Intercalation and reactions of CO under single layer graphene/Ni(111): the role of vacancies.

We use synchrotron radiation-induced core level photoemission spectroscopy to investigate the influence of vacancies, produced by ion bombardment, on monolayer graphene/Ni(111) exposed to CO at pressures ranging from ultra-high vacuum (10-10 mbar) up to near ambient (5.6 mbar) conditions. CO intercalates at a rate which is comparable to the one observed in absence of defects and reacts via the Boudouard reaction producing additional carbon atoms and CO2. While the former attach to the graphene layer and extend it over areas previously covered by carbide, the CO2 molecules bind to the graphene vacancies forming epoxy-like bonds across them, thus mending the defects. The so-formed complexes give rise to a peak at 533.4 eV which persists upon evacuating the vacuum chamber at room temperature and which we assign to a covalently bonded species containing C and O.

Adsorption of glutamic acid on clean and hydroxylated rutile TiO2(110): an XPS and NEXAFS investigation.

Due to its biocompatibility, TiO2is a relevant material for the study of bio-interfaces. Its electronic and chemical properties are influenced by defects, which mainly consist of oxygen vacancies or adsorbed OH groups and which affect, consequently, also the interaction with biological molecules. Here we report on an x-ray photoemission spectroscopy and near edge adsorption fine structure study of glutamic acid (Glu) adsorption on the rutile TiO2(110) surface, either clean or partially hydroxylated. We show that Glu anchors to the surface through a carboxylate group and that the final adsorption state is influenced by the presence of hydroxyl groups on the surface prior to Glu deposition. Indeed, molecules adsorb both in the anionic and in the zwitterionic form, the former species being favored on the hydroxylated substrate.

Morphological characterization and electronic properties of pristine and oxygen-exposed graphene nanoribbons on Ag(110).

Graphene nanoribbons (GNRs) are at the frontier of research on graphene materials since the 1D quantum confinement of electrons allows for the opening of an energy gap. GNRs of uniform and well-defined size and shape can be grown using the bottom-up approach, i.e. by surface assisted polymerization of aromatic hydrocarbons. Since the electronic properties of the nanostructures depend on their width and on their edge states, by careful choice of the precursor molecule it is possible to design GNRs with tailored properties. A key issue for their application in nanoelectronics is their stability under operative conditions. Here, we characterize pristine and oxygen-exposed 1.0 nm wide GNRs with a well-defined mixed edge-site sequence (two zig-zag and one armchair) synthesized on Ag(110) from 1,6-dibromo-pyrene precursors. The energy gap and the presence of quantum confined states are investigated by scanning tunneling spectroscopy. The effect of oxygen exposure under ultra-high vacuum conditions is inferred from scanning tunneling microscopy images and photoemission spectra. Our results demonstrate that oxygen exposure deeply affects the overall system by interacting both with the nanoribbons and with the substrate; this factor must be considered for supported GNRs under operative conditions.

Synthesis of corrugated C-based nanostructures by Br-corannulene oligomerization.

The structure and electronic properties of carbon-based nanostructures obtained by metal surface assisted synthesis is highly dependent on the nature of the precursor molecule. Here, we report on a combined scanning tunneling microscopy, soft X-ray spectroscopy and density functional theory investigation on the surface assisted polymerization of Br-corannulene at Ag(110) and on the possibility of building a mesh of π-conjugated polymers starting from buckyball shaped molecules. Indeed, the corannulene units form one-molecule-wide ribbons in which the natural concavity of the precursor molecule is maintained. These C-based nanostructures are corrugated and merge into a covalent network on the surface.

Adatom Extraction from Pristine Metal Terraces by Dissociative Oxygen Adsorption: Combined STM and Density Functional Theory Investigation of O/Ag(110).

The reconstruction and modification of metal surfaces upon O_{2} adsorption plays an important role in oxidation processes and in gauging their catalytic activity. Here, we show by employing scanning tunneling microscopy and the ab initio density functional theory that Ag atoms are extracted from pristine (110) terraces upon O_{2} dissociation, resulting in vacancies and in Ag-O complexes. The substrate roughening generates undercoordinated atoms and opens pathways to the Ag subsurface layer. With increasing O coverage, multiple vacancies give rise to remarkable structures. The mechanism is expected to be very general depending on the delicate interplay of energy and entropy, so that it may be active for other materials at different temperatures.

Morphology of monolayer MgO films on Ag(100): switching from corrugated islands to extended flat terraces.

The ability to engineer nearly perfect ultrathin oxide layers, up to the limit of monolayer thickness, is a key issue for nanotechnological applications. Here we face the difficult and important case of ultrathin MgO films on Ag(100), for which no extended and well-ordered layers could thus far be produced in the monolayer limit. We demonstrate that their final morphology depends not only on the usual growth parameters (crystal temperature, metal flux, and oxygen partial pressure), but also on aftergrowth treatments controlling so far neglected thermodynamics constraints. We thus succeed in tuning the shape of the oxide films from irregular, nanometer-sized, monolayer-thick islands to slightly larger, perfectly squared, bilayer islands, to extended monolayers limited apparently only by substrate steps.

