Removal of Aflatoxin B1 Using Alfalfa Leaves as an Adsorbent Material: A Comparison between Two In Vitro Experimental Models.

An adsorbent material derived from alfalfa leaves was prepared and further characterized, and its efficacy for removing aflatoxin B1 (AFB1) was investigated. Characterization consisted of the use of attenuated total reflectance-Fourier transform infrared spectroscopy (ATR-FTIR), environmental scanning electron microscopy (ESEM), X-ray fluorescence spectroscopy (XRF), X-ray diffraction (XRD), point of zero charge (pHpzc), zeta potential (ζ-potential), UV-Vis diffuse reflectance spectroscopy, and spectral analysis. To determine the adsorption capacity against AFB1 (250 ng AFB1/mL), pH-dependent and avian intestinal in vitro models were used. The adsorbent inclusion percentage was 0.5% (w/w). In general, the pH-dependent model gave adsorption percentages of 98.2%, 99.9%, and 98.2%, evaluated at pH values of 2, 5, and 7, respectively. However, when the avian intestinal model was used, it was observed that the adsorption percentage of AFB1 significantly decreased (88.8%). Based on the characterization results, it is proposed that electrostatic, non-electrostatic, and the formation of chlorophyll-AFB1 complexes were the main mechanisms for AFB1 adsorption. From these results, it can be concluded that the adsorbent derived from alfalfa leaves could be used as an effective material for removing AFB1 in in vitro digestion models that mimic the physiological reality.

Agave inulin as a fat replacer in tamales: Physicochemical, nutritional, and sensory attributes.

Tamales are a traditional dish rich in fat and carbohydrates with increasing popularity. The present study aimed to investigate the use of agave inulin powder (AIP) as a potential fat replacer in tamales. The effect of replacing 0%, 33%, 66%, and 100% (w/w) of fat with AIP was evaluated in the physicochemical, sensory, and nutritional features of tamales. The fat content of tamales decreased up to 88% in AIP tamales, whereas total dietary fiber (TDF) increased up to 14%. TDF in AIP tamales had a higher proportion of soluble dietary fiber (SDF). Moreover, results indicated that both insoluble and SDF were formed during the processing of tamales. Fat replacement led to a reduction of up to 26% in the calorie load of tamales. Fourier transform infrared spectroscopy analysis confirmed changes in the absorption bands related to carbohydrates, with increments in peaks associated with inulin (936 and 862 cm-1 ), and inhibition of retrogradation when inulin was included. AIP addition resulted in tamales with lighter color. Fat replacement with AIP affected the texture of tamales increasing their softness, adhesiveness, and cohesiveness. In general, inulin positively affected the hedonic attributes and acceptance of tamales. Interestingly, full-fat tamales had a lower glycemic index and presented higher contents of resistant starch compared to tamales with AIP. Nevertheless, agave inulin may serve as a fat replacer yielding reduced-fat tamales with higher TDF and SDF and yielding a lower calorie load without significantly affecting the sensory acceptability of this traditional meal.

Sustainable Process for Tortilla Production Using Ohmic Heating with Minimal Impact on the Nutritional Value, Protein, and Calcium Performance.

The nixtamalization process used for tortilla production entails extended processing time and generates pollutant effluents. Ohmic heating (OH) is an emerging technology that uses an alternating electric current for rapid and uniform food heating and mitigates effluent concerns. However, gaps exist in nutrient bioavailability studies. In this work, we assessed OH's impact on tortilla nutritional value, protein, and calcium using a rat model. Twenty-five male Wistar rats were fed one of four diets for 21 days: raw corn (RC) as an experimental control, OH-processed tortillas (OHTs), traditionally processed tortillas (TPTs), commercial tortillas (CTs), and a casein diet (CD) as a growth control. Despite similar protein and macronutrient profiles, OH significantly enhanced insoluble fiber content. The weight gain sequence was OHTs > TPTs > CTs > RC. OHTs exhibited superior protein digestibility (88.52%), which was 3% higher than other diets. The serum albumin (2.63-2.73 g/dL) indicated moderate malnutrition due to the tortilla's lower protein content. Nonetheless, the protein efficiency ratio (1.2-1.74) showed no significant difference from TPTs. Bone characteristics and fracture strength resembled the tortilla-fed groups, surpassing RC. X-ray diffraction and scanning electron microscopy confirmed that the OHT and TPT diets improved male rat bone thickness and crystallinity. The findings suggest the potential for OH as an eco-friendly tortilla production method, maintaining nutritional value comparable to traditional methods.

Humic Acids Preparation, Characterization, and Their Potential Adsorption Capacity for Aflatoxin B1 in an In Vitro Poultry Digestive Model.

