Multilevel synergically controlling wavefront correction of a high-power slab laser system.

We present a multilevel synergically controlling wavefront correction method that can apply in a slab laser system. To fully utilize the response frequency and the stroke of actuators of the single deformable mirror (DM), we design a set of multilevel wavefront correction devices to reduce the root-mean square of wavefront aberration before the DM. As the wavefront of slab geometry solid-state lasers mainly consists of fourth and longitudinally distributed aberration, such as 5th, 9th, and 14th orders of Legendre polynomials. We design a precompensating level of the aberration with a slow-drift mirror, fast-steer mirror, one-dimensional adjustable slab-aberration compensator, and beam-shaping system to reduce these orders of wavefront aberration with low spatial resolution and large stroke. As the controlling bandwidth of different devices is diverse, the coupling oscillation between the precompensating level and adaptive optics (AO) level occurs, then we develop the multilevel synergically control to address the coupling. With the precompensating level, the experimental result shows the residual wavefront aberration of the slab laser is compensated well by the AO level effectively within the compensating capability. We clean up a 9.8 kW slab laser system with the beam quality ß of far-field focus spots improved from 17.71 to 2.24 times the diffraction limit.

Excellent performance of a cryogenic Nd:YAlO3 laser with low wavefront distortion based on zero thermal expansion.

High-power solid-state lasers with good beam quality are attracting great attention on account of their important applications in industry and military. However, the thermal effects generated in the laser host materials seriously limit power scaling and degrade the beam quality. Thermal lensing and thermally induced wavefront deformation are the main causes of the beam quality deterioration. Here we investigate the performance of a zero thermal expansion (ZTE) solid-state laser gain material. In a proof-of-principle experiment, an ${a}$-cut rod ${\rm Nd}\!:\!{{\rm YAlO}_3}$ (Nd:YAP) perovskite crystal is chosen to be the gain medium for ZTE around 180 K. The laser performance spanning the temperature range from 80 to 290 K is studied. The maximum output power and minimum threshold pump power were obtained at a temperature of 180 K. Moreover, the measured thermal focal power and peak-to-valley value of the wavefront distortion also reach a minimum at this temperature, an additional benefit from the crystal's ZTE coefficient. We envisage that these results will open a new route towards the development of high-power and high-beam-quality lasers through the use of ZTE gain materials.

Adjustable slab-aberration compensator for high power slab laser.

An adjustable slab-aberration compensator (ASAC) with the ability to compensate the large magnitude inherent wavefront aberrations in the slab width direction is proposed and experimentally demonstrated. The ASAC has a size of 130mm×45mm (effective aperture of 75mm×28mm) and 11 actuators along the length with a contact spacing of 8 mm. The design is optimized by simulations in terms of the mirror's coupling coefficient with the contact areas, mechanical properties of the driving units, and the mirror thickness. The initial surface figure of the ASAC has PV and RMS values of 55 nm and 10 nm, and the dynamic range is 30 µm. In our experiments, a 20 kW Nd: YAG quasi-continuous wave (QCW) slab laser is further compensated by the ASAC system. The beam quality increases from 15× to 3.5× diffraction limit at 20 kW output after correction. Besides, the proposed ASAC can maintain the surface shape after power shutdown and have good thermal stability. The temperature rise of the ASAC is less than 7 °C in the 20 kW laser correction experiment.