Crystal structure refinement, low- and high-temperature X-ray diffraction and Mössbauer spectroscopy study of the oxoborate ludwigite from the Iten'yurginskoe deposit.

This paper reports an investigation of the chemistry, crystal structure refinement and thermal behavior (80-1650 K) of ludwigite from the Iten'yurginskoe deposit (Eastern Chukotka, Russia). Its chemical composition was determined by electron microprobe analysis, giving an empirical formula (Mg1.70Fe2+0.29Mn0.01)Σ2.00(Fe3+0.90Al0.08Mg0.02)Σ1.00O2(BO3). A refinement of the crystal structure from single-crystal X-ray diffraction data (SCXRD) was provided for the first time for ludwigite from this deposit (R = 0.047). The structure can be described as a framework composed of [MO6]n- octahedra and isolated [BO3]3- triangles located in triangular interstices of the framework. Based on a comprehensive analysis of SCXRD and Mössbauer spectroscopy data, the M1 site is occupied by Mg, M2 and M3 by Mg and Fe2+, M4 by Fe3+, Mg and Al. There are also oxo-centered [O4M4]n+ and [O2M5]n+ polyhedra building up a framework with the [BO3]3- triangles located in its hexagonal interstices. No indications of magnetic ordering are found in the temperature range investigated. The Fe2+ → Fe3+ oxidation occurs above 600 K, and is accompanied by a decrease of the unit-cell parameters and subsequent incomplete solid-phase decomposition with the formation of hematite, warwickite and magnetite. The mineral melts at temperatures above 1582 K. The thermal expansion of ludwigite is slightly anisotropic, which is explained by a dense packing of the [MO6]n- octahedra as well as a virtually perpendicular orientation of the oxo-centered double chains to each other. At room temperature, maximum expansion is along the c axis (αc = 9.1 × 10-6 K-1) and minimum expansion is in the ab plane (αa = 8.6 × 10-6, αb = 7.6 × 10-6 K-1), which is due to the preferred orientation of the [BO3]3- triangles. A comparison of the thermal behavior of three oxoborates of the ludwigite group, namely azoproite (Mg,Fe2+)2(Fe3+,Ti,Mg,Al)O2(BO3), vonsenite (Fe2+,Mg)2(Fe3+,Mn2+,Sn,Al)O2(BO3) and ludwigite (Mg,Fe2+,Mn)2(Fe3+,Al,Mg)O2(BO3), is provided.

The Phosphinate Group in the Formation of 2D Coordination Polymer with Sm(III) Nodes: X-ray Structural, Electrochemical and Mössbauer Study.

A coordination polymer has been synthesized using ferrocene-based ligand-bearing phosphinic groups of 1,1'-ferrocene-diyl-bis(H-phosphinic acid)), and samarium (III). The coordination polymer's structure was studied by both single-crystal and powder XRD, TG, IR, and Raman analyses. For the first time, the Mössbauer effect studies were performed on ferrocenyl phosphinate and the polymer based on it. Additionally, the obtained polymer was studied by the method of cyclic and differential pulse voltammetry. It is shown that it has the most positive potential known among ferrocenyl phosphinate-based coordination polymers and metal-organic frameworks. Using the values of the oxidation potential, the polymer was oxidized and the ESR method verified the oxidized Fe(III) form in the solid state. Additionally, the effect of the size of the phosphorus atom substituent of the phosphinate group on the dimension of the resulting coordination compounds is shown.

Investigation of thermal behavior of mixed-valent iron borates vonsenite and hulsite containing [OM4]n+ and [OM5]n+ oxocentred polyhedra by in situ high-temperature Mössbauer spectroscopy, X-ray diffraction and thermal analysis.

The investigation of elemental composition, crystal structure and thermal behavior of vonsenite and hulsite from the Titovskoe boron deposit in Russia is reported. The structures of the borates are described in terms of cation-centered and oxocentred polyhedra. There are different sequences of double chains and layers consisting of oxocentred [OM4]n+ tetrahedra and [OM5]n+ tetragonal pyramids forming a framework. Elemental composition was determined by energy-dispersive X-ray spectroscopy (EDX). Oxidation states and coordination sites of iron and tin in the oxoborates are determined using Mössbauer spectroscopy and compared with EDX and X-ray diffraction data (XRD). According to results obtained from high-temperature Mössbauer spectroscopy, the Fe2+ to Fe3+ oxidation in vonsenite and hulsite occurs at approximately 500 and 600 K, respectively. According to the high-temperature XRD data, this process is accompanied by an assumed deformation of crystal structures and subsequent solid-phase decomposition to hematite and warwickite. It is seen as a monotonic decrease of volume thermal expansion coefficients with an increase in temperature. A partial magnetic ordering in hulsite is observed for the first time with Tc ≃ 383 K. Near this temperature, an unusual change of thermal expansion coefficients is revealed. Vonsenite starts to melt at 1571 K and hulsite melts at 1504 K. Eigenvalues of thermal expansion tensor are calculated for the oxoborates as well as anisotropy of the expansion is described in comparison with their crystal structures.

γ-Iron Phase Stabilized at Room Temperature by Thermally Processed Graphene Oxide.

Stabilizing nanoparticles on surfaces, such as graphene, is a growing field of research. Thereby, iron particle stabilization on carbon materials is attractive and finds applications in charge-storage devices, catalysis, and others. In this work, we describe the discovery of iron nanoparticles with the face-centered cubic structure that was postulated not to exist at ambient conditions. In bulk, the γ-iron phase is formed only above 917 °C, and transforms back to the thermodynamically favored α-phase upon cooling. Here, with X-ray diffraction and Mössbauer spectroscopy we unambiguously demonstrate the unexpected room-temperature stability of the γ-phase of iron in the form of the austenitic nanoparticles with low carbon content from 0.60% through 0.93%. The nanoparticles have controllable diameter range from 30 nm through 200 nm. They are stabilized by a layer of Fe/C solid solution on the surface, serving as the buffer controlling carbon content in the core, and by a few-layer graphene as an outermost shell.

Towards a revisitation of vesuvianite-group nomenclature: the crystal structure of Ti-rich vesuvianite from Alchuri, Shigar Valley, Pakistan.

Vesuvianite containing 5.85 wt% TiO2 from an Alpine-cleft-type assemblage outcropped near Alchuri, Shigar Valley, Northern Areas, Pakistan, has been investigated by means of electron microprobe analyses, gas-chromatographic analysis of H2O, X-ray powder diffraction, single-crystal X-ray structure refinement, 27Al NMR, 57Fe Mössbauer spectroscopy, IR spectroscopy and optical measurements. Tetragonal unit-cell parameters are: a = 15.5326 (2), c = 11.8040 (2) Å, space group P4/nnc. The structure was refined to final R1 = 0.031, wR2 = 0.057 for 11247 I > 2σ(I). A general crystal-chemical formula of studied sample can be written as follows (Z = 2): [8-9](Ca17.1Na0.9) [8]Ca1.0[5](Fe2+0.44Fe3+0.34Mg0.22) [6](Al3.59Mg0.41) [6](Al4.03Ti2.20Fe3+1.37Fe2+0.40) (Si18O68) [(OH)5.84O2.83F1.33]. The octahedral site Y2 is Al-dominant and does not contain transition elements. Another octahedral site Y3 is also Al-dominant and contains Fe2+, Fe3+ and Ti. The site Y1 is split into Y1a and Y1b predominantly occupied by Fe2+ and Fe3+, respectively. The role of the Y1 site in the diversity of vesuvianite-group minerals is discussed.