Warped graphitic layers generated by oxidation of fullerene extraction residue and its oxygen reduction catalytic activity.

Carbon-based oxygen reduction reaction (ORR) catalysts are regarded as a promising candidate to replace the currently used Pt catalyst in polymer electrolyte fuel cells (PEFCs); however, the active sites remain under discussion. We predicted that warped graphitic layers (WGLs) are responsible for the ORR catalytic activity in some carbon catalysts (i.e., carbon alloy catalysts (CACs)). To prove our assumption, we needed to use WGLs consisting of carbon materials, but without any extrinsic catalytic elements, such as nitrogen, iron, or cobalt, which effectively enhance ORR activity. The present study employed a fullerene extraction residue as a starting material to construct WGLs. The oxidation of the material at 600 °C exposed the WGLs by removing the surrounding amorphous moieties. Transmission electron microscopy (TEM) observations revealed the formation of WGLs by oxidation treatment at 600 °C in an O2/N2 stream. Extending the oxidation time increased the purity of the WGL phase, but also simultaneously increased the concentration of oxygen-containing surface functional groups as monitored by temperature programmed desorption (TPD). The specific ORR activity increased with oxidation up to 1 h and then decreased with the intensive oxidation treatment. Correlations between the specific ORR activity and other parameters confirmed that the development of the WGL and the increase in the O/C ratio are the competing factors determining specific ORR activity. These results explain the maximum specific ORR activity after 1 h of oxidation time. WGLs were found to lower the heat of adsorption for O2 and to increase the occurrence of heterogeneous electron transfer.

Novel strategy using an adsorbent-column chromatography for effective ethanol production from sugarcane or sugar beet molasses.

Molasses-based distilleries generate large volumes of a highly polluted and dark brown-colored wastewater. The present work describes the way in which an adsorbent-column chromatography can effectively remove the colorant and produce biomass ethanol from sugarcane or sugar beet molasses. It was found that the color and chemical oxygen demand of the resulting wastewater was respectively reduced by approximately 87% and 28% as compared with conventional molasses fermentation. Gas chromatography showed that the decolorized molasses maintained good ethanol productivity almost equal to that of the original molasses. Furthermore, it was revealed that the colorant concentrations of about 5 mg ml(-1) in the medium were the most favorable for ethanolic fermentation. In summary, we have concluded that this method is the most effective when the adsorbent chromatography is performed just before molasses fermentation and that the decolorized molasses is an ideal substrate for fuel ethanol production.

Application of electron beam for the reduction of PCDD/F emission from municipal solid waste incinerators.

The electron-beam technology was applied to reduce the emission of polychlorinated dibenzo-p-dioxins (PCDD) and polychlorinated dibenzofurans (PCDF) in a flue gas of 1000 m(3)N/h from the municipal solid waste incinerator (MSWI) at a temperature of 200 degrees C. More than 90% decomposition of PCDD/Fs was obtained using an electron accelerator at a dose of 14 kGy. The decomposition was initiated through reactions with OH radicals produced by the irradiation of flue gases, followed by oxidation such as the ring cleavage of the aromatic ring, the dissociation of ether bond, and dechlorination. The cost analysis estimated that the electron-beam system can cut the annualized cost by approximately 50% for the treatment of PCDD/Fs in a pre-dusted MSWI flue gas as compared with a bag-filter system when operating on electricity generated from an incineration. Electron-beam technology is an economically and technologically useful method for reducing PCDD/Fs in an incineration flue gas.