Adsorption-Induced Expansion of Graphene Oxide Frameworks: Observation by in Situ Neutron Diffraction.

We have investigated adsorption-induced deformation in graphene oxide framework materials (GOFs) using neutron diffraction at sample pressures up to 140 bar. GOFs, made by the solvothermal reaction of graphite oxide and benzene-1,4-diboronic acid, are a suitable candidate for deformation studies due to their narrow (∼1 nm), monodispersed, slit-shaped pores whose width can be measured by diffraction techniques. We have observed, in situ, a monotonic expansion of the slit width with increasing pressure upon adsorption of xenon, methane, and hydrogen under supercritical conditions. The expansion of ∼4% observed for xenon at a pressure of 48 bar is the largest deformation yet reported for supercritical adsorption on a carbonaceous material. We find that the expansion of the three gases can be mapped onto a common curve based solely on their Lennard-Jones parameters, in a manner similar to a law of corresponding states.

Spontaneous formation of nanopatterns in velocity-dependent dip-coated organic films: from dragonflies to stripes.

We present an experimental study of the micro- and mesoscopic structure of thin films of medium length n-alkane molecules on the native oxide layer of a silicon surface, prepared by dip-coating in a n-C32H66/n-heptane solution. Electron micrographs reveal two distinct adsorption morphologies depending on the substrate withdrawal speed v. For small v, dragonfly-shaped molecular islands are observed. For a large v, stripes parallel to the withdrawal direction are observed. These have lengths of a few hundred micrometers and a few micrometer lateral separation. For a constant v, the stripes' quality and separation increase with the solution concentration. Grazing incidence X-ray diffraction and atomic force microscopy show that both patterns are 4.2 nm thick monolayers of fully extended, surface-normal-aligned alkane molecules. With increasing v, the surface coverage first decreases then increases for v > v(cr) ∼ 0.15 mm/s. The critical v(cr) marks a transition between the evaporation regime, where the solvent's meniscus remains at the bulk's surface, and the entrainment (Landau-Levich-Deryaguin) regime, where the solution is partially dragged by the substrate, covering the withdrawn substrate by a homogeneous film. The dragonflies are single crystals with habits determined by dendritic growth in prominent 2D crystalline directions of randomly seeded nuclei assumed to be quasi-hexagonal. The stripes' strong crystalline texture and the well-defined separation are due to an anisotropic 2D crystallization in narrow liquid fingers, which result from a Marangoni flow driven hydrodynamic instability in the evaporating dip-coated films, akin to the tears of wine phenomenology.

Fabry-Pérot cavity sensors for multipoint on-column micro gas chromatography detection.

We developed and characterized a Fabry-Pérot (FP) sensor module based micro gas chromatography (microGC) detector for multipoint on-column detection. The FP sensor was fabricated by depositing a thin layer of metal and a layer of gas-sensitive polymer consecutively on the endface of an optical fiber, which formed the FP cavity. Light partially reflected from the metal layer and the polymer-air interface generated an interference spectrum, which shifted as the polymer layer absorbed the gas analyte. The FP sensor module was then assembled by inserting the FP sensor into a hole drilled in the wall of a fused-silica capillary, which can be easily connected to the conventional gas chromatography (GC) column through a universal quick seal column connector, thus enabling on-column real-time detection. We characterized the FP sensor module based microGC detector. Sensitive detection of various gas analytes was achieved with subnanogram detection limits. The rapid separation capability of the FP sensor module assembled with both single- and tandem-column systems was demonstrated, in which gas analytes having a wide range of polarities and volatilities were well-resolved. The tandem-column system obtained increased sensitivity and selectivity by employing two FP sensor modules coated with different polymers, showing great system versatility.

Crystalline-to-plastic phase transitions in molecularly thin n-dotriacontane films adsorbed on solid surfaces.

