Zn[Formula: see text]Ni[Formula: see text]Te semiconductor nanocrystals in transparent glass for optoelectronic device applications.

Doping glass with semiconductors, particularly with nanostructured semiconductors, has attracted attention due to the large optical absorption cross-sections of the latter. Based on this property, Ni[Formula: see text] (5 wt%) doped phosphate glass and Zn[Formula: see text]Ni[Formula: see text]Te (x = 0.5, 1.0, 5.0 and 10.0 wt% of Ni[Formula: see text]) nanocrystals (NCs) doped phosphate glasses (GCs) were prepared by fusion method and subsequent heat treatment. Influence of Ni[Formula: see text] on structural, thermo-optical and third-order nonlinear optical properties have been analysed through various spectroscopic characterizations. The XRD pattern of the glass (G) exhibits the amorphous nature of the host material while GCs exhibit not only amorphous halo but also the presence of quantum dots (QDs) or nanocrystals (NCs) phases. TEM analysis of the studied GCs samples confirm the presence of quantum dots (QDs) and bulk NCs with an average diameter of approximately 4.2 [Formula: see text] 0.3 nm and 13.4 [Formula: see text] 0.2 nm, respectively. Several phosphate groups were observed and reported from Raman and FTIR-ATR spectra. The absorption band positions confirmed that Ni[Formula: see text] ions resemble to the octahedral symmetry. The intensity of absorption band around 1352 nm ([Formula: see text]T[Formula: see text](F) [Formula: see text] [Formula: see text]A[Formula: see text](F)) increased with the increase of Ni[Formula: see text] in GCs which is an indicative of the [Formula: see text]Ni[Formula: see text] coordination. The emission properties such as emission cross-sections ([Formula: see text]) full width at half maxima (FWHM) for the [Formula: see text]T[Formula: see text](D) [Formula: see text] [Formula: see text]T[Formula: see text](F) (visible) and [Formula: see text]A[Formula: see text](F) [Formula: see text] [Formula: see text]T[Formula: see text](F) (near-infrared) emission transitions were reported. Among the glass-containing semiconductor nanocrystals (GCs), the emission cross-sections in GC4 sample (x = 10% of Ni[Formula: see text]) are the largest for both the visible (11.88 [Formula: see text] 10[Formula: see text] cm[Formula: see text]) and infrared (0.98 [Formula: see text] 10[Formula: see text] cm[Formula: see text]) transitions. Thermal diffusivity (D), thermal conductivity (K) and temperature dependent optical path length change (ds/dT) were obtained through time-resolved thermal lens (TL) and thermal relaxation (TR) methods. The D and K parameters do not change significantly with increase of Ni[Formula: see text] ions (0.5-5%) in GCs. Nonlinear-refractive index and nonlinear absorption of the studied samples were also obtained using femtosecond Z-scan technique. The increase of nonlinear absorption coefficient ([Formula: see text]) is observed from GC2 (2.53 [Formula: see text] 10[Formula: see text] cm/W) to GC4 (7.98 [Formula: see text] 10[Formula: see text] cm/W). The GC4, sample with 10 wt% of Ni[Formula: see text], showed the lowest ds/dT (1.22 [Formula: see text] 10[Formula: see text] K[Formula: see text]) with good lasing (FOM and emission cross-sections) and nonlinear absorption properties suggesting that it can be a good candidate for visible-red emission light conversion in LED technology.

Identification of Listeria monocytogenes in cattle meat using biochemical methods and amplification of the hemolysin gene.

In Brazil and in other countries of the world, studies have been conducted to identify Listeria monocytogenes in cattle meat that is preferably consumed undercooked and, when marketed without meeting strict phytosanitary requirements, may cause outbreaks of listeriosis. In the such, foodborne outbreaks, the methods used for the detection of the pathogen and the efficiency associated with them are crucial for the proper assessment. In this study, we used the techniques biochemical and molecular for identification of the L. monocytogenes isolated from 30 samples of the fresh beef, marketed in ten butchers' shop of the free-fair from a municipality from the Bahia, Brazil. The results obtained from biochemical tests (catalase, motility, ß-hemolysis and carbohydrate fermentation), as well as PCR analysis for the hly gene (hemolysin production is an important factor in the pathogenesis of listeriosis) revealed that 50% of butchers shops presented bovine meat contaminated with bacteria of the Listeria sp. and confirmed that 54.16% of the analyzed meat samples were positive for L. monocytogenes. This study highlights the importance of microbiological surveillance in free-fair to minimize the exposure of consumers to this foodborne pathogen.