Accretion disc origin of the Earth's water.

Earth's water is conventionally believed to be delivered by comets or wet asteroids after the Earth formed. However, their elemental and isotopic properties are inconsistent with those of the Earth. It was thus proposed that water was introduced by adsorption onto grains in the accretion disc prior to planetary growth, with bonding energies so high as to be stable under high-temperature conditions. Here, we show both by laboratory experiments and numerical simulations that water adsorbs dissociatively on the olivine {100} surface at the temperature (approx. 500-1500 K) and water pressure (approx. 10⁻8 bar) expected for the accretion disc, leaving an OH adlayer that is stable at least up to 900 K. This may result in the formation of many Earth oceans, provided that a viable mechanism to produce water from hydroxyl exists. This adsorption process must occur in all disc environments around young stars. The inevitable conclusion is that water should be prevalent on terrestrial planets in the habitable zone around other stars.

Unraveling the self-assembly of the (S)-glutamic acid "flower" structure on Ag(100).

(S)-Glutamic acid adsorbed on Ag(100) organizes in different self-assembled structures depending on surface temperature [Smerieri, M.; Vattuone, L.; Kravchuk, T.; Costa, D.; Savio, L. (S)-Glutamic Acid on Ag(100): Self-Assembly in the Nonzwitterionic Form. Langmuir2011, 27, 2393-2404]. In particular, two of these structures, referred to as "square" and "flower" geometries, are found to coexist on the surface upon deposition at T = 350 K. The former assembly was fully resolved at the atomic level in the work of Smerieri et al. [Smerieri, M.; Vattuone, L.; Costa, D.; Tielens, F.; Savio, L. Self-Assembly of (S)-Glutamic Acid on Ag(100): A Combined LT-STM and Ab Initio Investigation. Langmuir2010, 26, 7208-7215], in which we proved that the driving force for adsorption is the van der Waals interactions between the molecules and the Ag surface, that is, that molecules are in a physisorbed state. In this paper, we complete our work by presenting the characterization of the "flower" structure. In contrast to the case of the "square" assembly, a strong chemical bond between glutamic acid radicals and the surface is at the basis of the "flowers" geometry. Whereas the chemisorbed central GLU tetramer interacts strongly with the surface, the physisorbed surrounding GLU molecules conserve some degree of freedom in the layer which counterbalances the weak adsorption energy. The "flower" and the "square" assemblies have similar dispersion energy and H-bond interaction energy; as a consequence of the different chemical state of the GLU molecules, however, such contributions have a very different relative weight in the stabilization of the two structures.

The effect of step geometry in copper oxidation by hyperthermal O2 molecular beam: Cu(511) vs Cu(410).

Steps are known to be often the active sites for the dissociation of O(2) molecules and the nucleation sites of oxide films since they provide paths for subsurface migration and oxygen incorporation. In order to unravel the effect of their morphology on the oxidation of Cu surfaces, we present here a detailed investigation of the O(2) interaction with Cu(511) and compare it with previous results for Cu(410), a surface exhibiting terraces of similar size and geometry but different step morphology. As for Cu(410) we find, by x-ray photoemission spectroscopy performed with synchrotron radiation, that Cu(2)O formation gradually starts above half a monolayer oxygen coverage and that the ignition of oxidation can be lowered to room temperature by dosing O(2) via a supersonic molecular beam at hyperthermal energy. The oxidation rate for Cu(511) comes out to be lower than for Cu(410) at normal incidence, about the same when the O(2) molecules impinge towards the ascending step rise, but higher when they hit the surface along trajectories even slightly inclined towards the descending step rise. These findings can be rationalized by a collision induced absorption mechanism.

Ethene stabilization on Cu(111) by surface roughness.

The molecular vibrations of ethene adsorbed on roughened Cu(111) surfaces have been investigated with high resolution electron energy loss spectroscopy and density-functional-theory calculations. The roughness was introduced by sputtering or evaporation of copper, respectively, on the cooled surface. We found stabilization of the ethene layer compared to ethene adsorbed on pristine Cu(111). Furthermore, two new vibrational features observed on the rough surface can be assigned to frustrated translations and rotations of the ethene molecule on surface defects and are indicative of a different binding on the rough surface.

Selective production of reactive and nonreactive oxygen atoms on Pd(001) by rotationally aligned oxygen molecules.

Sticking together: The occupation of different sites by oxygen atoms that are produced by the dissociation of O(2) on Pd(100) is determined by the initial rotational alignment of the parent molecules. The atom locations are characterized by different chemical reactivities in the reaction with CO to form CO(2) (see picture), which are followed by synchrotron radiation (SR) experiments with a supersonic molecular beam (SMB).

