The Optoelectronic Properties of p-Type Cr-Deficient Cu[Cr0.95-xMg0.05]O2 Films Deposited by Reactive Magnetron Sputtering.

CuCrO2 is one of the most promising p-type transparent conductive oxide (TCO) materials. Its electrical properties can be considerably improved by Mg doping. In this work, Cr-deficient CuCrO2 thin films were deposited by reactive magnetron sputtering based on 5 at.% Mg doping. The influence of Cr deficiency on the film's optoelectronic properties was investigated. As the film's composition varied, CuO impurity phases appeared in the film. The mixed valency of Cu+/Cu2+ led to an enhancement of the hybridization between the Cu3d and O2p orbitals, which further reduced the localization of the holes by oxygen. As a result, the carrier concentration significantly improved. However, since the impurity phase of CuO introduced more grain boundaries in Cu[Cr0.95-xMg0.05]O2, impeding the transport of the carrier and incident light in the film, the carrier mobility and the film's transmittance reduced accordingly. In this work, the optimal optoelectronic performance is realized where the film's composition is Cu[Cr0.78Mg0.05]O2. Its Haacke's figure of merit is about 1.23 × 10-7 Ω-1.

Monte Carlo simulation of an anharmonic Debye-Waller factor to the T4 order.

In an increasing number of cases the harmonic approximation is incommensurate with the quality of Bragg diffraction data, while results of the anharmonic Debye-Waller factor are not typically available. This paper presents a Monte Carlo computation of a Taylor expansion of an anharmonic Debye-Waller factor with respect to temperature up to the fourth order, where the lattice was a face-centred cubic lattice and the atomic interaction was described by the Lennard-Jones potential. The anharmonic Debye-Waller factor was interpreted in terms of cumulants. The results revealed three significant points. Firstly, the leading term of anharmonicity had a negative contribution to the Debye-Waller factor, which was confirmed by Green's function method. Secondly, the fourth-order cumulants indicated a non-spherical probability density function. Thirdly, up to the melting point of two different densities, the cumulants up to the fourth order were well fitted by the Taylor expansion up to T4, which suggested that the Debye-Waller factor may be calculated by perturbation expansion up to the corresponding terms. In conclusion, Monte Carlo simulation is a useful approach for calculating the Debye-Waller factor.

Effect of Boric Acid Supplementation on the Expression of BDNF in African Ostrich Chick Brain.

The degree of brain development can be expressed by the levels of brain brain-derived neurotrophic factor (BDNF). BDNF plays an irreplaceable role in the process of neuronal development, protection, and restoration. The aim of the present study was to evaluate the effects of boric acid supplementation in water on the ostrich chick neuronal development. One-day-old healthy animals were supplemented with boron in drinking water at various concentrations, and the potential effects of boric acid on brain development were tested by a series of experiments. The histological changes in brain were observed by hematoxylin and eosin (HE) staining and Nissl staining. Expression of BDNF was analyzed by immunohistochemistry, quantitative real-time PCR (QRT-PCR), and enzyme linked immunosorbent assay (ELISA). Apoptosis was evaluated with Dutp-biotin nick end labeling (TUNEL) reaction, and caspase-3 was detected with QRT-PCR. The results were as follows: (1) under the light microscope, the neuron structure was well developed with abundance of neurites and intact cell morphology when animals were fed with less than 160 mg/L of boric acid (groups II, III, IV). Adversely, when boric acid doses were higher than 320 mg/L(groups V, VI), the high-dose boric acid neuron structure was damaged with less neurites, particularly at 640 mg/L; (2) the quantity of BDNF expression in groups II, III, and IV was increased while it was decreased in groups V and VI when compared with that in group I; (3) TUNEL reaction and the caspase-3 mRNA level showed that the amount of cell apoptosis in group II, group III, and group IV were decreased, but increased in group V and group VI significantly. These results indicated that appropriate supplementation of boric acid, especially at 160 mg/L, could promote ostrich chicks' brain development by promoting the BDNF expression and reducing cell apoptosis. Conversely, high dose of boric acid particularly in 640 mg/L would damage the neuron structure of ostrich chick brain by inhibiting the BDNF expression and increasing cell apoptosis. Taken together, the 160 mg/L boric acid supplementation may be the optimal dose for the brain development of ostrich chicks.

Diagnosing x-ray power and energy of tungsten wire array z-pinch with a flat spectral response x-ray diode.

Fast z-pinch is a very efficient way of converting electromagnetic energy to radiation. With an 8-10 MA current on primary test stand facility, about 1 MJ electromagnetic energy is delivered to vacuum chamber, which heats z-pinch plasma to radiate soft x-ray. To develop a pulsed high power x-ray source, we studied the applicability of diagnosing x-ray power from tungsten wire array z-pinch with a flat spectral response x-ray diode (FSR-XRD). The detector was originally developed to diagnose radiation of a hohlraum in SG-III prototype laser facility. It utilized a gold cathode XRD and a specially configured compound gold filter to yield a nearly flat spectral response in photon energy range of 0.1-4 keV. In practice, it was critical to avoid surface contamination of gold cathode. It is illustrated that an exposure of an XRD to multiple shots caused a significant change of response. Thus, in diagnosing x-ray power and energy, we used each XRD in only one shot after calibration. In a shot serial, output of FSR-XRD was compared with output of a nickel bolometer. In these shots, the outputs agreed with each other within their uncertainties which were about 12% for FSR-XRD and about 15% for bolometer. Moreover, the ratios between the FSR-XRD and the bolometer among different shots were explored. In 8 shots, the standard deviation of the ratio was 6%. It is comparable to XRD response change of 7%.