Copper nanowire array as highly selective electrochemical sensor of nitrate ions in water.

Contamination of water with nitrate ions is a significant problem that affects many areas of the world. For this reason, European legislation has set the maximum permissible concentration of nitrates in drinking water at 44 mg/L. Thus, it is clear that a continuous monitoring of nitrate ions is of high technological interest but it must be rapid, easy to perform and directly performable in situ. In this work we have developed a nanostructured sensor based on array of copper nanowires obtained with the simple method of galvanic deposition. The nanostructured sensors have a very short response time with a detection limit less than 10 µM. Different interfering species were tested finding a negligible effect except for the chloride ions. However, this problem has been solved by removing chloride ions from the water through a simple precipitation of chloride compounds with low solubility. Nanostructured sensors were also used to analyze real water samples (rain, river and drinking water). In the case of drinking water, we have measured a concentration of nitrate ions very close to the that measured by conventional laboratory techniques.

Electro-synthesis of Sn-Co nanowires in alumina membranes.

A fabrication process of amorphous nanowires of Sn-Co alloys, based on electrodeposition into anodic alumina membranes, is described. It is shown that nanowires of tin-cobalt alloys with different compositions can be produced by varying electrodeposition time and concentration ratio of salts dissolved into the electrolytic bath. Importance of the chelating agent to produce amorphous Sn-Co alloys has also been addressed. Electrodepositions were carried out potentiostatically at -1 V versus Saturated Calomel Electrode and 60 degrees C for times ranging from 10 to 90 minutes; the atomic fraction of Co2+ in the aqueous electrolyte (Co2+/(Co2+ + Sn2+)) was varied from 0.33 to 0.67. Nanowires aspect ratio (height/width) was controlled by adjusting the deposition time. Alloys were characterized by scanning electron microscopy and X-ray diffraction; compositional analysis was performed by energy dispersive spectroscopy and induced coupled plasma. The highest concentration of Co in the alloy was found after 90 min of electrodeposition from a bath containing 67% of Co2+.