Tribology. Mechanisms of antiwear tribofilm growth revealed in situ by single-asperity sliding contacts.

Zinc dialkyldithiophosphates (ZDDPs) form antiwear tribofilms at sliding interfaces and are widely used as additives in automotive lubricants. The mechanisms governing the tribofilm growth are not well understood, which limits the development of replacements that offer better performance and are less likely to degrade automobile catalytic converters over time. Using atomic force microscopy in ZDDP-containing lubricant base stock at elevated temperatures, we monitored the growth and properties of the tribofilms in situ in well-defined single-asperity sliding nanocontacts. Surface-based nucleation, growth, and thickness saturation of patchy tribofilms were observed. The growth rate increased exponentially with either applied compressive stress or temperature, consistent with a thermally activated, stress-assisted reaction rate model. Although some models rely on the presence of iron to catalyze tribofilm growth, the films grew regardless of the presence of iron on either the tip or substrate, highlighting the critical role of stress and thermal activation.

Viscoelastic property mapping with contact resonance force microscopy.

We demonstrate the accurate nanoscale mapping of near-surface loss and storage moduli on a polystyrene-polypropylene blend with contact resonance force microscopy (CR-FM). These viscoelastic properties are extracted from spatially resolved maps of the contact resonance frequency and quality factor of the AFM cantilever. We consider two methods of data acquisition: (i) discrete stepping between mapping points and (ii) continuous scanning. For point mapping and low-speed scanning, the values of the relative loss and storage modulus are in good agreement with the time-temperature superposition of low-frequency dynamic mechanical analysis measurements to the high frequencies probed by CR-FM.

Mapping nanoscale elasticity and dissipation using dual frequency contact resonance AFM.

We report on a technique that simultaneously quantifies the contact stiffness and dissipation of an AFM cantilever in contact with a surface, which can ultimately be used for quantitative nanomechanical characterization of surfaces. The method is based on measuring the contact resonance frequency using dual AC resonance tracking (DART), where the amplitude and phase of the cantilever response are monitored at two frequencies on either side of the contact resonance. By modelling the tip-sample contact as a driven damped harmonic oscillator, the four measured quantities (two amplitudes and two phases) allow the four model parameters, namely, drive amplitude, drive phase, resonance frequency and quality factor, to be calculated. These mechanical parameters can in turn be used to make quantitative statements about localized sample properties. We apply the method to study the electromechanical coupling coefficients in ferroelectric materials and the storage and loss moduli in viscoelastic materials.