RESUMO
Despite the progress made in Li-ion battery components, technology still faces major challenges. Among them, the development of novel electrolytes with promising characteristics is required for next-generation energy storage devices. In this work, rigid hybrid electrolytes have been prepared by infiltration of an ionic liquid solution (Pyr14TFSI) with a lithium salt (LiTFSI) into a sintered LATP ion-conducting porous ceramic. The porous ceramic 3D network was obtained via solid-state sintering of LATP powders mixed with a small amount of corn starch as pore former. A synergetic effect between the ionic liquid and support was evidenced. The resultant quasi-solid-state hybrid electrolytes exhibit high ionic conductivity (â¼10-3 S·cm-1 at 303 K), improved ion transfer number, tLi+, and a wide electrochemical window of 4.7-4.9 V vs Li+/Li. The LATP porosity plays a critical role in the free Li+ charge because it favors higher TFSI- confinement in the ceramic interfaces, which consequently positively influences tLi+ and ionic conductivity. Electrochemical tests conducted at room temperature for Li/LiFePO4 cells using the hybrid electrolyte exhibited a high capacity of 150 mAh·g-1LFP at C/30, and still retained 60 mAh·g-1LFP at 1 C, while bare LATP does not perform well at low temperatures. These findings highlight this hybrid electrolyte as a superior alternative to the ceramic LATP electrolyte and a safer option compared with conventional organic electrolytes.
RESUMO
New proton conducting membranes based on sulfonated polysulfone (sPSU) reinforced with TiO2(B) nanowires (1, 2, 5 and 10 wt.%) were synthesized and characterized. TiO2(B) nanowires were synthesized by means of a hydrothermal method by mixing TiO2 precursor in aqueous solution of NaOH as solvent. The presence of the TiO2(B) nanowires into the polymer were confirmed by means of Field Emission Scanning Electron Microscopy, Fourier transform infrared and X-ray diffraction. The thermal study showed an increase of almost 20 °C in the maximum temperature of sPSU backbone decomposition due to the presence of 10 wt.% TiO2(B) nanowires. Water uptake also is improved with the presence of hydrophilic TiO2(B) nanowires. Proton conductivity of sPSU with 10 wt.% TiO2(B) nanowires was 21 mS cm-1 (at 85 °C and 100% RH). Under these experimental conditions the power density was 350 mW cm-2 similar to the value obtained for Nafion 117. Considering all these obtained results, the composite membrane doped with 10 wt.% TiO2(B) nanowires is a promising candidate as proton exchange electrolyte in fuel cells (PEMFCs), especially those operating at high temperatures.
