Separation of folinic acid diastereomers in capillary electrophoresis using a new cationic ß-cyclodextrin derivative.

A method for the separation of folinic acid diastereomers by capillary electrophoresis in chiral separation media was developed. Aiming to achieve a good separation of the anionic analytes, a newly synthesized cationic ß-cyclodextrin derivative, mono-6-deoxy-6-piperdine-ß-cyclodextrin, was applied as the chiral selector. The effect of background electrolyte pH, the concentration of the cyclodextrin additive, and organic modifier on the separation was investigated. A good separation of folinic acid diastereomers was obtained with 30 mmol/L phosphate buffer at pH 6.50 containing 6.0 mmol/L of mono-6-deoxy-6-piperdine-ß-cyclodextrin in 10% acetonitrile. Based on the capillary electrophoresis data, the binding constants of each diastereomer with mono-6-deoxy-6-piperdine-ß-cyclodextrin were determined. Moreover, a computational modeling study, using the semi-empirical PM3 method, was used to discuss the possible mechanism of separation of folinic acid with mono-6-deoxy-6-piperdine-ß-cyclodextrin.

Use of short chain alkyl imidazolium ionic liquids for on-line stacking and sweeping of methotrexate, flinic acid and folic acid: their application to biological fluids.

Methotrexate (MTX) is widely used for the treatment of many types of cancer. Folinic acid (FNA) and folic acid (FA) were usually simultaneously supplemented with MTX to reduce the side effects of a folate deficiency. This study, for the first time, included on-line sample preconcentration by stacking and sweeping techniques under reduced or enhanced electric conductivity in the sample region using short chain alkyl imidazolium ionic liquids (ILs) as micelle forming agents for analyte focusing. Both analyte focusing by micelle collapse (AFMC) and sweeping-MEKC had been investigated for the comparison of their effectiveness to examine simultaneously MTX, FNA and FA in plasma and urine under physiological conditions. In sweeping-MEKC, the sample solution without micelles was hydrodynamically injected as a long plug into a fused-silica capillary pre-filled with phosphate buffer containing 3.0 mol/L of 1-butyl-3-methylimidazolium bromide (BMIMBr). Using AFMC, the analytes were prepared in BMIMBr micellar matrix and hydrodynamically injected into the phosphate buffer without IL micelles. The conductivity ratio between BGE and sample (γ, BGE/sample) was optimized to be 3.0 in sweeping-MEKC and 0.33 in AFMC resulting the adequate separation of analytes within 4.0 min. To reduce the possibility of BMIMBr adsorption, an appropriate rinsing protocol was used. The limits of detection were calculated as 0.1 ng/mL MTX, 0.05 ng/mL FNA and 0.05 ng/mL FA by sweeping-MEKC and 0.5 ng/mL MTX, 0.3 ng/mL FNA and 0.3 ng/mL FA by AFMC. The accuracy was tested by recovery in plasma and urine matrices giving values ranging between 90 and 110%. Both stacking and sweeping by BMIMBr could be successfully used for the rapid, selective and sensitive determination of pharmaceuticals in complex matrices due to its fascinating properties, including high conductivity, good thermal stability and ability to form different types of interactions by electrostatic, hydrophobic, hydrogen bonding and π-π interactions. In sweeping-MEKC, the using of BMIMBr enhanced the γ factor, k retention factor and the injected amount of sample. Consequently, this technique offers particular potential for higher sensitivity by giving 22- and 5-fold sensitivity enhancement factors (SEFs) of MTX compared to CZE and AFMC, respectively.

[Study on synthesis and purification of calcium 5-formyltetrahydrofolate].

OBJECTIVE: To establish a new approach to synthesis and purification of calcium 5-formytetrahydrofolate. METHODS: Target compound was synthesized by the use of folic acid as starting material via reduction, formylation, hydrolysis and salt formation RESULTS: The structure of calcium 5-formytetrahydrofolate was confirmed by UV, 1H-NMR and elemental analysis and the overall yield was 54%-59%, 14%-17% higher than the reported yield. CONCLUSION: A convenient synthetic route was developed and it would be suitable for industrial production.

Applicability of alkyl-bonded ultra-pure silica stationary phases for gradient reversed-phase HPLC of folates with conventional and volatile buffers under highly aqueous conditions.

