A Distributed Clustering Algorithm Guided by the Base Station to Extend the Lifetime of Wireless Sensor Networks.

Clustering algorithms are necessary in Wireless Sensor Networks to reduce the energy consumption of the overall nodes. The decision of which nodes are the cluster heads (CHs) greatly affects the network performance. The centralized clustering algorithms rely on a sink or Base Station (BS) to select the CHs. To do so, the BS requires extensive data from the nodes, which sometimes need complex hardware inside each node or a significant number of control messages. Alternatively, the nodes in distributed clustering algorithms decide about which the CHs are by exchanging information among themselves. Both centralized and distributed clustering algorithms usually alternate the nodes playing the role of the CHs to dynamically balance the energy consumption among all the nodes in the network. This paper presents a distributed approach to form the clusters dynamically, but it is occasionally supported by the Base Station. In particular, the Base Station sends three messages during the network lifetime to reconfigure the s k i p value of the network. The s k i p , which stands out as the number of rounds in which the same CHs are kept, is adapted to the network status in this way. At the beginning of each group of rounds, the nodes decide about their convenience to become a CH according to a fuzzy-logic system. As a novelty, the fuzzy controller is as a Tagaki-Sugeno-Kang model and not a Mandami-one as other previous proposals. The clustering algorithm has been tested in a wide set of scenarios, and it has been compared with other representative centralized and distributed fuzzy-logic based algorithms. The simulation results demonstrate that the proposed clustering method is able to extend the network operability.

A New Centralized Clustering Algorithm for Wireless Sensor Networks.

Clustering is presently one of the main routing techniques employed in randomly deployed wireless sensor networks. This paper describes a novel centralized unequal clustering method for wireless sensor networks. The goals of the algorithm are to prolong the network lifetime and increase the reliability of the network while not compromising the data transmission. In the proposed method, the Base Station decides on the cluster heads according to the best scores obtained from a Type-2 Fuzzy system. The input parameters of the fuzzy system are estimated by the base station or gathered from the network with a careful design that reduces the control message exchange. The whole network is controlled by the base station in a rounds-based schedule that alternates rounds when the base station elects cluster heads, with other rounds in which the cluster heads previously elected, gather data from their contributing nodes and forward them to the base station. The setting of the number of rounds in which the Base Station keeps the same set of cluster heads is another contribution of the present paper. The results show significant improvements achieved by the proposal when compared to other current clustering methods.

Promoting wired links in wireless mesh networks: an efficient engineering solution.

Wireless Mesh Networks (WMNs) cannot completely guarantee good performance of traffic sources such as video streaming. To improve the network performance, this study proposes an efficient engineering solution named Wireless-to-Ethernet-Mesh-Portal-Passageway (WEMPP) that allows effective use of wired communication in WMNs. WEMPP permits transmitting data through wired and stable paths even when the destination is in the same network as the source (Intra-traffic). Tested with four popular routing protocols (Optimized Link State Routing or OLSR as a proactive protocol, Dynamic MANET On-demand or DYMO as a reactive protocol, DYMO with spanning tree ability and HWMP), WEMPP considerably decreases the end-to-end delay, jitter, contentions and interferences on nodes, even when the network size or density varies. WEMPP is also cost-effective and increases the network throughput. Moreover, in contrast to solutions proposed by previous studies, WEMPP is easily implemented by modifying the firmware of the actual Ethernet hardware without altering the routing protocols and/or the functionality of the IP/MAC/Upper layers. In fact, there is no need for modifying the functionalities of other mesh components in order to work with WEMPPs. The results of this study show that WEMPP significantly increases the performance of all routing protocols, thus leading to better video quality on nodes.