RESUMO
Biochar-based slow-release fertilizers (BSRFs) are vital for the development of eco-friendly and sustainable agriculture. Considerable attention has been given to enhancing the efficiency of fertilizers (EEFs) by appropriate modification or binding to reduce nutrient waste and improve the slow-release effect on the growth of plants. In this study, sustained binding materials were presented for BSRF synthesis, including pyroligneous acids (PA), bio-oil (BO), and modified starch binder (MSB). The results show that the release ratio of phosphorus from PA + BO+MSB was 4.7%, 15.2%, and 21.2% slower than that of PA, BO, and MSB alone, respectively. The BSRFs were characterized by SEM, XRD, FT-IR, XPS, and EDS, and the release kinetic outcome revealed that PA + BO+MSB contributed to the formation of a satisfactory structure in the BSRFs. The MSB viscosity significantly influences the slow-release performance and accumulation of N, P, and K nutrients. Moreover, economic assessments showed that PA + BO+MSB exhibited the lowest cost.
Assuntos
Fertilizantes , Pirólise , Fertilizantes/análise , Fósforo , Espectroscopia de Infravermelho com Transformada de Fourier , Amido/químicaRESUMO
A better understanding of the growth and interspecific competition of native dominant species under water stress should aid in prediction of succession in plant communities. In addition, such research would guide the selection of appropriate conservation and agricultural utilization of plants in semiarid environments that have not been very well characterized. Biomass production and allocation, relative competitive ability and water use efficiency of one C(4) herbaceous grass (Bothriochloa ischaemum) and one C(3) leguminous subshrub (Lespedeza davurica), both important species from the semiarid Loess Plateau of China, were investigated in a pot-cultivation experiment. The experiment was conducted using a replacement series design in which B. ischaemum and L. davurica were grown with twelve plants per pot, in seven combinations of the two species (12:0, 10:2, 8:4, 6:6, 4:8, 2:10, and 0:12). Three levels of water treatments included sufficient water supply (HW), moderate water stress (MW) and severe water stress (LW). These treatments were applied after seedling establishment and remained until the end of the experiment. Biomass production and its partitioning, and transpiration water use efficiency (TWUE) were determined at the end of the experiment. Interspecific competitive indices (competitive ratio (CR), aggressiveness (A) and relative yield total (RYT)) were calculated from the dry weight for shoots, roots and total biomass. Water stress decreased biomass production of both species in monoculture and mixture. The growth of L. davurica was restrained in their mixtures for each water treatment. L. davurica had significantly (P<0.05) greater root:shoot allocation than B. ischaemum for each water treatment and proportion within the replacement series. Aggressiveness (A) values for B. ischaemum with respect to L. davurica were negative only at the proportions of B. ischaemum to L. davurica being 8:4 and 10:2 in LW treatment. B. ischaemum had a significantly (P<0.05) higher CR value under each water treatment, and water stress considerably reduced its relative CR while increased that of L. davurica. RYT values of the two species indicated some degree of resource complimentarity under both water sufficient and deficit conditions. The results suggest that it is advantageous for growing the two species together to maximize biomass production, and the suggested ratio was 10:2 of B. ischaemum to L. davurica because of significantly higher (P<0.05) RYT and TWUE under low water availability condition.
Assuntos
Biomassa , Lespedeza/crescimento & desenvolvimento , Poaceae/crescimento & desenvolvimento , Água/fisiologia , Biocombustíveis , China , EcossistemaRESUMO
OBJECTIVE: To investigate the effect of autocontrol micromotion locking nail (AMLN) on experimental fracture healing and its mechanism. METHODS: 16 goats undergoing both sides of transverse osteotomy of the femoral shafts were fixed intramedullary with AMLN and Gross-Kempf (GK) nail, respectively. The follow-up time was 7, 14, 28 and 56 days. Roentgenographic, biomechanical, histological, scanning electromicroscopic and biochemical analyses were done. RESULTS: (1) The strength of anticompression, antiflexion and antitorsion in the fractural end in the AMLN-fixed group was higher than that of GK nail-fixed group; whereas, the rate of stress shelter in the fractured end decreased significantly (P<0.01). (2) The content of the total collagen, insoluble collagen, calcium and phosphate in the AMLN-fixed group was higher than that in the GK nail-fixed group (P<0.05). (3) Histological observation and quantitative analysis of calluses revealed that AMLN could promote the growth of bridge calluses and periosteum calluses. Hence the fracture healing and remolding process achieved early, which was much better than traditional GK nail fixation. (P<0.05). (4) 7-14 days postoperation, the calluses of AMLN-fixed group was flourish and camellarly arranged and the collagen fibril formed constantly in the absorption lacuna of bone trabecula. 28-56 days postoperation, the collagen fibril was flourish around the absorption lacuna and was parallel to the bone's longitudinal axis. Active bony absorption and formation were seen, so was remolding and rebuilding. Haversian system was intact and the bony structural net was very tenacious because of the deposition of calcium salt. None of the above findings was observed in the GK nail-fixed group. CONCLUSIONS: The design of AMLN accords well with the plastic fixation theory. As the geometry ametabolic system constituted by the intramedullary fixation instruments and the proximal and distal end of the fracture is very firm and stable, the disturbance to the physical stress distributed in the fractural end is light. The generation and conduct of the intermittent physical stress between the fractural parts could reach the balance between stress conduct and stress protection. The feature that the healing and remolding take place at the same time speeds up the fractural healing process.
Assuntos
Pinos Ortopédicos , Fraturas do Fêmur/cirurgia , Fixação Intramedular de Fraturas/instrumentação , Consolidação da Fratura/fisiologia , Animais , Fenômenos Biomecânicos , Cabras , Microscopia Eletrônica de Varredura , Estresse MecânicoRESUMO
OBJECTIVE: To search an ideal method for treatment of severe blepharoptosis. METHODS: Fifty-four eyes of 47 patients with severe blepharoptosis were undergoing for the treatment with a frontalis muscle complex flap, included in the frontalis muscle, orbicularis oculi muscle and SMAS membranes, to suspend the dropped eyelids. RESULTS: The 54 eyes with severe blepharoptosis were successfully treated with the frontalis muscle complex suspension technique. Although the lagophthalmos in different degrees was shown in 3 months after the operation, it usually disappeared 6 months after the operation. The results were shown good appearance without recurrence. CONCLUSION: The above mentioned technique may be a good and effective method for treatment of the severe blepharoptosis, compared with the traditional technique.