Modeling and Assessment of Afterglow Decay Curves from Thermally Stimulated Luminescence of Complex Garnets.

Afterglow is an important phenomenon in luminescent materials and can be desired (e.g., persistent phosphors) or undesired (e.g., scintillators). Understanding and predicting afterglow is often based on analysis of thermally stimulated luminescence (TSL) glow curves, assuming the presence of one or more discrete trap states. Here we present a new approach for the description of the time-dependent afterglow from TSL glow curves using a model with a distribution of trap depths. The method is based on the deconvolution of the energy dependent density of occupied traps derived from TSL glow curves using Tikhonov regularization. To test the validity of this new approach, the procedure is applied to experimental TSL and afterglow data for Lu1Gd2Ga3Al2O12:Ce ceramics codoped with 40 ppm of Yb3+ or Eu3+ traps. The experimentally measured afterglow curves are compared with simulations based on models with and without the continuous trap depth distribution. The analysis clearly demonstrates the presence of a distribution of trap depths and shows that the new approach gives a more accurate description of the experimentally observed afterglow. The new method will be especially useful in understanding and reducing undesired afterglow in scintillators.

Low-dose single acquisition rest (99m)Tc/stress (201)Tl myocardial perfusion SPECT protocol: phantom studies and clinical validation.

PURPOSE: We developed and tested a single acquisition rest (99m)Tc-sestamibi/stress (201)Tl dual isotope protocol (SDI) with the intention of improving the clinical workflow and patient comfort of myocardial perfusion single photon emission computed tomography (SPECT). METHODS: The technical feasibility of SDI was evaluated by a series of anthropomorphic phantom studies on a standard SPECT camera. The attenuation map was created by a moving transmission line source. Iterative reconstruction including attenuation correction, resolution recovery and Monte Carlo simulation of scatter was used for simultaneous reconstruction of dual tracer distribution. For clinical evaluation, patient studies were compared to stress (99m)Tc and rest (99m)Tc reference images acquired in a 2-day protocol. Clinical follow-up examinations like coronary angiography (CAG) and fractional flow reserve (FFR) were included in the assessment if available. RESULTS: Phantom studies demonstrated the technical feasibility of SDI. Artificial lesions inserted in the phantom mimicking ischaemia could be clearly identified. In 51/53 patients, the image quality was adequate for clinical evaluation. For the remaining two obese patients with body mass index > 32 the injected (201)Tl dose of 74 MBq was insufficient for clinical assessment. In answer to this the (201)Tl dose was adapted for obese patients in the rest of the study. In 31 patients, SDI and (99m)Tc reference images resulted in equivalent clinical assessment. Significant differences were found in 20 patients. In 18 of these 20 patients additional examinations were available. In 15 patients the diagnosis based on the SDI images was confirmed by the results of CAG or FFR. In these patients the SDI images were more accurate than the (99m)Tc reference study. In three patients minor ischaemic lesions were detected by SDI but were not confirmed by CAG. In one of these cases this was probably caused by pronounced apical thinning. For two patients no relevant clinical follow-up information was available for evaluation. CONCLUSION: The proposed SDI protocol has the potential to improve clinical workflow and patient comfort and suggests improved accuracy as demonstrated in the clinical feasibility study.

The image quality of FBP and MLEM reconstruction.

We have developed an image quality theory for filtered back-projection (FBP) and maximum likelihood expectation maximization (MLEM) based on quality measures like signal-to-noise ratio (SNR), contrast-to-noise ratio (CNR), signal and noise power spectra and the detective quantum efficiency (DQE) concept. Analytic expressions are derived for unattenuated SPECT reconstruction with ideal collimation to obtain the fundamental performance parameters of different reconstruction algorithms. This theory is verified by measurements of signal and noise power on simulated phantoms. We demonstrate that the noise power of reconstructed images is proportional to the diameter of the object given as a number of voxels. This is analytically proven for FBP and clarified by assessment of the convergence properties for MLEM. The latter technique is shown to be superior to FBP in terms of a noise level at least two times lower. The free choice of MLEM reconstruction parameters and correction for physical effects in the image acquisition enables quantitative evaluation of SPECT and PET images.