Anomalous polarization enhancement in a van der Waals ferroelectric material under pressure.

CuInP2S6 with robust room-temperature ferroelectricity has recently attracted much attention due to the spatial instability of its Cu cations and the van der Waals (vdW) layered structure. Herein, we report a significant enhancement of its remanent polarization by more than 50% from 4.06 to 6.36 µC cm-2 under a small pressure between 0.26 to 1.40 GPa. Comprehensive analysis suggests that even though the hydrostatic pressure suppresses the crystal distortion, it initially forces Cu cations to largely occupy the interlayer sites, causing the spontaneous polarization to increase. Under intermediate pressure, the condensation of Cu cations to the ground state and the polarization increase due cell volume reduction compensate each other, resulting in a constant polarization. Under high pressure, the migration of Cu cations to the center of the S octahedron dominates the polarization decrease. These findings improve our understanding of this fascinating vdW ferroelectric material, and suggest new ways to improve its properties.

Pressure-induced polymerization and bandgap-adjustment of TPEPA.

Organic solar cells have become an important development direction in solar cell materials because of their low cost, light weight, and good flexibility. However, the size of their bandgap is difficult to continuously regulate, resulting in a low power conversion efficiency. In this work, an organic molecule TPEPA was synthesized, and its luminescence performance and polymerization under high pressure were studied by performing in situ Raman, IR, fluorescence, and UV-vis spectroscopy. The Raman and IR spectroscopic results show that single bonds (C-H, C-Ph) and long chains (C-C[triple bond, length as m-dash]C-C) are more unstable and prone to amorphization under high pressure. At 10 GPa, the TPEPA molecule undergoes a transition of amorphization accompanied by a few polymerizations in the C[triple bond, length as m-dash]C bond structure. After holding pressure at 20 GPa for one day and releasing to ambient pressure, the other peaks almost disappeared, while the new peak of C(sp3)-H from the polymerization of the benzene ring was observed, indicating that the irreversible amorphization and polymerization did occur. UV-vis spectra results show that the bandgap is reduced from 2.9 eV to 1.3 eV, which is just in the maximum conversion efficiency bandgap range (1.3-1.4 eV) of p-n junction solar cell materials. This pressure is within the working pressure range of a large volume press, which is favorable in applications of large-scale synthesis. Our strategy may provide a method for the large-scale synthesis of novel organic solar cell materials.

Pressure-Induced Superconductivity in HgTe Single-Crystal Film.

HgTe film is widely used for quantum Hall well studies and devices, as it has unique properties, like band gap inversion, carrier-type switch, and topological evolution depending on the film thickness modulation near the so-called critical thickness (63.5 Å), while its counterpart bulk materials do not hold these nontrivial properties at ambient pressure. Here, much richer transport properties emerging in bulk HgTe crystal through pressure-tuning are reported. Not only the above-mentioned abnormal properties can be realized in a 400 nm thick bulk HgTe single crystal, but superconductivity is also discovered in a series of high-pressure phases. Combining crystal structure, electrical transport, and Hall coefficient measurements, a p-n carrier type switching is observed in the first high-pressure cinnabar phase. Superconductivity emerges after the semiconductor-to-metal transition at 3.9 GPa and persists up to 54 GPa, crossing four high-pressure phases with an increased upper critical field. Density functional theory calculations confirm that a surface-dominated topologic band structure contributes these exotic properties under high pressure. This discovery presents broad and efficient tuning effects by pressure on the lattice structure and electronic modulations compared to the thickness-dependent critical properties in 2D and 3D topologic insulators and semimetals.

Tuning of Optical Behavior in Monolayer and Bilayer Molybdenum Disulfide Using Hydrostatic Pressure.

Researchers have shown great interest in two-dimensional crystals recently, because of their thickness-dependent electronic and optical properties. We have investigated the Raman and photoluminescence spectra of free-standing monolayer and bilayer MoS2, as a function of pressure. As the enforcement of layer interaction, an electronic and a crystal phase transition were revealed at ∼6 GPa and ∼16 GPa, respectively, in bilayer MoS2, while no phase transition in the monolayer is observed. The electronic phase transition at ∼6 GPa is supposed to be a direct interband changing to an indirect Λ-K interband transition, and the new structure shown at ∼16 GPa is not metallized and supposed to be a transformation from stacking faults due to layer sliding like 2Hc to 2Ha. The different pressure-induced features of monolayer MoS2, compared with bilayer MoS2, can help to get a better understanding about the importance of interlayer interaction on modifying the optical properties of MoS2 and other fundamental understanding of 2D materials.