Characteristics of gas from the fluidized bed gasification of refuse paper and plastic fuel (RPF) and wood biomass.

Energy recovery from small and medium scale waste thermal treatment facilities in the municipalities of Japan is challenging, owing to low power generation efficiency and high economic demands. Gas Engine (GE) generation is considered an efficient resource utilization method in these facilities. In this study, new and consistent feedstock, Refuse Paper and Plastic Fuel (RPF), and wood pellets were tested in an air-blown Fluidized Bed Gasifier (FBG) for syngas utilization in a GE. With temperatures ranging from 700 to 940 °C and varying Equivalence Ratios (ER) of 0.3-0.5, some of the most important product gas characteristics were analyzed, including the Lower Heating Value (LHV) and tar concentration levels. Gas composition results revealed that the concentration tendencies varied for the product gases CO, H2, and hydrocarbons, depending on the feedstock type, whereas the same tendencies were observed for CH4 and tar concentrations. Through the ER range, the LHV of product gas for RPF and wood pellets was 3.4-5.9 MJ/Nm3. Tar concentrations decreased to 2.5-14.0 g/Nm3-dry as the ER was raised. The optimal ER for LHV performance in GE generation was approximately 0.4 for RPF and wood pellets, and remaining tar concentrations were about 5.0 g/Nm3-dry at the gasifier exit.

Recycling Potentials of Precious Metals from End-of-Life Vehicle Parts by Selective Dismantling.

Recycling of some minor but essential scarce metals used in vehicles may serve as an important strategy to strengthen sustainable management of natural resources. Accordingly, this study focused on five precious metals (PMs): Au, Ag, Pt, Pd, and Rh, in both end-of-life conventional and next-generation vehicles. To explore their recycling potentials in Japan, we developed substance flow and scenario analyses based on estimations of PM contents per end-of-life vehicle (ELV) and ELV generations. The study predicts that in Japan, from 2015 to 2040, the content of PMs per ELV will range from 2 to 6 g, and the annual amount of PMs in ELVs will remain largely stable, at 14-15 t, but the proportions of PMs utilized in different vehicles, parts, and components will gradually change; in particular, increased proportions will occur in the printed wiring boards (PWBs) of next-generation vehicles. The results also show that, in Japan, totals of 33-53% of PMs in ELVs were recycled in 2015, and that by selective dismantling of PWBs and heating wires in the rear windows of ELVs, the recycling potentials of PMs could be optimally increased to a maximum of 62-83% by 2040.

Monitoring environmental burden reduction from household waste prevention.

In this study, the amount of prevented household waste in Kyoto city was quantified using three methods. Subsequently, the greenhouse gas (GHG) emission reduction by waste prevention was calculated in order to monitor the impact of waste prevention. The methods of quantification were "relative change from baseline year (a)," "absolute change from potential waste generation (b)," and "absolute amount of activities (c)." Method (a) was popular for measuring waste prevention, but method (b) was the original approach to determine the absolute amount of waste prevention by estimating the potential waste generation. Method (c) also provided the absolute value utilizing the information of activities. Methods (b) and (c) enable the evaluation of the waste prevention activities with a similar baseline for recycling. Methods (b) and (c) gave significantly higher GHG reductions than method (a) because of the difference in baseline between them. Therefore, setting a baseline is very important for evaluating waste prevention. In practice, when focusing on the monitoring of a specific policy or campaign, method (a) is an appropriate option. On the other hand, when comparing the total impact of waste prevention to that of recycling, methods (b) and (c) should be applied.

Life cycle assessment of hydrogenated biodiesel production from waste cooking oil using the catalytic cracking and hydrogenation method.

There is a worldwide trend towards stricter control of diesel exhaust emissions, however presently, there are technical impediments to the use of FAME (fatty acid methyl esters)-type biodiesel fuel (BDF). Although hydrogenated biodiesel (HBD) is anticipated as a new diesel fuel, the environmental performance of HBD and its utilization system have not been adequately clarified. Especially when waste cooking oil is used as feedstock, not only biofuel production but also the treatment of waste cooking oil is an important function for society. A life cycle assessment (LCA), including uncertainty analysis, was conducted to determine the environmental benefits (global warming, fossil fuel consumption, urban air pollution, and acidification) of HBD produced from waste cooking oil via catalytic cracking and hydrogenation, compared with fossil-derived diesel fuel or FAME-type BDF. Combined functional unit including "treatment of waste cooking oil" and "running diesel vehicle for household waste collection" was established in the context of Kyoto city, Japan. The calculation utilized characterization, damage, and integration factors identified by LIME2, which was based on an endpoint modeling method. The results show that if diesel vehicles that comply with the new Japanese long-term emissions gas standard are commonly used in the future, the benefit of FAME-type BDF will be relatively limited. Furthermore, the scenario that introduced HBD was most effective in reducing total environmental impact, meaning that a shift from FAME-type BDF to HBD would be more beneficial.