Effect of Co co-doping on the optical properties of ZnTe:Mn nanocrystals.

We study the effect of Co co-doping on the optical properties of Mn-doped ZnTe nanocrystals (NCs) embedded in a glass matrix. Optical absorption (OA) and crystal field theory strongly indicated the substitutional incorporation of Co2+ ions into these semiconducting NCs as well as the characteristic transitions of these ions in the visible and near infrared spectral region. Transmission electron microscopy (TEM) images revealed an invariant NC lattice parameter with the incorporation of Mn2+ and Co2+ ions. The same was confirmed by X-ray diffraction (XRD). The photoluminescence (PL) spectra showed that the characteristic emission bands of Co2+ ions (E1Co2+ and E2Co2+) are intense and evident at low temperatures. Indeed, Raman spectra showed that the dependence of luminescence intensity on temperature is due to the electron-phonon interaction that arises from multiphonon relaxation processes. The redshifts in the PL spectra from green to orange with the incorporation of Mn2+ ions into ZnTe NCs, and in the near infrared with increasing Co-concentration, result from sp-d exchange interactions associated with the increase in Mn2+ and Co2+ ions in tetrahedral sites of ZnTe NCs, which may be very interesting for applications in luminescent devices. These observations provide strong evidence that higher Co-concentrations inhibit the incorporation of Mn2+ into ZnTe NCs, suggesting that there may be competition between Co2+ and Mn2+ ions substituting Zn2+ ions and, furthermore, that these ions replace zinc vacancies (VZn) in these NCs.

Mn concentration-dependent tuning of Mn(2+) d emission of Zn1-xMnxTe nanocrystals grown in a glass system.

We studied the effect of Mn concentration on the optical, morphological and magnetic properties of Zn1-xMnxTe NCs grown in a glass matrix produced by the fusion method. The physical properties of these materials were determined by optical absorption (OA), transmission electron microscopy (TEM), atomic/magnetic force microscopy (AFM/MFM) and photoluminescence (PL). An analysis of the OA spectra, based on the crystal field theory (CFT), showed strong evidence that Mn(2+) ions were substitutionally incorporated into the Zn1-xMnxTe NCs until reaching the solubility limit (concentration, x = 0.100). Above this nominal concentration, TEM showed the onset of Mn-related phases, such as MnO and α-MnO2, in the PZABP glass system. AFM images showed that NC density on the surface of the glass matrix decreased as x-content increased. It is probable that MnO and MnO2 NCs would outnumber Zn1-xMnxTe NCs at higher concentrations - a conclusion that was corroborated by the OA spectra and TEM images. MFM images revealed that samples with Mn(2+) ions responded to magnetization from an MFM probe. This implied that Mn(2+) ions were incorporated within the Zn1-xMnxTe NCs and gave rise to the diluted magnetic semiconductor (DMS) structure. The PL spectra not only confirmed the evidence obtained by OA, CFT, TEM and AFM/MFM, but also showed that Mn(2+) concentration could be used to tune (4)T1((4)G) → (6)A1((6)S) emission energy.

Thermal activated energy transfer between luminescent states of Mn2+-doped ZnTe nanoparticles embedded in a glass matrix.

Zn(1-x)Mn(x)Te nanocrystals (NCs), at various concentrations x, were successfully grown in a host glass matrix by the fusion method after appropriate annealing. Growth of these NCs was evidenced by optical absorption (OA), X-Ray Diffraction (XRD), magnetic force microscopy (MFM) and photoluminescence (PL) measurements. From the room temperature OA spectra, it was possible to observe the formation of two well defined, different sized groups of NCs, one attributed to quantum dots (QDs) and the other to bulk-like nanocrystals (NCs). XRD results have confirmed that the cubic zincblend structure of nanoparticles is not altered by the substitutional incorporation of Mn(2+) ions into the ZnTe NCs. MFM images supported the OA spectra results and thus provided additional confirmation of the formation of Zn(1-x)Mn(x)Te magnetic nanoparticles in the host glass matrix. The two groups of NCs were also observed in the PL spectra as well as deep defects attributed to the presence of oxygen centers in the electronic structure of the Zn(1-x)Mn(x)Te NCs. Strong agreement between the fitting model, based on rate equation, and experimental PL intensity data at different temperatures demonstrates that this model adequately describes the energy transfer processes between the NCs and the defects of the Zn(1-x)Mn(x)Te system at different temperatures.

Chondrocutaneous auricular graft for reconstruction of ocular socket in anophthalmic cavities.

