RESUMO
The aim of this study was to obtain a series of activated carbon samples by the chemical activation of low-rank coal. The precursor was impregnated with a NaOH solution. Activated carbons were characterized by determining their textural parameters and content of surface oxygen functional groups and by using an elemental analysis. The carbons were tested as potential adsorbents for the removal of liquid pollutants represented by rhodamine B. The effectiveness of rhodamine B removal from water solutions depended on the initial concentration of the dye, the mass of rhodamine B, and the pH and temperature of the reaction. The isotherm examination followed the Langmuir isotherm model. The maximum adsorption capacity of the rhodamine B was 119 mg/g. The kinetic investigation favored the pseudo-second-order model, indicating a chemisorption mechanism. The thermodynamic assessment indicated spontaneous and endothermic adsorption, with decreased randomness at the solid-liquid interface. The experiment revealed that a 0.1 M HCl solution was the most effective regenerative agent.
RESUMO
The aim of the current study was to produce biocarbons through the activation of carbon dioxide with the extraction residues of the fungus Inonotus obliquus. To achieve this goal, a microwave oven was used to apply three different activation temperatures: 500, 600, and 700 °C. Low-temperature nitrogen adsorption/desorption was employed to determine the elemental composition, acid-base properties, and textural parameters of the resulting carbon adsorbents. Subsequently, the produced biocarbons were evaluated for their efficiency in removing malachite green and NO2. The adsorbent obtained by activation of the precursor in 700 °C had a specific surface area of 743 m2/g. In the aqueous malachite green solution, the highest measured sorption capacity was 176 mg/g. Conversely, under dry conditions, the sorption capacity for NO2 on this biocarbon was 21.4 mg/g, and under wet conditions, it was 40.9 mg/g. According to the experimental findings, surface biocarbons had equal-energy active sites that interacted with the dye molecules. A pseudo-second-order kinetics model yielded the most accurate results, indicating that the adsorption of malachite green was driven by chemisorption. Additionally, the study demonstrates a clear correlation between the adsorption capacity of the biocarbons and the pH level of the solution, as it increases proportionately.
RESUMO
The results of kinetic measurements revealed an accelerating effect of acetazolamide (ACT) on the multistep In(III) ions electroreduction in chlorates(VII) on a novel, cyclically renewable liquid silver amalgam film electrode (R-AgLAFE). The kinetic and thermodynamic parameters were determined by applying the DC polarography, square-wave (SWV) and cyclic voltammetry (CV), as well as electrochemical impedance spectroscopy (EIS). It was shown that ACT catalyzed the electrode reaction ("cap-pair" effect) by adsorbing on the surface of the R-AgLAFE electrode. The catalytic activity of ACT was explained as related to its ability to form active In(III)- acetazolamide complexes on the electrode surface, facilitating the electron transfer process. The active complexes constitute a substrate in the electroreduction process and their different structures and properties are responsible for differences in the catalytic activity. The determined values of the activation energy ΔH≠ point to the catalytic activity of ACT in the In(III) ions electroreduction process in chlorates(VII). Analysis of the standard entropy values ΔS0 confirm changes in the dynamics of the electrode process.
