Porphyrin-doped solgel-lined structured optical fibers for local and remote sensing.

We constructed a type of sensor by depositing a solgel layer within the interior holes of a silica-structured fiber and, subsequently, coating this with an acid-responsive porphyrin. Protonation of the porphyrin by an acidic gas (HCl in this case), is detected by a large change in the visible spectrum. Compared to previous work on a liquid-core sensor in a structured optical fiber, the signal-to-noise ratio of this gas sensor shows a reduced signal strength, but the detection rate is increased about fortyfold.

Evaluation of optical fiber microcell reactor for use in remote acid sensing.

An optical fiber acid-sensor based on protonation of a porphyrin solution within a single-hole structured optical fiber is proposed and demonstrated. The liquid-core fiber acts as a microcell reactor, and changes in the spectral signature with acidification are detected. Challenges and limitations in the practical deployment of such sensors are evaluated. An effective chemical sensor is demonstrated, but issues such as diffusion limit its full utilization. Some solutions are discussed.

Evanescent-field spectroscopy using structured optical fibers: detection of charge-transfer at the porphyrin-silica interface.

The fabrication of porphyrin thin films derived from dichloro[5,10,15,20-tetra(heptyl)porphyrinato]tin(IV) [Cl-Sn(THP)-Cl] in the holes of photonic crystal fibers over 90 cm in length is described. Evanescent field spectroscopy (EFS) is used to investigate the interfacial properties of the films, with the high surface optical intensity and the long path length combining to produce significant absorption. By comparison with results obtained for similar films formed from Cl-Sn(THP)-Cl inside fused-silica cuvettes and on glass slides, the film is shown to be chemisorbed as a surface Si-O-Sn(THP)-X (X = Cl or OH) species. In addition to the usual porphyrin Q and Soret bands, new absorptions in the in-fiber films are observed by EFS at 445 nm and between 660-930 nm. The 660-930 nm band is interpreted as a porphyrin to silicon charge-transfer transition and postulated to arise following chemisorption at mechanical-strain induced defect sites on the silica surface. Such defect sites are caused by the optical fiber production process and are less prevalent on other glass surfaces. EFS within optical fibers therefore offers new ways for understanding interface phenomena such as surface adsorbates on glass. Such understanding will benefit all devices that exploit interface phenomena, both in optical fibers and other integrated waveguide forms. They may be directly exploited to create ultrasensitive molecular detectors and could yield novel photonic devices.

Water-soluble porphyrin detection in a pure-silica photonic crystal fiber.

Aqueous solutions of the water-soluble porphyrin 5,10,15,20-tetrakis(4-sulfonatophenyl)porphyrinatomanganese(III) acetate were inserted into the holes of a photonic crystal fiber, and the porphyrin absorption bands were identified. Results were obtained for three concentrations. The porphyrins in water show no surface interactions with the silica walls of the capillary channels. We discuss the implications for future hybrid electronic and photonic fiber devices.