RESUMO
Cellulose/graphene oxide composite membranes (CGCMs) were prepared using a vacuum-filtration method. The CGCMs were then used as filters to remove organic pollutants from wastewater. It was found that the CGCM filters could efficiently and simultaneously achieve wastewater treatment and adsorbent separation. Their adsorption of Rhodamine B (RhB, an organic dye) varied with varying cellulose/graphene oxide mass ratios. The CGCM obtained at a cellulose/graphene oxide mass ratio of 8:1 exhibited the maximum removal efficiency for RhB. The maximum adsorption capacity of the CGCMs for RhB was found to be 86.4 mg/g. In addition, the CGCMs were easily regenerated and the regenerated CGCMs retained good abilities to remove contaminants, which could be significant for their application in wastewater treatment.
RESUMO
Most polymers exhibit high flammability and poor degradability, which restrict their applications and causes serious environmental problem like "white pollution." Thus, titanate nanotubes (TNTs) were adopted to decorate graphene oxide (GO) by a facile solution method to afford TNTs/GO nanocomposites with potential in improving the flame retardancy and photodegradability of flexible polyvinyl chloride (PVC). Results show that the as-prepared TNTs/GO can effectively improve the thermal stability and flame retardancy than TNTs and GO, especially, the peak heat release rate and total heat release were reduced by 20 and 29% with only 2.5 wt.% loading. And more, the TNTs/GO also improve the photodegradability of PVC compared with the neat PVC. The reasons can be attributed to synergistic flame-retardant and photocatalytic effects between TNTs and GO. The present research could contribute to paving a feasible pathway to constructing polymer-matrix composites with desired flame retardancy and photodegradability, thereby adding to the elimination of white pollution caused by polymers.
RESUMO
A simple aqueous solution-immersion process was established to fabricate highly dense ordered Cu2O nanorods on commercial phosphor-copper mesh, with which the preparation was accomplished in distilled water. The present method, with the advantages of simple operation, low cost, short reaction time, and environmental friendliness, can be well adopted to fabricate desired Cu2O nanostructures on the phosphor-copper mesh under mild conditions. After surface modification with 1-dodecanethiol, the Cu2O nanostructure obtained on the phosphor-copper mesh exhibits excellent superhydrophobicity and superoleophilicity. Besides, a "mini boat" made from the as-prepared superhydrophobic phosphor-copper mesh can float freely on water surface and in situ collect oil from water surface. This demonstrates that the present approach, being facile, inexpensive, and environmentally friendly, could find promising application in oil-water separation and off shore oil spill cleanup.