Vermicompost was used for humic acid (HA) preparation, and the adsorption of aflatoxin B1 (AFB1) was investigated. Two forms of HA were evaluated, natural HA and sodium-free HA (SFHA). As a reference, a non-commercial zeolitic material was employed. The adsorbents were characterized by attenuated total reflectance-Fourier transform infrared spectroscopy (ATR-FTIR), energy-dispersive X-ray spectroscopy (EDS), zeta potential (ζ-potential), scanning electron microscopy (SEM), and point of zero charge (pHpzc). The adsorbent capacity of the materials when added to an AFB1-contaminated diet (100 µg AFB1/kg) was evaluated using an in vitro model that simulates the digestive tract of chickens. Characterization results revealed the primary functional groups in HA and SFHA were carboxyl and phenol. Furthermore, adsorbents have a highly negative ζ-potential at the three simulated pH values. Therefore, it appears the main influencing factors for AFB1 adsorption are electrostatic interactions and hydrogen bonding. Moreover, the bioavailability of AFB1 in the intestinal section was dramatically decreased when sorbents were added to the diet (0.2%, w/w). The highest AFB1 adsorption percentages using HA and SFHA were 97.6% and 99.7%, respectively. The zeolitic material had a considerable adsorption (81.5%). From these results, it can be concluded that HA and SFHA from vermicompost could be used as potential adsorbents to remove AFB1 from contaminated feeds.

Multivariate Analysis on the Properties of Intact Cereal Kernels and Their Association with Viscoelasticity at Different Moisture Contents.

The viscoelastic properties of cereal kernels are strongly related to their quality, which can be applied to the development of a more selective and objective classification process. In this study, the association between the biophysical and viscoelastic properties of wheat, rye, and triticale kernels was investigated at different moisture contents (12% and 16%). A uniaxial compression test was performed under a small strain (5%), and the increase in viscoelasticity at 16% moisture content corresponded to proportional increases in biophysical properties such as the appearance and geometry. The biophysical and viscoelastic behaviors of triticale were between those of wheat and rye. A multivariate analysis showed that the appearance and geometric properties significantly influenced kernel features. The maximum force showed strong correlations with all viscoelastic properties, and it can be used to distinguish between cereal types and moisture contents. A principal component analysis was performed to discriminate the effect of the moisture content on different types of cereals and to evaluate the biophysical and viscoelastic properties. The uniaxial compression test under a small strain and the multivariate analysis can be considered a simple and non-destructive tool for assessing the quality of intact cereal kernels.

Effects of germination and lactic acid fermentation on nutritional and rheological properties of sorghum: A graphical review.

Sorghum (Sorghum bicolor) is a nutritional grain considered an important source of micro- and macro-nutrients. Also, the flour obtained from sorghum is considered a suitable substitute for wheat flour for celiac disease patients due it is gluten-free. However, its use has some limitations due to anti-nutritional factors such as tannins, phytates, trypsin inhibitors, and protein crosslinkers. To prevent those effects, new strategies for sorghum processing have been explored. Germination of this grain has been shown to increase nutrient content further and reduce anti-nutrients. In addition, fermentation with lactic acid bacteria could modify starch and protein digestion in sorghum flour and increase their nutrient availability. Although there are many benefits to germination and fermentation, more research must be done to improve the products' texture and sensory properties to gain wider consumer acceptance. In this review, the mechanism behind changes in the nutritional and anti-nutritional profile of sorghum grain due to germination and fermentation treatments is shown, and the impact of these changes on dough rheological properties and bread quality.

Evaluation of microwave heating on the mechanical properties, ß-glucan, and fiber content of barley kernels.

BACKGROUND: Microwave heating may affect some non-starch polysaccharides of cereal kernels. This microwave effect can be positive for functional properties and the final product. Therefore, the purpose of this work was to explore the effects of microwave heating on mechanical properties, malt extract yield, wort viscosity, β-glucan of wort, and soluble, insoluble, and total dietary fiber in malting and feed barley. METHODS: The barley kernels were microwave heated for 4 and 8 s and compared with a control (0 s) with no microwave irradiation treatment. The mechanical properties were measured by compressive loadings; an Environmental Scanning Electron Microscopy was used for kernel layers. β-glucan content in the barley kernel and wort was measured with a Mixed Linkage beta-glucan (K-BGLU Megazyme International; Wicklow, Ireland). Insoluble, soluble, and total dietary fiber was determined using 32-07 of AACC method. RESULTS: The thickness of barley kernel bran layers was related to the mechanical properties. The modulus of elasticity decreased after 4 s of heating but increased after 8 s. Irradiation affected non-starch polysaccharides, such as β-glucan and fiber. β-glucan decreased after 4 s as did wort viscosity. The insoluble and total dietary fiber followed the same trend as β-glucan, but the soluble fiber content increased with prolonged microwave heating. CONCLUSIONS: A few seconds of microwave heating is enough to increase barley’s value in the brewing industry and improve health benefits due to minor changes in the biochemical grain components.

