Conformal breast irradiation with the arm of the affected side parallel to the body.

PURPOSE: To propose a simple, forward-planned three-dimensional conformal radiotherapy (3D-CRT) technique for breast cancer patients with frozen shoulder. MATERIALS AND METHODS: A technique is described that avoids lateral beams transmitting through the arm of the affected side. One medial, tangentially applied beam deposits most of the dose. Further beams with little weight are used to attain dose homogeneity. In order to quantify dose distribution and homogeneity in the planning target volume (PTV), as well as the scattered dose in organs at risk (OAR), the parameters D95, D5, D1, mean and median dose were determined for the individual volumes. Intensity-modulated radiotherapy (IMRT) and volumetric modulated arc therapy (VMAT) plans were created in order to compare these with the proposed technique. RESULTS: The described technique achieved homogenous dose deposition within the PTV. A regimen comprising 25 fractions of 2 Gy prescribed to the PTV resulted in the following dose parameters: PTV(D95): 44.3 Gy, PTV(D5): 52.7 Gy, PTV(D1): 54.8 Gy, PTV(mean): 49.3 Gy and PTV(median): 49.9 Gy. Mean lung dose was 7.0 Gy. The ipsilateral lung received a mean dose of 9.9 Gy. This plan was accepted for treatment. The IMRT and VMAT plans achieved a similar dose distribution in the PTV. These techniques also reduced dose deposition in the OAR. CONCLUSION: The proposed 3D-CRT technique allows treatment of breast cancer patients who are not able to raise their arms above their head. Homogenous dose distribution in the PTV was achieved while avoiding lateral beams that transmit through the arm of the affected side. Mean lung dose was comparable to that of the conventional technique using opposed tangential beams. IMRT and VMAT also provide good target dose homogeneity with good sparing of OAR. However, these techniques are more demanding in terms of planning and quality assurance.

Influence of dental materials on dental MRI.

OBJECTIVES: To investigate the potential influence of standard dental materials on dental MRI (dMRI) by estimating the magnetic susceptibility with the help of the MRI-based geometric distortion method and to classify the materials from the standpoint of dMRI. METHODS: A series of standard dental materials was studied on a 1.5 T MRI system using spin echo and gradient echo pulse sequences and their magnetic susceptibility was estimated using the geometric method. Measurements on samples of dental materials were supported by in vivo examples obtained in dedicated dMRI procedures. RESULTS: The tested materials showed a range of distortion degrees. The following materials were classified as fully compatible materials that can be present even in the tooth of interest: the resin-based sealer AH Plus(®) (Dentsply, Maillefer, Germany), glass ionomer cement, gutta-percha, zirconium dioxide and composites from one of the tested manufacturers. Interestingly, composites provided by the other manufacturer caused relatively strong distortions and were therefore classified as compatible I, along with amalgam, gold alloy, gold-ceramic crowns, titanium alloy and NiTi orthodontic wires. Materials, the magnetic susceptibility of which differed from that of water by more than 200 ppm, were classified as non-compatible materials that should not be present in the patient's mouth for any dMRI applications. They included stainless steel orthodontic appliances and CoCr. CONCLUSIONS: A classification of the materials that complies with the standard grouping of materials according to their magnetic susceptibility was proposed and adopted for the purposes of dMRI. The proposed classification can serve as a guideline in future dMRI research.