Influence of temperature combined with photodynamic inactivation on the development of Aedes aegypti.

To reduce the speed of selection of populations resistant to chemical insecticides, photodynamic inactivation (PDI) against Aedes aegypti is a hot-topic and promising alternative technique to vector control. Temperature is an important factor in the survival of Ae. aegypti larvae and mosquitoes as it influences physiology, behavior, and ecology. This work aimed to evaluate parameters of the biological cycle of Ae. aegypti such as: hatching rate, larval development, adult mosquito longevity, sex ratio, weight, and lethal concentration of larval mortality (LC) through the combination of PDI with different temperatures. The number of larvae found after 48 h suggests that temperature affects hatching rate. Additionally, results showed a delay in development of surviving larvae after PDI when compared to control groups, and there was a reduction in the longevity of mosquitoes that undertook photodynamic action. PDI also led to a predominance of male insects, and observed weight indicates that the inactivation method may have also interfered in mosquito size. The results point to a satisfactory performance of PDI at all tested temperatures. Experimental conditions that were not lethal to all larvae implied that PDI impacts the mosquitoes' biological cycle. Though metabolism and development are improved at higher temperatures, so is PDI action, thus maintaining the net benefit. Therefore, it is assumed that the proposed photolarvicide can be useful in reducing arbovirus transmission, and results invite for future research in different abiotic conditions.

Bioactive Luminescent Silver Clusters Confined in Zeolites Enable Quick and Wash-Free Biosensing.

The simultaneous capture and detection of biomolecules is crucial for revolutionizing bioanalytical platforms in terms of portability, response time and cost-efficiency. Herein, we demonstrate how the sensitivity to external stimuli and changes in the local electronic environment of silver clusters lead to an advantageous biosensing platform based on the fluorometric response of bioactive luminescent silver clusters (BioLuSiC) confined in faujasite X zeolites functionalized with antibodies. The photoluminescence response of BioLuSiC was enhanced upon immunocomplex formation, empowering a wash-free and quick biodetection system offering optimal results from 5 min. Proteins and pathogens (immunoglobulin G and Escherichia coli) were targeted to demonstrate the biosensing performance of BioLuSiC, and a human serum titration assay was also established. BioLuSiC will pave the way for innovative bioanalytical platforms, including real-time monitoring systems, point-of-care devices and bioimaging techniques.

Photon spectra effects tested on the vegetal model Allium cepa.

The use of artificial light sources in plants is considered a type of photobiomodulation (PBM), a trend in agriculture and food industries, aiming at decontamination, pest control, and increased production yield. However, literature lacks a broader assessment to address the effects of photon light spectra on plant characteristics. Here, we aimed to describe the effects of visible light, infrared, and ultraviolet light upon Allium cepa, a known bioindicator, under various light doses. Samples irradiated under visible and infrared light did not show cytotoxicity, genotoxicity, or mutagenicity in any of the evaluated doses. Light induction at 460 and 635 nm significantly stimulated root development of the test organism. In contrast, 254 nm irradiation proved to be cytotoxic, genotoxic, and mutagenic. This work reveals and quantifies the spectral response of A. cepa seeds, suggesting that it can be proposed as a model for future research on mechanisms of PBM in plants.

Design of a Low-Cost Diffuse Optical Mammography System for Biomedical Image Processing in Breast Cancer Diagnosis.