Exploiting the Native Microorganisms from Different Food Matrices to Formulate Starter Cultures for Sourdough Bread Production.

The use of sourdough for bread production involves fermentation, which is dominated by lactic acid bacteria (LAB) and yeast. Sourdough can be inoculated with a starter culture or through a food matrix containing microorganisms to initiate sourdough fermentation. Sourdough is used as leavening agent for bread making, and metabolites produced by LAB and yeast confer a specific aroma and flavor profile to bread, thus improving its sensory attributes. However, few publications report the effect of microorganisms from different food products and by-products on sourdough fermentation. This review focuses on using different starter cultures from various food sources, from wheat flour to starter cultures. Additionally, included are the types of sourdough, the sourdough fermentation process, and the biochemical transformations that take place during the sourdough fermentation process.

Synthesis and Characterization of Chitosan Particles Loaded with Antioxidants Extracted from Chia (Salvia hispanica L.) Seeds.

Chia (Salvia hispanica L.) seeds contain antioxidants with great benefits for health and are widely used in the food industry. Antioxidants can be degraded by environmental factors, decreasing their biological activity. Their encapsulation in chitosan (CH) particles represents an alternative to protect them and increases their application. The encapsulation efficiency (%EE) of the antioxidants in the CH particles depends on the synthesis conditions. In this study, two methods for encapsulation of chia extract in chitosan particles were evaluated: method A, 0.05% CH in 1% acetic acid was mixed with 0.07% of tripolyphosphate (TPP) and method B, 0.3% CH in 2% acetic acid was mixed with 1% TPP. The results showed that the %EE decreased with the concentration of the extract, and the FTIR analysis suggested that the compounds of the extract were adsorbed on the surface of the particles. Dynamic light scattering and zeta potential analysis showed that the particles of method A are unstable and with a tendency to agglomerate, and the particles of method B are stable. The highest %EE was obtained with 0.2 mg·mL-1 (method A) and 1.0 mg·mL-1 (method B) of the extract. The higher loading capacity (%LC) (16-72%) was exhibited by the particles of method A. The best particle yield (62-69%) was observed for method B. The particles with the extract adsorbed showed antioxidant activity (5-60%) at 25°C; however, in the particles with the extract encapsulated, the activity increased after subjecting to acidic conditions at 40°C due to the breakdown of the particles. The results obtained will allow choosing the appropriate conditions for the synthesis of chitosan particles loaded with chia extracts with specific characteristics (%EE, %LC, size, and type) according to their future applications. The particles could be used in food and pharmaceutical industries and even in edible films for food packaging.

Thermosonication as an alternative method for processing, extending the shelf life, and conserving the quality of pulque: A non-dairy Mexican fermented beverage.

The aim of this study was to evaluate thermosonication as an alternative method for the pasteurization of pulque in order to improve its shelf life and retain its quality parameters. Thermosonication was carried out at 50 °C using amplitudes of 75% (for 6 and for 9 min), 85% (for 4 and for 6 min), and 95% (for 3 and for 5 min). These were the optimal conditions found for processing pulque by thermosonication. Physicochemical (acidity, color, alcohol content, and sensory analysis) and microbiological (lactic acid bacteria and yeasts) parameters were determined during 30 days for storage at 4 ± 1 °C. Conventional pasteurization (63 °C, 30 min) and raw pulque were used as controls. According to the results, the shelf life of pulque was extended up to 24 days storage at 4 °C. After this time, the quality of beverage decreased, due that the microbial load increases. Thermosonication treatments at 75% and 85% showed a higher content of LAB (6.58-6.77 log CFU/mL) and yeasts (7.08-7.27 log CFU/mL) than conventional pasteurization (3.64 log CFU/mL of LAB and 3.97 log CFU/mL of yeasts) at 24 days of storage. Raw pulque demonstrated up to 7.77 log CFU/mL of yeasts and 7.51 log CFU/mL of LAB. Pulque processed by thermosonication exhibited greater lightness, sensory acceptance, a maximal acidity of 0.83 g/lactic acid, and an alcohol content of 4.48-4.95% v/v. The thermosonication process preserves sensory and physicochemical properties better than conventional pasteurization. Lactic acid bacteria such as Lactobacillus kefiri, Lactobacillus acidophilus, and Lactobacillus hilgardii and yeasts such as Saccharomyces cereviasiae were identified in thermosonicated pulque.