Crystalline-to-rotator phase transitions have been widely studied in bulk hydrocarbons, in particular in normal alkanes. But few studies of these transitions deal with molecularly thin films of pure n-alkanes on solid substrates. In this work, we were able to grow dotriacontane (n-C(32)H(66)) films without coexisting bulk particles, which allows us to isolate the contribution to the ellipsometric signal from a monolayer of molecules oriented with their long axis perpendicular to the SiO(2) surface. For these submonolayer films, we found a step in the ellipsometer signal at approximately 331 K, which we identify with a solid-solid phase transition. At higher coverages, we observed additional steps in the ellipsometric signal that we identify with a solid-solid phase transition in multilayer islands ( approximately 333 K) and with the transition to the rotator phase in bulk crystallites ( approximately 337 K), respectively. After considering three alternative explanations, we propose that the step upward in the ellipsometric signal observed at approximately 331 K on heating the submonolayer film is the signature of a transition from a perpendicular monolayer phase to a denser phase in which the alkane chains contain on average one to two gauche defects per molecule.

Structure and growth of vapor-deposited n-dotriacontane films studied by X-ray reflectivity.

We have used synchrotron X-ray reflectivity measurements to investigate the structure of n-dotriacontane (n-C(32)H(66) or C32) films deposited from the vapor phase onto a SiO(2)-coated Si(100) surface. Our primary motivation was to determine whether the structure and growth mode of these films differ from those deposited from solution on the same substrate. The vapor-deposited films had a thickness of approximately 50 A thick as monitored in situ by high-resolution ellipsometry and were stable in air. Similar to the case of solution-deposited C32 films, we find that film growth in vacuum begins with a nearly complete bilayer adjacent to the SiO(2) surface formed by C32 molecules aligned with their long axis parallel to the interface followed by one or more partial layers of perpendicular molecules. These molecular layers coexist with bulk particles at higher coverages. Furthermore, after thermally cycling our vapor-deposited samples at atmospheric pressure above the bulk C32 melting point, we find the structure of our films as a function of temperature to be consistent with a phase diagram inferred previously for similarly treated solution-deposited films. Our results resolve some of the discrepancies that Basu and Satija (Basu, S.; Satija, S. K. Langmuir 2007, 23, 8331) found between the structure of vapor-deposited and solution-deposited films of intermediate-length alkanes at room temperature.

Ellipsometric and neutron diffraction study of pentane physisorbed on graphite.

High-resolution ellipsometry and neutron diffraction measurements have been used to investigate the structure, growth, and wetting behavior of fluid pentane (n-C(5)H(12)) films adsorbed on graphite substrates. We present isotherms of the thickness of pentane films adsorbed on the basal-plane surfaces of a pyrolytic graphite substrate as a function of the vapor pressure. These isotherms are measured ellipsometrically for temperatures between 130 and 190 K. We also describe neutron diffraction measurements in the temperature range 11-140 K on a deuterated pentane (n-C(5)D(12)) monolayer adsorbed on an exfoliated graphite substrate. Below a temperature of 99 K, the diffraction patterns are consistent with a rectangular centered structure. Above the pentane triple point at 143.5 K, the ellipsometric measurements indicate layer-by-layer adsorption of at least seven fluid pentane layers, each having the same optical thickness. Analysis of the neutron diffraction pattern of a pentane monolayer at a temperature of 130 K is consistent with small clusters having a rectangular-centered structure and an area per molecule of approximately 37 A(2) in coexistence with a fluid monolayer phase. Assuming values of the polarizability tensor from the literature and that the monolayer fluid has the same areal density as that inferred for the coexisting clusters, we calculate an optical thickness of the fluid pentane layers in reasonable agreement with that measured by ellipsometry. We discuss how these results support the previously proposed "footprint reduction" mechanism of alkane monolayer melting. In the hypercritical regime, we show that the layering behavior is consistent with the two-dimensional Ising model and determine the critical temperatures for layers n = 2-5.