Worldwide, breast cancer is the most common type of cancer that mainly affects women. Several diagnosis techniques based on optical instrumentation and image analysis have been developed, and these are commonly used in conjunction with conventional diagnostic devices such as mammographs, ultrasound, and magnetic resonance imaging of the breast. The cost of using these instruments is increasing, and developing countries, whose deaths indices due to breast cancer are high, cannot access conventional diagnostic methods and have even less access to newer techniques. Other studies, based on the analysis of images acquired by traditional methods, require high resolutions and knowledge of the origin of the captures in order to avoid errors. For this reason, the design of a low-cost diffuse optical mammography system for biomedical image processing in breast cancer diagnosis is presented. The system combines the acquisition of breast tissue photographs, diffuse optical reflectance (as a biophotonics technique), and the processing of digital images for the study and diagnosis of breast cancer. The system was developed in the form of a medical examination table with a 638 nm red-light source, using light-emitted diode technology (LED) and a low-cost web camera for the acquisition of breast tissue images. The system is automatic, and its control, through a graphical user interface (GUI), saves costs and allows for the subsequent analysis of images using a digital image-processing algorithm. The results obtained allow for the possibility of planning in vivo measurements. In addition, the acquisition of images every 30° around the breast tissue could be used in future research in order to perform a three-dimensional (3D) reconstruction and an analysis of the captures through deep learning techniques. These could be combined with virtual, augmented, or mixed reality environments to predict the position of tumors, increase the likelihood of a correct medical diagnosis, and develop a training system for specialists. Furthermore, the system allows for the possibility to develop analysis of optical characterization for new phantom studies in breast cancer diagnosis through bioimaging techniques.

How can biophotonics help dentistry to avoid or minimize cross infection by SARS-CoV-2?

Biophotonics is defined as the combination of biology and photonics (the physical science of the light). It is a general term for all techniques that deal with the interaction between biological tissues/cells and photons (light). Biophotonics offers a great variety of techniques that can facilitate the early detection of diseases and promote innovative theragnostic approaches. As the COVID-19 infection can be transmitted due to the face-to-face communication, droplets and aerosol inhalation and the exposure to saliva, blood, and other body fluids, as well as the handling of sharp instruments, dental practices are at increased risk of infection. In this paper, a literature review was performed to explore the application of Biophotonics approaches in Dentistry focusing on the COVID-19 pandemic and how they can contribute to avoid or minimize the risks of infection in a dental setting. For this, search-related papers were retrieved from PubMED, Scielo, Google Schoolar, and American Dental Association and Centers for Disease Control and Prevention databases. The body of evidence currently available showed that Biophotonics approaches can reduce microorganism load, decontaminate surfaces, air, tissues, and minimize the generation of aerosol and virus spreading by minimally invasive, time-saving, and alternative techniques in general. However, each clinical situation must be individually evaluated regarding the benefits and drawbacks of these approaches, but always pursuing less-invasive and less aerosol-generating procedures, especially during the COVID-19 pandemic.

A Very Bright Far-Red Bioluminescence Emitting Combination Based on Engineered Railroad Worm Luciferase and 6'-Amino-Analogs for Bioimaging Purposes.

Beetle luciferases produce bioluminescence (BL) colors ranging from green to red, having been extensively used for many bioanalytical purposes, including bioimaging of pathogen infections and metastasis proliferation in living animal models and cell culture. For bioimaging purposes in mammalian tissues, red bioluminescence is preferred, due to the lower self-absorption of light at longer wavelengths by hemoglobin, myoglobin and melanin. Red bioluminescence is naturally produced only by Phrixothrix hirtus railroad worm luciferase (PxRE), and by some engineered beetle luciferases. However, Far-Red (FR) and Near-Infrared (NIR) bioluminescence is best suited for bioimaging in mammalian tissues due to its higher penetrability. Although some FR and NIR emitting luciferin analogs have been already developed, they usually emit much lower bioluminescence activity when compared to the original luciferin-luciferases. Using site-directed mutagenesis of PxRE luciferase in combination with 6'-modified amino-luciferin analogs, we finally selected novel FR combinations displaying BL ranging from 636-655 nm. Among them, the combination of PxRE-R215K mutant with 6'-(1-pyrrolidinyl)luciferin proved to be the best combination, displaying the highest BL activity with a catalytic efficiency ~2.5 times higher than the combination with native firefly luciferin, producing the second most FR-shifted bioluminescence (650 nm), being several orders of magnitude brighter than commercial AkaLumine with firefly luciferase. Such combination also showed higher thermostability, slower BL decay time and better penetrability across bacterial cell membranes, resulting in ~3 times higher in vivo BL activity in bacterial cells than with firefly luciferin. Overall, this is the brightest FR emitting combination ever reported, and is very promising for bioimaging purposes in mammalian tissues.

Discovering new 3D bioprinting applications: Analyzing the case of optical tissue phantoms.