In addition to the emotional suffering after the removal of an eye, various problems can occur so that reconstruction of an anophthalmic cavity becomes difficult. The objective of reconstruction is to increase the depth of the conjunctival fornix to secure and support a prosthesis. Nine patients operated on during 2008 and 2009 in the Craniofacial Division of the Hospital Beneficência Portuguesa in São Paulo were evaluated retrospectively with the operative technique described in this article. The application of the technique described for reconstruction of the eyelid fornix achieved a high success rate regarding the ability to use an ocular prosthesis and a high rate of patient satisfaction in this small study sample.

Matriz óssea homóloga desmineralizada na união vertebral dorsolateral lombar em coelhos / Demineralized homologous bone matrix for lumbar dorsolateral spinal union in rabbits

Foi avaliada a atuação da matriz óssea homóloga desmineralizada (MOD) na união dorsolaterallombar, aplicada bilateralmente sobre os processos transversos de L5-L6, após sua descorticação, em 24 coelhos (grupo 1). Outros nove coelhos (grupo 2) foram submetidos apenas à descorticação dos processos transversos. Oito animais do grupo 1 e três do grupo 2 foram sacrificados às cinco, sete e nove semanas após a cirurgia e submetidos a avaliações radiográfica, histológica e por palpação. Os animais do grupo 1 tiveram a área de enxertia submetida a testes bio-mecânicos. No grupo 1, às cinco semanas, 37,5 por cento dos animais apresentaram união à palpação, que estava presente em 50por cento nas semanas seguintes. As análises radiográficas demonstraram índice de união de 25 por cento às cinco semanas, seguido por um índice de 100 por cento de pseudartrose às sete semanas e 33,4 por cento de união às nove semanas. A avaliação histológica demonstrou, predominantemente, a fragmentação seguida pela reabsorção da MOD, que foi substituída em quase sua totalidade por tecido conjuntivo fibroso. Quando houve união vertebral, a formação óssea endocondral se deu a partir dos processos transversos descoticados. No grupo 2, na avaliação radiográfica foi observada pequena reação periosteal local, não apresentando qualquer sinal de união nas demais análises. As evidências histológicas demonstraram que a MOD comportou-se como agente osteocondutor. O teste de tração demonstrou diferença significativa, referente à força e rigidez, entre os seg- mentos operados e os adjacentes. Evidências radiográficas, mecânicas e histológicas demonstraram que a matriz óssea homóloga desmineralizada de coelhos é ineficaz, quando utilizada isoladamente, na determinação de união vertebral dorsolaterallombar estável em coelhos

Autoenxerto de crista ilíaca de coelhos na união vertebral dorsolateral lombar / Iliac crest autograft in rabbit dorsolateral spinal fusion

Foi realizada artrodese dorsolateral das vértebras lombares L5-L6 de coelhos, avaliando-se a eficácia do autoenxerto da crista ilíaca na promoção de união vertebral. Foram utilizados 33 coelhos da raça Nova Zelândia Branco, distribuídos em dois grupos, com nove indivíduos no grupo 1 (G1), submetidos a descorticação bilateral dos processos transversos; e vinte e quatro indivíduos no grupo 2 (G2), que receberam 2g de autoenxerto da crista ilíaca sobre a área de descorticação. Três coelhos do G1 e oito do G2 foram submetidos à eutanásia as cinco, sete e nove semanas após o ato operatório e à avaliações por palpação, radiográfica e histológica no local do procedimento. Testes biomecânicos para avaliação de força e rigidez da união foram realizados somente nos animais do G2 e as vértebras adjacentes não operadas, serviram de controle. Os animais do G1 apresentaram mobilidade normal à palpação do segmento operado em todos os momentos de avaliação e não apresentaram evidência radiográfica de união. Na avaliação histológica foi observada discreta reação periosteal, sem evidências de formação de ponte óssea. No G2, as avaliações por palpação e radiográficas evidenciaram indícios de união óssea as cinco semanas, intensificando-se ao longo das semanas de avaliação. Na análise histológica foi observada reabsorção de fragmentos ósseos as cinco semanas, predominância de trabéculas ósseas e corações condróides, além de suprimento sanguíneo abundante as sete semanas e osteointegração em todo leito de enxertia as nove semanas, com predomínio de formação óssea endocondral. Os testes biomecânicos evidenciaram aumento da força e rigidez da massa óssea ao longo do tempo de avaliação. Quando foi realizada comparação das vértebras tratadas e não tratadas, os índices de união foram maiores em todos os momentos, no grupo tratado. Com os resultados foi possível concluir que alta percentagem de união vertebral foi conseguida quando o osso autógeno da crista ilíaca foi utilizado como material de enxertia em coelhos.