Greenhouse gas emissions from the treatment of household plastic containers and packaging: replacement with biomass-based materials.

The purpose of this study was to quantify the life-cycle greenhouse gas (GHG) emissions reduction that could be achieved by replacement of fossil-derived materials with biodegradable, biomass-based materials for household plastic containers and packaging, considering a variety of their treatment options. The biomass-based materials were 100% polylactide or a combination of polybutylene succinate adipate and polylactide. A scenario analysis was conducted considering alternative recycling methods. Five scenarios were considered: two for existing fossil-derived materials (the current approach in Japan) and the three for biomass-based materials. Production and waste disposal of 1 m(3) of plastic containers and packaging from households was defined as the functional unit. The results showed that replacement of fossil-derived materials with biomass-based materials could reduce life-cycle GHG emissions by 14-20%. Source separation and recycling should be promoted. When the separate collection ratio reached 100%, replacement with biomass-based materials could potentially reduce GHG emissions by 31.9%. Food containers are a priority for replacement, because they alone could reduce GHG emissions by 10%. A recycling system for biomass-based plastics must be carefully designed, considering aspects such as the transition period from fossil-derived plastics to biomass-based plastics.

Apoptosis and survivability of human dental pulp cells under exposure to Bis-GMA.

OBJECTIVE: In the present study, we examined whether 2, 2-bis [4-(2-hydroxy-3-methacryloxypropoxy) phenyl] propane (Bis-GMA) has effects on LSC2 cells, human dental pulp cell line. MATERIAL AND METHODS: The viability, cell cycle, and morphology of LSC2 cells were analyzed after exposure to several different concentrations of Bis-GMA. The recovery of viability of Bis-GMA exposed cells was also analyzed in the condition without Bis-GMA. Further, penetration of Bis-GMA to dentin disc was examined using isocratic high-performance liquid chromatography. RESULTS: There was a concentration-dependent decrease in cell proliferation and an increase in cell number in the sub-G1 population after exposure to Bis-GMA. Furthermore, the cells showed typical characteristics of apoptotic cells after the exposure to high concentration of Bis-GMA. In contrast, cells exposed to lower concentrations of Bis-GMA recovered their viability after being cultured without Bis-GMA. We also found that Bis-GMA is capable of penetrating 1-mm-thick dentin discs, though the penetrated concentration was lower than that showing cytotoxicity. CONCLUSION: These results suggest that Bis-GMA has cytotoxic effects, though dental pulp exposed to lower concentrations is able to recover their viability when Bis-GMA is removed.

Apoptosis and survivability of human dental pulp cells under exposure to Bis-GMA

OBJECTIVE: In the present study, we examined whether 2, 2-bis [4-(2-hydroxy-3-methacryloxypropoxy) phenyl] propane (Bis-GMA) has effects on LSC2 cells, human dental pulp cell line. MATERIAL AND METHODS: The viability, cell cycle, and morphology of LSC2 cells were analyzed after exposure to several different concentrations of Bis-GMA. The recovery of viability of Bis-GMA exposed cells was also analyzed in the condition without Bis-GMA. Further, penetration of Bis-GMA to dentin disc was examined using isocratic high-performance liquid chromatography. RESULTS: There was a concentration-dependent decrease in cell proliferation and an increase in cell number in the sub-G1 population after exposure to Bis-GMA. Furthermore, the cells showed typical characteristics of apoptotic cells after the exposure to high concentration of Bis-GMA. In contrast, cells exposed to lower concentrations of Bis-GMA recovered their viability after being cultured without Bis-GMA. We also found that Bis-GMA is capable of penetrating 1-mm-thick dentin discs, though the penetrated concentration was lower than that showing cytotoxicity. CONCLUSION: These results suggest that Bis-GMA has cytotoxic effects, though dental pulp exposed to lower concentrations is able to recover their viability when Bis-GMA is removed.

Effects of sequential exposure to lipopolysaccharide and heat stress on dental pulp cells.

In the present study, we examined the effects of sequential exposure to bacterial lipopolysaccharide (LPS) and heat stress on dental pulp cells. LPS induced the proliferation of pulp cells through the activation of p38 MAPK. HSP27 was expressed in cells with or without LPS during the entire period of heat stress, while transiently phosphorylated by short-term heat stress. In LPS-treated cells, short-term heat stress also induced the phosphorylation of HSF1. The immediate phosphorylation of HSF1 and HSP27 in LPS-treated cells by short-term heat stress occurred dependent on the activation of p38 MAPK. However, with long-term heat stress, the activation of HSF1 and induction of HSP27 occurred independent of p38 MAPK. Further, full activation of Akt in LPS-treated cells was immediately induced by short-term heat stress and lasted during the entire period of heat stress. IkappaB alpha was induced and phosphorylated throughout sequential exposure to LPS and heat stress. These results suggest that LPS has the unique effects on the cytoprotection and the cell death of pulp cells during heat stress through the modification and the activation of heat stress responsive molecules, HSF1 and HSP27, and cell survival molecules, Akt and NF-kappaB/IkappaB alpha.

