Strategies to improve the challenges of classic dispersive liquid-liquid microextraction for determination of the parabens in personal care products-One step closer to green analytical chemistry.

Gas flow-assisted dispersive liquid-phase microextraction based on deep eutectic solvent was used to determine parabens in personal care products such as mouthwash, lidocaine gel, aloe vera gel, and skin tonic. A homemade extraction device was innovated, in which by passing the stream of gas bubbles through the deep eutectic solvent a thin layer of the extraction phase is coated on the surface of the bubbles. The extraction is finally achieved when the bubbles are going up through the sample. The single-factor experiments and response surface methodology were applied to optimize the independent variables. The linear range of the method was 0.5 to 1000 µg L-1, the coefficient of determination for the goal analytes was higher than 0.9989, the instrumental limit of detections were in the range 0.2-0.3 µg L-1, and the instrumental limit of quantifications were in the range 0.5-1.1 µg L-1, the relative standard deviations were <5.2% for repeatability and <11.2% for intermediate precision, and the enrichment factors were 66 to 87 obtained under the optimized conditions. A spiking approach by means of standard material was used to estimate accuracy. The relative recoveries were in the range 95.8-105.2%. By using mentioned strategies, the organic waste and energy consumption reduced, toxic reagents replaced with safer ones, and operator safety enhanced. Accordingly, these benefits have been simultaneously attained and, the proposed method was one step closer to automation and sustainable analytical chemistry.

Experimental design in formulation optimization of vitamin K1 oxide-loaded nanoliposomes for skin delivery.

Due to the vitamin K1 sensitizing potential, the oxidized-isoform of vitamin K1 (vitamin K1 oxide, VKO), has been recently used for treating laser-induced purpura and hyperpigmentation in cosmetics. The objective of this study was to formulate VKO in nanoliposomes by using Box-Behnken experimental design to obtain an optimized formula with higher efficiency. The ratio of phospholipid to cholesterol (PC/CHO ratio), VKO concentration and sonication time in low, medium, and high levels were independent variables, while the percent of VKO entrapment efficiency (EE%) and vesicle size were selected as dependent variables. Optimum desirability was identified and an optimized formulation was prepared, characterized, and selected for in vitro VKO release and ex vivo skin permeation. The PC/CHO ratio showed the greatest effect on both responses (P < 0.0001). This effect was positive on EE%, while a negative effect was shown on vesicle size. The optimized formulation showed controlled drug release of 79.2% through a silicon membrane, and achieved flux of 327.36 ± 22.1 µg/cm2 through human skin after 24 h. So, nanoliposomes were proven as a suitable drug delivery system for topical delivery of VKO.

Ultrasensitive separation of methylprednisolone acetate using a photoresponsive molecularly imprinted polymer incorporated polyester dendrimer based on magnetic nanoparticles.

We developed an approach for the use of polyester dendrimer during the imprinting process to raise the number of recognized sites in the polymer matrix and improve its identification ability. Photoresponsive molecularly imprinted polymers were synthesized on modified magnetic nanoparticles involving polyester dendrimer which uses the reactivity between allyl glycidyl ether and acrylic acid for the high-yielding assembly by surface polymerization. The photoresponsive molecularly imprinted polymers were constructed using methylprednisoloneacetate as the template, water-soluble azobenzene involving 5-[(4, 3-(methacryloyloxy) phenyl) diazenyl] dihydroxy aniline as the novel functional monomer, and ethylene glycol dimethacrylate as the cross-linker. Through the evaluation of a series of features of spectroscopic and nano-structural, this sorbent showed excellent selective adsorption, recognition for the template, and provided a highly selective and sensitive strategy for determining the methylprednisoloneacetate in real and pharmaceutical samples. In addition, this sorbent according to good photo-responsive features and specific affinity to methylprednisoloneacetate with high recognition ability, represented higher binding capacity, a more extensive specific area, and faster mass transfer rate than its corresponding surface molecularly imprinted polymer.

Erratum to "Comparison between Different Extraction Methods for Determination of Primary Aromatic Amines in Food Simulant".

[This corrects the article DOI: 10.1155/2018/1651629.].

Comparison between Different Extraction Methods for Determination of Primary Aromatic Amines in Food Simulant.

The primary aromatic amines (PAAs) are food contaminants which may exist in packaged food. Polyurethane (PU) adhesives which are used in flexible packaging are the main source of PAAs. It is the unreacted diisocyanates which in fact migrate to foodstuff and then hydrolyze to PAAs. These PAAs include toluenediamines (TDAs) and methylenedianilines (MDAs), and the selected PAAs were 2,4-TDA, 2,6-TDA, 4,4'-MDA, 2,4'-MDA, and 2,2'-MDA. PAAs have genotoxic, carcinogenic, and allergenic effects. In this study, extraction methods were applied on a 3% acetic acid as food simulant which was spiked with the PAAs under study. Extraction methods were liquid-liquid extraction (LLE), dispersive liquid-liquid microextraction (DLLME), and solid-phase extraction (SPE) with C18 ec (octadecyl), HR-P (styrene/divinylbenzene), and SCX (strong cationic exchange) cartridges. Extracted samples were detected and analyzed by HPLC-UV. In comparison between methods, recovery rate of SCX cartridge showed the best adsorption, up to 91% for polar PAAs (TDAs and MDAs). The interested PAAs are polar and relatively soluble in water, so a cartridge with cationic exchange properties has the best absorption and consequently the best recoveries.

Determination of residual nonsteroidal anti-inflammatory drugs in aqueous sample using magnetic nanoparticles modified with cetyltrimethylammonium bromide by high performance liquid chromatography.

