Dynamic ultrasound-assisted extraction of environmental pollutants from marine sediments for comprehensive two-dimensional gas chromatography with time-of-flight mass spectrometric detection.

A dynamic ultrasound-assisted extraction (UAE) of marine sediments has been optimized using experimental design methodology. Comprehensive two-dimensional gas chromatography (GC x GC) using a cryogenic modulator, and time-of-flight-mass spectrometry (TOF-MS) were used to separate and identify environmental pollutants. Six compounds from three different chemical classes were used to optimize the extraction parameters.

Simple, non-moving modulation interface for comprehensive two-dimensional gas chromatography.

A simple, non-moving dual-stage CO2 jet modulator is described, which cools two short sections of the front end of the second-dimension column of a comprehensive two-dimensional gas chromatograph. A stream of expanding CO2 is sprayed directly onto this capillary column to trap small fractions eluting from the first-dimension column. Remobilization of the trapped analytes is performed by direct heating by the GC oven air. Installation, maintenance and control of the modulator is simple. Focusing and remobilization of the fractions is a very efficient process, as the bandwidths of the re-injected pulses are less than 10 ms. As a result, alkane peaks eluting from the second-dimension column have peakwidths at the baseline of only 120 ms.

Miniaturized automated matrix solid-phase dispersion extraction of pesticides in fruit followed by gas chromatographic-mass spectrometric analysis.

In this study a simple and fast miniaturized automated matrix solid-phase dispersion method for the sample preparation and quantitative extraction of pesticides was developed and evaluated. Only 25 mg of sample and 100 microl of organic solvent were used per analysis for this new miniaturized set-up. The extracts were subsequently analysed by GC-MS without any further purification. The method was optimized for oranges and tested for the determination of a variety of organophosphorus pesticides and a pyrethroid at concentration levels below the maximum residue levels set by the European Union and authorities in The Netherlands. The limits of detection were 4-90 microg/kg. The recoveries for pesticides in orange were 83-118% and the relative standard deviations for the total procedure were 10-13% (n=4) at the limit of quantification. The feasibility of the developed method for apple, pear and grapes was also studied. Equally good results were obtained, but for apple the washing step should be omitted.

Determination of chlorophenoxy acid herbicides in water by in situ esterification followed by in-vial liquid-liquid extraction combined with large-volume on-column injection and gas chromatography-mass spectrometry.

A new approach for rapidly analysing chlorophenoxy acid herbicides in water is presented. The chlorinated acids are derivatised with dimethyl sulphate in the water sample itself (800 microl) and, next, the methyl esters are extracted with 800 microl of n-hexane. A 200-microl volume of the extract is injected into the GC-MS system. The miniaturisation of both the methylation and extraction steps could be implemented because of the use of large-volume on-column injection and mass spectrometric detection. The optimisation of the methylation reaction for the simultaneous determination of (3,6-dichloro-2-methoxy)benzoic acid, (2-methyl-4-chlorophenoxy)- and (2,4-dichlorophenoxy)acetic acids, (+/-)-2-(4-chloro-2-methylphenoxy)- and 2-(2,4-dichlorophenoxy)propanoic acids and 4-(4-chloro-2-methylphenoxy)- and 4-(2,4-dichlorophenoxy)butyric acids showed that tetrabutylammonium salts act as catalysts. Addition of sodium hydroxide was required to obtain quantitative reaction yields for 4-(4-chloro-2-methylphenoxy)- and 4-(2,4-dichlorophenoxy)butyric acids. The methylation-cum-extraction procedure takes only 3 min per sample for a batch of seven samples. Linear calibration plots were obtained for the complete procedure and the limits of detection were of 10-60 ng/l with a signal-to-noise ratio (S/N) of 6. Relative standard deviations ranged from 8 to 15% (n=7) for analyte concentrations of 0.5 microg/l in surface water.

Trace-level determination of polar flavour compounds in butter by solid-phase extraction and gas chromatography-mass spectrometry.

Volatile compounds are responsible for the aromas of butter. A simple technique for the determination of these components is described which is based on solid-phase extraction (SPE) after melting of the butter and separation of the aqueous phase from the fat. Volatile flavours present in the water fraction are collected by off-line SPE on cartidges packed with a copolymer sorbent. After desorption with 500 microliters of methyl acetate, 1-microliter aliquots are quantified and/or identified by gas chromatography-mass spectrometry. The procedure was tested with respect to recovery, linearity and limit of detection in real-life samples using five polar model analytes. It allows the characterisation of polar flavour compounds in butter prior to and after heat treatment at 170 degrees C. From the five model compounds, vanillin, traces of diacetyl and maltol were found to be present in the butter samples. After heat treatment 500-1000-fold increased concentration of maltol, and substantial amounts of furaneol were detected.

On-line coupling of immunoaffinity-based solid-phase extraction and gas chromatography for the determination of s-triazines in aqueous samples.

The potential of immunoaffinity-based solid-phase extraction (IASPE) coupled on-line to gas chromatography (GC) for the determination of micropollutants was studied with emphasis on the interfacing of the immunoaffinity-based SPE and GC parts of the system. The cartridge containing the immobilized antibodies was coupled to the gas chromatograph via a reversed-phase cartridge (copolymer sorbent). After trace enrichment of the analytes on the immunoaffinity cartridge, they were desorbed and recollected on the reversed-phase cartridge by means of an acidic buffer. After clean-up and drying with nitrogen, desorption and transfer to the GC was done with ethyl acetate via an on-column interface in the partially concurrent solvent evaporation mode. The antibodies used in the immunoaffinity cartridge were raised against atrazine; several s-triazines were used as test compounds. Triazines that were structurally similar to atrazine, showed quantitative recovery. As an application, immunoaffinity SPE-GC was used for the analysis of river and waste water and orange juice. The selectivity of the system was such that non-selective flame ionization detection (FID) could be used to detect the analytes of interest in these complex matrices. The detection limits for 10-ml water samples were 15-25 ng/l for FID and about 1.5 ng/l for the nitrogen-phosphorus detection.