RESUMO
Following the initial cation formation, the synthesis of ionic liquids (ILs) often involves an anion-exchange or metathesis reaction. For hydrophobic ILs, this is generally performed through several cross-current contacts of the IL with a fresh salt solution of the desired anion. However, if a large number of contacts is required to attain an adequate conversion, this procedure is not economical because of the large excess of the reagent that is consumed. In this study, the metathesis of an IL, Aliquat 336 or [A336][Cl], to ILs with other anions ([A336][X] with X = HSO4 -, Br-, NO3 -, I-, and SCN-) was studied in a continuous counter-current mixer-settler setup. McCabe-Thiele diagrams were constructed to estimate the required number of stages for quantitative conversion. Significantly higher IL conversions were achieved, combined with reduced reagent consumption and waste production. This improvement in efficiency was most pronounced for anions placed low in the Hofmeister series, for example, HSO4 -, Br-, and NO3 -, which are difficult to exchange. The performance of the counter-current experiments was compared with the conventional multistep cross-current batch process by calculating the reaction mass efficiency (RME) and the environmental factor (E-factor). The RMEs of the cross-current experiments were notably smaller, that is, 38-78% of the values observed for the counter-current experiments. The E-factors of the counter-current experiments were a factor of 2.0-6.8 smaller than those of the cross-current experiments. These sustainability metrics indicate a highly efficient reagent use and a considerable, simultaneous decrease in waste production for the counter-current IL metathesis reactions.
RESUMO
The synthesis of ionic liquids (ILs) usually involves two steps: (i) quaternization of a precursor followed by (ii) a salt metathesis reaction to introduce the desired anion. A consequence of the second step is that most ILs still contain some amount of the initial anion, often chloride. In this work, wavelength dispersive X-ray fluorescence (WDXRF) spectrometry is presented for the direct measurement of chlorides in ILs. The WDXRF settings were optimized, and the system was calibrated for the detection of chloride in several analogues of the commercially available IL Aliquat 336, [A336][X] (with X = I-, Br-, NO3 -, or SCN-). The Cl Kα intensity showed excellent linearity for samples with a conversion >0.80 (approximately Cl < 8000 ppm). Synthetic quality control samples showed that the instrumental error and deviations induced by the calibration procedure were small with maximum values of 1 and 5%, respectively. Detection and quantification limits depended strongly on the matrix (i.e., anion system and dilution) but were relatively low: 42-191 and 127-578 ppm Cl, respectively. Compared with other analytical techniques used for this purpose, the strengths of WDXRF include its ease of use, rapid measurements, the near absence of sample preparation steps, and versatility in terms of anion systems and chloride concentration range.
