Effect of the Addition of Graphene Flakes on the Physical and Biological Properties of Composite Paints.

In this study, graphene flakes were obtained using an electrolytic method and characterized using X-ray diffraction (XRD), Raman and FTIR spectroscopy, scanning and transmission electron microscopy (SEM/TEM). Graphene-based composites with varying concentrations of 0.5%, 1% and 3% by weight were prepared with acrylic paint, enamel and varnish matrices. The mechanical properties were evaluated using micro-hardness testing, while wettability and antimicrobial activity against three pathogens (Staphylococcus aureus 33591, Pseudomonas aeruginosa 15442, Candida albicans 10231) were also examined. The results indicate that the addition of graphene flakes significantly enhances both the mechanical and antimicrobial properties of the coatings.

The Influence of Microstructure on Abrasive Wear Micro-Mechanisms of the Claddings Produced by Welding Used in Agricultural Soil.

Claddings produced by welding are commonly used to increase the durability of the working elements of agricultural tools. The working conditions that occur during the cultivation of agricultural soil determine the wear intensity (different soil fractions, biological, and chemical environment). It was found that the tested claddings (Fe-Cr-C-Nb system) is characterized by three different layers: hypereutectic (layer I), near eutectic (layer II), and hypoeutectic (layer III). In layer I, micro-cracking and spalling of hard and brittle primary M7C3 carbides resulted in micro-delamination under the impact of larger soil fractions, which increased the wear intensity. Due to the lower fraction of primary M7C3 carbides in layer II, the share of micro-delamination was less significant in comparison to layer I. It was found that niobium carbides are firmly embedded in the matrix and effectively inhibit wear intensity in layer I and layer II. Layer III contained austenite dendrites, a refined eutectic mixture, and also NbC. In this layer, cracks (caused the unfavorable eutectic mixture morphology) were found in the interdendritic spaces at the worn surface. After the penetration of the cladding, there was a "wash-out effect", which resulted in a significant reduction in the durability of the working elements due to abrasive wear.