a change in knee biomechanics, and an early onset of osteoarthritis. To overcome these problems, meniscal transplant surgery can be performed. However, adequate meniscal replacements remain to be a great challenge. In this research, we propose the use of a decellularized and sterilized human meniscus allograft as meniscal replacement. METHODS: Human menisci were subjected to a decellularization protocol combined with sterilization using supercritical carbon dioxide (scCO2). The decellularization efficiency of human meniscus tissue was evaluated via DNA quantification and Hematoxylin & Eosin (H&E) and DAPI staining. The mechanical properties of native, decellularized, and decellularized + sterilized meniscus tissue were evaluated, and its composition was determined via collagen and glycosaminoglycan (GAG) quantification, and a collagen and GAG stain. Additionally, cytocompatibility was determined in vitro. RESULTS: Human menisci were decellularized to DNA levels of ~ 20 ng/mg of tissue dry weight. The mechanical properties and composition of human meniscus were not significantly affected by decellularization and sterilization. Histologically, the decellularized and sterilized meniscus tissue had maintained its collagen and glycosaminoglycan structure and distribution. Besides, the processed tissues were not cytotoxic to seeded human dermal fibroblasts in vitro. CONCLUSIONS: Human meniscus tissue was successfully decellularized, while maintaining biomechanical, structural, and compositional properties, without signs of in vitro cytotoxicity. The ease at which human meniscus tissue can be efficiently decellularized, while maintaining its native properties, paves the way towards clinical use.

An off-the-shelf decellularized and sterilized human bone-ACL-bone allograft for anterior cruciate ligament reconstruction.

Approximately 1% of active individuals participating in sports rupture their anterior cruciate ligaments (ACL) every year, which is currently reconstructed using tendon autografts. Upon reconstruction, clinical issues of concern are ACL graft rupture, persistent knee instability, limited return to sports, and early onset of osteoarthritis (OA). This happens because tendon autografts do not have the same compositional, structural, and mechanical properties as a native ACL. To overcome these problems, we propose to use decellularized bone-ACL-bone allografts in ACL reconstruction (ACLR) as a mechanically robust, biocompatible, and immunologically safe alternative to autografts. Here, a decellularization protocol combined with sterilization using supercritical carbon dioxide (scCO2) was used to thoroughly decellularize porcine and human ACLs attached to tibial and femoral bone blocks. The specimens were named ultrACLean and their compositional, structural, and mechanical properties were determined. Our results indicate that: 1) decellularization of ultrACLean allografts leads to the removal of nearly 97% of donor cells, 2) ultrACLean has mechanical properties which are not different to native ACL, 3) ultrACLean maintained similar collagen content and decreased GAG content compared to native ACL, and 4) ultrACLean is not cytotoxic to seeded tendon-derived cells in vitro. Results from an in vivo pilot experiment showed that ultrACLean is biocompatible and elicits a moderate immunological response. In summary, ultrACLean has proven to be a mechanically competent and biocompatible graft with the potential to be used in ACLR surgery.

Ultrasound-Based Quantification of Cartilage Damage After In Vivo Articulation With Metal Implants.

OBJECTIVE: This study aims to evaluate the applicability of the ultrasound roughness index (URI) for quantitative assessment of cartilage quality ex vivo (post-mortem), after 6 months of in vivo articulation with a Focal Knee Resurfacing Implant (FKRI). DESIGN: Goats received a metal FKRI (n = 8) or sham surgery (n = 8) in the medial femoral condyles. After 6 months animals were sacrificed, tibial plateaus were stained with Indian ink, and macroscopic scoring of the plateaus was performed based on the ink staining. The URI was calculated from high-frequency ultrasound images at several sections, covering both areas that articulated with the implant and non-articulating areas. Cartilage quality at the most damaged medial location was evaluated with a Modified Mankin Score (MMS). RESULTS: The URI was significantly higher in the FKRI-articulating than in the sham plateaus at medial articulating sections, but not at sections that were not in direct contact with the implant, for example, under the meniscus. The mean macroscopic score and MMS were significantly higher in the FKRI-articulating group than in the sham group (P=0.035, P<0.001, respectively). Correlation coefficients between URI and macroscopic score were significant in medial areas that articulated with the implant. A significant correlation between URI and MMS was found at the most damaged medial location (ρ=0.72,P=0.0024). CONCLUSIONS: This study demonstrates the potential of URI to evaluate cartilage roughness and altered surface morphology after in vivo articulation with a metal FKRI, rendering it a promising future tool for quantitative follow-up assessment of cartilage quality.

Solid-phase silica-based extraction leads to underestimation of residual DNA in decellularized tissues.

Decellularization of animal tissues is a novel route to obtain biomaterials for use in tissue engineering and organ transplantation. Successful decellularization is required as animal DNA causes inflammatory reactions and contains endogenous retroviruses, which could be transmitted to the patient. One of the criteria for successful decellularization is digestion (fragmentation) and elimination (residual quantity) of DNA from the tissue. Quantification of DNA can be done in many ways, but it has recently been shown that silica-based solid-phase extraction methods often do not completely purify in particular small DNA fragments. In the context of decellularization, this means that the measured DNA amount is underestimated, which could compromise safety of the processed tissue for in-patient use. In this article, we review DNA quantification methods used by researchers and assess their influence on the reported DNA contents after decellularization. We find that underestimation of residual DNA amount after silica-based solid-phase extraction may be as large as a factor of ten. We therefore recommend a direct assessment of DNA amount in tissue lysate using dsDNA-specific binding dyes, such as Picogreen, due to their higher accuracy for small fragment detection as well as ease of use and widespread availability.