Applicability of several alkyl-bonded silica stationary phases was tested for gradient RP-HPLC of folates under highly aqueous conditions. High retention of folates was achieved on alternative phases with enhanced polarity and classical phases with higher carbon content. Phases exhibiting polar secondary interactions were found to provide better selectivity for late-eluting folates, whereas selectivity for early-eluting folates was mostly dependent on hydrophobic interactions. Best selectivity in phosphate buffered mobile phase was achieved on polar-endcapped silica phases (Aquasil C18 and HyPurity Aquastar) followed by alternative Atlantis dC18. Classical phases exhibited poorer separation of 10-formyl-folic acid and 5-formyl-tetrahydrofolate, but it could be considerably improved by increasing the buffer pH. Strong secondary interactions of ion-exchange character on polar-embedded phases resulted in marked peak deterioration, loss of recovery and dramatic changes in retention behaviour for early- and late-eluting folates when changing the mobile phase composition and pH. Therefore, polar-embedded phases such as HyPurity Advance were found to be unsuitable for separating folates. Stationary phases exhibited peak deterioration when using volatile buffer of low ionic strength. Better results were obtained with classical phases, whereas alternative phases showed not only peak deterioration but also a decrease in recovery and poorer selectivity due to increased secondary interactions in volatile buffer.

Capillary electrophoretic determination of methotrexate, leucovorin and folic acid in human urine.

A simple, rapid and sensitive procedure using capillary zone electrophoresis (CZE) to measure methotrexate, folinic acid and folic acid in human urine has been developed and validated. Optimum separation of methotrexate, folinic acid and folic acid was obtained on a 60 cm x 75 microm capillary using a 15 mM phosphate buffer solution (pH 12.0), temperature and voltage 20 degrees C and 25 kV, respectively and hydrodynamic injection. Under these conditions the analysis takes approximately 9.0 min. Good results were obtained for different aspects including stability of the solutions, linearity, accuracy and precision. Before CZE determination, the urine samples were purified and enriched by means of a solid phase extraction step with a preconditioned C(18) cartridge and eluting the compound with a mixture 1:1 of methanol:water. A linear response over the urine concentration range 1.0-6.0 mgL(-1) for MTX and 0.5-6.0 mgL(-1) for folinic acid and folic acid was observed. Detection limits for the three compound in urine were 0.35 mgL(-1). CZE was shown to be a good method with regard to simplicity, satisfactory precision, and sensitivity.

Column-switching techniques in the biomedical analysis of stereoisomeric drugs: why, how and when.

The application of stereoselective chromatographic techniques to bioanalytical problems has become a routine procedure. However, this approach is not always straightforward; particularly when the separation involves chromatographic chiral stationary phases. Matrix interferences and more importantly, overlapping metabolite peaks often make direct analysis impractical. One strategy to overcome these problems is to combine two or more columns with different selectivities to produce a multi-dimensional chromatographic system. This review addresses the use of coupled column chromatography in HPLC systems including different coupling methods and the application of the resulting arrangements to bioanalytical analyses.

Capillary electrophoresis quantitation of l-L-folinic acid in the presence of its inactive d-L-form.

The diastereomers d-L and l-L-folinic acid were separated by capillary electrophoresis, using heptakis (2,3-di-O-methyl)-beta-cyclodextrin as a chiral active component in the background electrolyte. The method proved suitable for the quantitation of these compounds in one commercial pharmaceutical preparation.

HPLC analysis of optical isomers of leucovorin and methotrexate using achiral-chiral system.

Chiral high performance liquid chromatography was used for the enantiometric separation of leucovorin. The optimal separation conditions recommended after optimizing the mobile phase composition, flow rate, and temperature are described. Achiral reversed-phase chromatographic method was applied for the simultaneous separation of methotrexate and leucovorin in clinical samples. Column-switching system including achiral short pre-column and chiral analytical column based on immobilized bovine serum albumin were used for simultaneous determination of leucovorin and methotrexate patients treated at the National Cancer Institute.

A thin-layer chromatographic method to determine process impurities in leucovorin calcium.

A densitometric thin-layer chromatographic method for the analysis of process impurities in leucovorin calcium was developed and validated. Using this method, folic acid, N10-formyldihydrofolic acid, p-aminobenzoic acid, and N-(4-aminobenzoyl)-L-glutamic acid were monitored with a limit of detection of approximately 0.1% each. Both absorbance and fluorescence densitometric evaluations were utilized; fluorescence evaluation selectively detected impurities that were not chromatographically resolved from leucovorin.

Chiral separation of leucovorin with bovine serum albumin using affinity capillary electrophoresis.

A method for the determination of the (6R)- and (6S)-stereoisomers of leucovorin using electrokinetic chromatography (EKC) in the affinity mode has been developed. Bovine serum albumin (BSA) is used as a run buffer additive to incorporate enantiomeric selectivity into the system. Protein-wall interactions are minimized by using a poly(ethylene glycol) (PEG) coated capillary. Chiral resolution is obtained in 12.5 min with efficiencies greater than 200,000 theoretical plates using BSA as an additive, while no resolution is obtained in the absence of BSA. A general equation is derived to calculate the free energy of interaction between the leucovorin isomers and the BSA molecule. This method represents a new means of obtaining thermodynamic data for substrate binding interactions and for the general study of drug cross-reactions and interactions of drugs with serum and other proteins.