Optical tissue phantoms enable to mimic the optical properties of biological tissues for biomedical device calibration, new equipment validation, and clinical training for the detection, and treatment of diseases. Unfortunately, current methods for their development present some problems, such as a lack of repeatability in their optical properties. Where the use of three-dimensional (3D) printing or 3D bioprinting could address these issues. This paper aims to evaluate the use of this technology in the development of optical tissue phantoms. A competitive technology intelligence methodology was applied by analyzing Scopus, Web of Science, and patents from January 1, 2000, to July 31, 2018. The main trends regarding methods, materials, and uses, as well as predominant countries, institutions, and journals, were determined. The results revealed that, while 3D printing is already employed (in total, 108 scientific papers and 18 patent families were identified), 3D bioprinting is not yet applied for optical tissue phantoms. Nevertheless, it is expected to have significant growth. This research gives biomedical scientists a new window of opportunity for exploring the use of 3D bioprinting in a new area that may support testing of new equipment and development of techniques for the diagnosis and treatment of diseases.

Comparative Study of the Physiotherapeutic and Drug Protocol and Low-Level Laser Irradiation in the Treatment of Pain Associated with Temporomandibular Dysfunction.

BACKGROUND: The temporomandibular joint (TMJ) is a structure of the craniofacial complex affected by neurological diseases. Orthopedic and musculoskeletal changes can also cause temporomandibular disorders (TMD) and pain. Low-level laser (LLL) therapy has been studied in the treatment of temporomandibular jaw (TMJ) dysfunction, and controversial results were obtained. OBJECTIVE: The objective of this work was comparing the physiotherapeutic and drug protocol (PDP) to LLL therapy in the treatment of pain associated with TMD. METHODS: A sample of 60 female patients, 20-50 years of age, TMD triggering agents (stress, parafunctional habits) controlled, was randomly divided into three groups, group 1 (G1)-LLL (780 nm laser, dose of 35.0 J/cm2, for 20 sec, thrice a week, for 4 weeks); group 2 (G2)-PDP (hot packs thrice a day, morning, afternoon, and evening, for 15 min, exercise of opening and closing the mouth, twice a day, myorelaxing and anti-inflammatory drug administration); and group 3 (G3)-Placebo (450 nm halogen lamp, Max LD Gnatus, light curing unit). RESULTS: Patients were evaluated every return appointment for the presence (P) or absence (A) of pain for 4 weeks and results were statistically analyzed. First week: 60% of G1, 100% G2, and 70% of G3-related pain. Second week: 55% of G1, 15% of G2, and 100% of G3-related pain. Third week: 10% of G1, 15% of G2, and 85% of G3-related pain. Last week: 0% of G1, 0% of G2, and 100% of G3-related pain. CONCLUSIONS: Based on obtained data, we concluded that, compared to PDP, LLL treatment is effective to control pain associated with TMD.

The optical properties of mouse skin in the visible and near infrared spectral regions.

Visible and near-infrared radiation is now widely employed in health science and technology. Pre-clinical trials are still essential to allow appropriate translation of optical methods into clinical practice. Our results stress the importance of considering the mouse strain and gender when planning pre-clinical experiments that depend on light-skin interactions. Here, we evaluated the optical properties of depilated albino and pigmented mouse skin using reproducible methods to determine parameters that have wide applicability in biomedical optics. Light penetration depth (δ), absorption (µa), reduced scattering (µ's) and reduced attenuation (µ't) coefficients were calculated using the Kubelka-Munk model of photon transport and spectrophotometric measurements. Within a broad wavelength coverage (400-1400nm), the main optical tissue interactions of visible and near infrared radiation could be inferred. Histological analysis was performed to correlate the findings with tissue composition and structure. Disperse melanin granules present in depilated pigmented mouse skin were shown to be irrelevant for light absorption. Gender mostly affected optical properties in the visible range due to variations in blood and abundance of dense connective tissue. On the other hand, mouse strains could produce more variations in the hydration level of skin, leading to changes in absorption in the infrared spectral region. A spectral region of minimal light attenuation, commonly referred as the "optical window", was observed between 600 and 1350nm.