Ethylene decomposition at undercoordinated sites on Cu(410).

We demonstrate the selective, low-temperature chemistry of ethylene on the strongly undercoordinated sites of Cu(410) by investigating its adsorption by high-resolution electron energy loss spectroscopy (HREELS), X-ray photoelectron spectroscopy (XPS), and temperature-programmed desorption (TPD). After dosing ethylene at approximately 110 K, apart from the expected pi-bonded species adsorbed on terraces, di-sigma-bonded ethylene and carbon are formed at the step edges. The latter product results from the complete dehydrogenation of ethylene and blocks sites for further dissociation and/or di-sigma-adsorption. However, these processes can be restored merely by heating the sample to 900 K, by causing the carbon to diffuse into the bulk. The presented results support the relevance of copper-based catalysts for the steam reforming process.

Carbon dioxide hydrogenation on Ni(110).

We demonstrate that the key step for the reaction of CO 2 with hydrogen on Ni(110) is a change of the activated molecule coordination to the metal surface. At 90 K, CO 2 is negatively charged and chemically bonded via the carbon atom. When the temperature is increased and H approaches, the H-CO 2 complex flips and binds to the surface through the two oxygen atoms, while H binds to the carbon atom, thus yielding formate. We provide the atomic-level description of this process by means of conventional ultrahigh vacuum surface science techniques combined with density functional theory calculations and corroborated by high pressure reactivity tests. Knowledge about the details of the mechanisms involved in this reaction can yield a deeper comprehension of heterogeneous catalytic organic synthesis processes involving carbon dioxide as a reactant. We show why on Ni the CO 2 hydrogenation barrier is remarkably smaller than that on the common Cu metal-based catalyst. Our results provide a possible interpretation of the observed high catalytic activity of NiCu alloys.

Low-energy acoustic plasmons at metal surfaces.

Nearly two-dimensional (2D) metallic systems formed in charge inversion layers and artificial layered materials permit the existence of low-energy collective excitations, called 2D plasmons, which are not found in a three-dimensional (3D) metal. These excitations have caused considerable interest because their low energy allows them to participate in many dynamical processes involving electrons and phonons, and because they might mediate the formation of Cooper pairs in high-transition-temperature superconductors. Metals often support electronic states that are confined to the surface, forming a nearly 2D electron-density layer. However, it was argued that these systems could not support low-energy collective excitations because they would be screened out by the underlying bulk electrons. Rather, metallic surfaces should support only conventional surface plasmons-higher-energy modes that depend only on the electron density. Surface plasmons have important applications in microscopy and sub-wavelength optics, but have no relevance to the low-energy dynamics. Here we show that, in contrast to expectations, a low-energy collective excitation mode can be found on bare metal surfaces. The mode has an acoustic (linear) dispersion, different to the dependence of a 2D plasmon, and was observed on Be(0001) using angle-resolved electron energy loss spectroscopy. First-principles calculations show that it is caused by the coexistence of a partially occupied quasi-2D surface-state band with the underlying 3D bulk electron continuum and also that the non-local character of the dielectric function prevents it from being screened out by the 3D states. The acoustic plasmon reported here has a very general character and should be present on many metal surfaces. Furthermore, its acoustic dispersion allows the confinement of light on small surface areas and in a broad frequency range, which is relevant for nano-optics and photonics applications.

High-resolution electron energy loss spectroscopy study of O-Cu(410).

We have investigated oxygen adsorption on Cu(410) by high-resolution electron energy loss spectroscopy, dosing O2 with a supersonic molecular beam at different surface temperatures and for different angles of incidence and beam energies or by backfilling. In the investigated crystal temperature range (127 < T < 570 K), adsorption is always dissociative. Depending on T, impact energy, and angle of incidence, the oxygen atoms end up in different adsorption configurations, characterized by different vibrational signatures. In particular, at grazing incidence when only the step edge is exposed to O2, the adatoms end up initially preferentially at the step edge. An ordered overlayer forms at half monolayer coverage when the adsorbate is mobile. Oxide patches develop eventually for large exposures performed by backfilling and at high crystal temperature.

New insights on the stereodynamics of ethylene adsorption on an oxygen-precovered silver surface.

The control of spatial orientation of molecules has a great influence on the stereodynamics of elementary processes occurring both in homogeneous and heterogeneous phases. Nonpolar molecules have so far escaped direct experimental investigations because of their poor sensitivity to several external constraints. Recently, it has been shown that the collisional alignment produced in supersonic expansions coupled with molecular-beam velocity selection can help solve such problems. Here we show that the sticking probability of ethylene, a nonpolar molecule prototypical of unsaturated hydrocarbons, on an O(2)-precovered Ag(001) surface is larger for molecules approaching in a helicopter-like motion than for those cartwheeling. A mechanism involving a weakly bound precursor state is suggested, with helicopter molecules having a lower chance of being scattered back into the gas phase than cartwheels when colliding with preadsorbed ethylene.