A simple and sensitive solid-phase extraction method for separation and preconcentration of trace amount of four nonsteroidal anti-inflammatory drugs (naproxen, indomethacin, diclofenac, and ibuprofen) using Fe3O4 magnetic nanoparticles modified with cetyltrimethylammonium bromide has been developed. For this purpose, the surface of MNPs was modified with cetyltrimethylammonium bromide (CTAB) as a cationic surfactant. Effects of different parameters influencing the extraction efficiency of drugs including the pH, amount of salt, shaking time, eluent type, the volume of solvent, amount of adsorbent, sample volume, and the time of desorption were investigated and optimized. Methanol has been used as desorption solvent and the extracts were analysed on a reversed-phase octadecyl silica column using 0.02 M phosphate-buffer (pH = 6.02) acetonitrile (65 : 35 v/v) as the mobile phase and the effluents were measured at 202 nm with ultraviolet detector. The relative standard deviation (RSD%) of the method was investigated at three concentrations (25, 50, and 200 ng/mL) and was in the range of 3.98-9.83% (n = 6) for 50 ng/mL. The calibration curves obtained for studied drugs show reasonable linearity (R (2) > 0.99) and the limit of detection (LODs) ranged between 2 and 7 ng/mL. Finally, the proposed method has been effectively employed in extraction and determination of the drugs in biological and environmental samples.

Analysis of chlorpheniramine in human urine samples using dispersive liquid-liquid microextraction combined with high-performance liquid chromatography

A simple and environmentally friendly microextraction technique was used for determination of chlorpheniramine (CPM), an antihistamine drug, in human urine samples using dispersive liquid-liquid microextraction (DLLME) followed by high performance liquid chromatography with diode array detection (HPLC-DAD). In this extraction technique, an appropriate mixture of acetonitrile (disperser solvent) and carbon tetrachloride (extraction solvent) was rapidly injected into the urine sample containing the target analyte. Tiny droplets of extractant were formed and dispersed into the sample solution and then sedimented at the bottom of the conical test tube by centrifugation. Under optimal conditions, the calibration curve was linear in the range of 0.055-5.5 µg mL-1, with a detection limit of 16.5 ng mL-1. This proposed method was successfully applied to the analysis of real urine samples. Low consumption of toxic organic solvents, simplicity of operation, low cost and acceptable figures of merit are the main advantages of the proposed technique.

Utilizou-se uma técnica de microextração simples e ambientalmente amigável para a determinação de clorfeniramina (CPM), anti-histamínico, em amostras de urina humana, utilizando a microextração dispersiva líquido-líquido (DLLME), seguida por cromatografia líquida de alta eficiência com detecção por arranjo de diodos (HPLC-DAD). Nesse método de extração, mistura apropriada de acetonitrila (solvente dispersor) e tetracloreto de carbono (solvente de extração) foi injetada rapidamente na amostra de urina contendo o analito alvo. As pequenas gotículas de agente de extração foram formadas e dispersas na solução da amostra e, em seguida, sedimentadas no fundo do tubo cônico de ensaio por centrifugação. Em condições ótimas, a curva de calibração foi linear no intervalo entre 0,055 e 5,5 µg mL-1, com limite de detecção de 16,5 ng mL-1. O método proposto foi aplicado com sucesso na análise de amostras de urina reais. Baixo consumo de solventes orgânicos tóxicos, simplicidade de operação, baixo custo e figuras de mérito aceitáveis são as principais vantagens do método sugerido.

Extraction and Determination of Cyproheptadine in Human Urine by DLLME-HPLC Method.

Novel dispersive liquid-liquid microextraction (DLLME), coupled with high performance liquid chromatography with photodiode array detection (HPLC-DAD) has been applied for the extraction and determination of cyproheptadine (CPH), an antihistamine, in human urine samples. In this method, 0.6 mL of acetonitrile (disperser solvent) containing 30 µL of carbon tetrachloride (extraction solvent) was rapidly injected by a syringe into 5 mL urine sample. After centrifugation, the sedimented phase containing enriched analyte was dissolved in acetonitrile and an aliquot of this solution injected into the HPLC system for analysis. Development of DLLME procedure includes optimization of some important parameters such as kind and volume of extraction and disperser solvent, pH and salt addition. The proposed method has good linearity in the range of 0.02-4.5 µg mL(-1) and low detection limit (13.1 ng mL(-1)). The repeatability of the method, expressed as relative standard deviation was 4.9% (n = 3). This method has also been applied to the analysis of real urine samples with satisfactory relative recoveries in the range of 91.6-101.0%.

Liquid phase microextraction-ion exchange-high performance thin layer chromatography for the preconcentration, separation, and determination of plasticizers in aqueous samples.

Liquid phase microextraction combined with ion-exchange-high performance thin layer chromatography has been developed for analysis of four plasticizers in aqueous samples. After their preconcentration by liquid phase microextraction, fast separation on thin layers of inorganic ion-exchanger stannic silicate has been developed using a mixture of toluene + ethyl acetate (10:1, v/v) as mobile phase. Consequently, densitometric quantitative determination of the plasticizers has been made at λ = 280 nm in reflection-absorption mode by Camag TLC scanner-3. The effects of type and volume of extraction solvent, stirring rate, extraction time, and ionic strength in the microextraction method have been also evaluated and optimized. The results show that the proposed method provides enhanced accuracy, linear range, LOD, and LOQ, and is very effective for analyzing the target compounds in water samples. Under the optimized conditions, preconcentration factor of 149-279 and extraction efficiency of 31-59% have been obtained. Repeatability (5.67-7.26%) and intermediate precision (6.21-8.17%) were in acceptable range. The relative recovery obtained for each analyte in different water samples was higher than 82.3% at three fortification levels with RSD <7.9%.