Overexpression of cyclooxygenase-2 is associated with radioresistance in oral squamous cell carcinoma.

Cyclooxygenase-2 (COX-2), an inducible isoform of cyclooxygenase, is overexpressed in many types of malignant tumors, which in turn may stimulate tumor growth and protect against damage by irradiation or cytotoxic agents. The purpose of this study is to investigate the relationship between the radiation sensitivity and elevated level of COX-2. Radiation sensitivity of the eight oral SCC cell lines differed greatly in their response to radiation. Further, the level of the COX-2 expression correlated inversely with increased tumor radiation sensitivity. The similar significant association between the response to preoperative radiation therapy and COX-2 overexpression was observed in the oral SCC patients. In addition, treatment with a COX-2 selective inhibitor enhanced the radioresponse of HSC-2 cell, which constitutively expressed COX-2. These results suggested that COX-2 expression level correlates to radiation tolerance and the COX-2 selective inhibitor may be a potent enhancer for tumor radioresponse in oral SCC.

Gefitinib ('Iressa', ZD1839), an epidermal growth factor receptor tyrosine kinase inhibitor, up-regulates p27KIP1 and induces G1 arrest in oral squamous cell carcinoma cell lines.

High expression of epidermal growth factor receptor (EGFR) is frequently observed in many solid tumor types including oral squamous cell carcinomas (OSCC). Recently, the results of preclinical studies and early clinical trials targeting the EGFR have shown evidence of the activity. In this study, gefitinib ('Iressa', ZD1839), an EGFR-tyrosine kinase inhibitor, inhibited cell proliferation and upregulated p27KIP1 in OSCC cells. Growth inhibition was observed in OSCC xenografts when mice were treated with gefitinib in vivo. A flow cytometric analysis demonstrated that treatment with gefitinib induced accumulation in G1 phase, accompanied by a decrease in the percentage of cells in S phase. Apoptosis was not seen in this study. Cell growth was inhibited by an increase of the cell cycle inhibitor p27KIP1 and a decrease of its ubiquitin ligase subunit Skp2.

Enhancement of tumor radioresponse by combined treatment with gefitinib (Iressa, ZD1839), an epidermal growth factor receptor tyrosine kinase inhibitor, is accompanied by inhibition of DNA damage repair and cell growth in oral cancer.

Molecular blockade of EGFR with either an EGFR MAb or an EGFR TKI enhances the radiosensitivity of human SCCs. In the present study, we investigated whether treatment with the EGFR TKI gefitinib (Iressa, ZD1839) improves the response to radiotherapy in the OSCC cell lines HSC2 and HSC3. We examined potential mechanisms that may contribute to the enhanced radiation response induced by gefitinib. Growth inhibition was observed in vitro with radiation or gefitinib. A cooperative antiproliferative effect was obtained when cancer cells were treated with radiation followed by gefitinib. Cells treated with a combination of radiation and gefitinib arrested in G(1) and G(2)-M phases, with a decrease in the S-phase population. While radiation alone did not significantly affect MEK1/2 and p38 MAPK autophosphorylation, the combination of gefitinib and radiation completely inhibited the downstream signaling of EGFR. Results from DNA damage repair analysis in cultured OSCC cells demonstrated that gefitinib had a strong inhibitory effect on DNA-PKc pathways after radiation. Tumor xenograft studies demonstrated that the combination of gefitinib and radiation caused growth inhibition and tumor regression of well-established OSCC tumors in athymic mice; tumor volume was reduced from 1,008.2 to 231.4 mm(3) in HSC2 cells (p < 0.01) and from 284.2 to 12.4 mm(3) in HSC3 cells (p < 0.01). Immunohistochemical analysis of OSCC xenografts revealed that gefitinib caused a striking decrease in tumor cell proliferation when combined with radiotherapy. Overall, we conclude that gefitinib enhances tumor radioresponse by multiple mechanisms that may involve antiproliferative growth inhibition and effects on DNA repair after exposure to radiation.

[A case of mandibular gingival cancer (T4) responding to concurrent chemoradiotherapy with TS-1].

We report here a patient with advanced oral cancer in which concurrent chemoradiotherapy with TS-1 was performed. The patient was an 82-year-old male who had a 41 x 22 mm tumor mass around the left lower gingiva, whose X-ray showed a bone resorption image reaching the mandibular canal. We carried out concurrent chemoradiotherapy with TS-1. After 4 weeks, severe side effects, i.e., stomatitis and diarrhea, force us to discontinue the treatment. However, the tumor had begun to shrink from the 2nd week of treatment, and had clinically disappeared by the 8th week. The histopathological examination also indicated a complete response (CR). Thus, this treatment was very effective and may be useful for advanced cases.