RESUMO
Active disturbance rejection control (ADRC) is widely used in airborne optoelectronic stabilization platforms due to its minimal reliance on the mathematical model of the controlled object. The extended state observer (ESO) is the core of ADRC, which treats internal parameter variations and external disturbances as total disturbances, observes the disturbances as extended states, and then compensates them into the control loop to eliminate their effects. However, the ESO can only achieve a precise estimation of constant or slowly varying disturbances. When the disturbance is periodically changing, satisfactory results cannot be obtained. In this paper, a generalized high-order extended state observer (GHOESO) is proposed to achieve the precise estimation of known frequency sinusoidal disturbance signals and improve disturbance suppression levels. Through numerical simulations, a traditional ESO and GHOESO are compared in terms of disturbance observation capability and disturbance suppression ability for single and compound disturbances based on our prior knowledge of disturbance frequency. The effectiveness of the proposed GHOESO method is verified. Finally, the algorithm is applied to an airborne optoelectronic stabilization platform for a 1°/1 Hz swing experiment on a space hexapod swing table. The experimental results demonstrate the superiority of the GHOESO proposed in this paper.
RESUMO
In this paper, a MIMO (Multi-Input Multi-Output) fuzzy sliding mode control method is proposed for a three-axis inertially stabilized platform. This method is based on the MIMO coupling model of the three-axis inertially stabilized platform in which the dynamic coupling among the three frames, namely the azimuth frame, the pitch frame and the roll frame, is fully considered. Firstly, the dynamic equation of the three-axis inertially stabilized platform is analyzed and its linearized model is obtained. After this, the controller is designed based on the model, during which fuzzy logic is introduced to deal with the frame coupling and the adaptive fuzzy coupling compensation factor is designed to be part of the algorithm. A complete proof of the stability and convergence is also provided in this paper. Finally, the performance of the platform with a MIMO fuzzy sliding mode controller and PI controller is analyzed. The simulation results show that the proposed scheme can guarantee tracking accuracy and effectively suppress the coupling interference between the three frames.
RESUMO
Torque ripples caused by cogging torque, flux harmonics, and current measurement error seriously restrict the application of a permanent magnet synchronous motor (PMSM), which has been paid more and more attention for the use in inertial stabilized platforms. Sliding mode control (SMC), in parallel with the classical proportional integral (PI) controller, has a high advantage to suppress the torque ripples as its invariance to disturbances. However, since the high switching gain tends to cause chattering and it requires derivative of signals which is not readily obtainable without an acceleration signal sensor. Therefore, this paper proposes a robust SMC scheme based on a rapid nonlinear tracking differentiator (NTD) and a disturbance observer (DOB) to further improve the performance of the SMC. The NTD is employed to providing the derivative of the signal, and the DOB is utilized to estimate the system lumped disturbances, including parameter variations and external disturbances. On the one hand, DOB can compensate the robust SMC speed controller, it can reduce the chattering of SMC on the other hand. Experiments were carried out on an ARM and DSP-based platform. The obtained experimental results demonstrate that the robust SMC scheme has an improved performance with inertia stability and it exhibits a satisfactory anti-disturbance performance compared to the traditional methods.
