Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 2 de 2
Filtrar
Mais filtros










Base de dados
Intervalo de ano de publicação
1.
Rev Sci Instrum ; 82(5): 053503, 2011 May.
Artigo em Inglês | MEDLINE | ID: mdl-21639500

RESUMO

A technique is presented for determining the radial location of the rotating magnetic islands in the STOR-M tokamak by use of soft x-ray (SXR) detector arrays. The location is determined by examining the difference in the integrated SXR emission intensities through two adjacent lines of sight. A model for calculating dependence of the line integrated SXR emission intensity on the radius, the mode numbers and the magnetic island geometry, has been developed. The SXR difference signal shows phase inversion when the impact parameter of the line of sight sweeps across the magnetic islands. Experimentally, the difference SXR signals significantly reduce noise and suppress the influence of background plasma fluctuations through common mode rejection when a dominant mode exists in the STOR-M tokamak. The radial locations of the m = 2 magnetic islands have been determined under several experimental conditions in the STOR-M discharges. With the decrease in the tokamak discharge current and thus the increase of the safety factor at the edge, the radial location of the m = 2 magnetic islands has been found to move radially inward.

2.
Rev Sci Instrum ; 79(10): 10E926, 2008 Oct.
Artigo em Inglês | MEDLINE | ID: mdl-19044581

RESUMO

Two miniature pinhole camera arrays for spatially and temporally resolved measurements of soft x-ray emission have been designed and installed on the STOR-M tokamak. Each array consists of a photodiode array, with one array viewing vertically and one viewing horizontally through a plasma cross section. Preamplifiers with fixed gains of 10(5) VA and custom built amplifiers with variable gains are used for signal amplification. Digitizers with 14 bit resolution and 3 MSs sampling rate are used for data acquisition. In the initial operation, an Al foil with a thickness of 1.8 microm installed for one array and Be filter of 7.6 microm installed for the other array are used to test signal strength. Initial tests have identified sawtooth oscillations and 20 kHz fluctuations, which are also detected by Mirnov coils, superimposed on the sawtooth oscillations.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA
...